AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected in series. If the circuit is supplied by 12.9 V rms, 60 Hz voltage source, calculate dissipated power in "W" through the resistor 18.7 Q

AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected in series. If the circuit is supplied by 12.9 V rms, 60 Hz voltage source, calculate dissipated power in "W" through the resistor 18.7 Q

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: What is the difference between a conductor and a sem Which element is used to construct most…

A: In this question we will write about conductor and semicondutor.... Note :- as per our guidelines, I…

Q: Fig. P18.5. Figure P18.5 l, 10 Ω V₁ 15 Ω ΜΕ Ω 5Ω w ww 200 Με

A: Given, To find the Y-parameter

Q: For the circuit shown below, the switch has been in position A for a ong ume and is moved to…

Q: A 5 hp motor (mechanical power), wye connected with a 208V line: a. What is the apparent power…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 4. A Normally-Open Pushbutton is used in the Micro850 PLC control system to control Lamp 1 and Lamp…

A: PLC- Programmable Logic Control. It is technique or a method which is used to automate the…

Q: Describe what the terms Gain Bandwidth Product (GBP) and Slew Rate mean in the context of an…

A: In this question we will define gain bandwidth product and slew rate of opamp....

Q: t=0 FR E ZL= ∞0 1=1m I need to convert the drawing from a handwritten drawing to a typeface on the…

A: Given circuit,

Q: Ultra-Sound is widely used in instrument. It can be used to measure flowrate and level. Please…

Q: A shunt motor delivers 450 A at 230 V and the resistance of the shunt field and armature are 50 Ω…

Q: 7.28 For a current distribution in free space, (2x°y + yz)a, + (xy – xz')a, - (6xyz - 2x²y)a. Wb/m A…

A: The solution is given below

Q: A 500V, single-phase SM gives a net output mechanical power of 7.46 kW and operates at 0.9 pf lag.…

Q: Assume Vth = 1V and k = 50mA/V2. Given the schematic below, do the following: 1) Indicate and…

A: 1)

Q: 1. From the obtained data, sketch the transfer characteristics of the JFET. 2. Determine the values…

A: Given question is related to analog electronics

Q: 21. In a closed-loop control system, desired input value r in Volt must be generated by the function…

A: In a closed loop control system , the desirable output can be fetched by connecting a feedback path…

Q: O 2MF Ci S AMF 24v 2μF 1. TOTAL CAPACITANCE = 2. TOTAL CHARGE = 3. TOTAL VOLTAGE 4. TOTAL ENERGY =…

Q: Using Superposition Theorem, determine the current I for each network. R WWW XL 40 Xc² 30 R≤10 000 +…

Q: I need to convert the drawing from a handwritten drawing to a typeface on a computer or computer in…

A: Given, The circuit is

Q: Write the logic expression for each of the circuits in Fig. 3-33.

A: The logic expression for the given digital circuits can be obtained by taking the product of…

Q: Complete the missing information from the table below for the Delta-Delta connection transfer shown…

A: there are 3 more connections possible delta-star star-star star-delta all the calculations for the…

Q: 3. The 6-V zener diode in Fig. 7-12 has a maximum rated power dissipated of 690 mW. Its reverse…

A: In this question, We need to determine the value of source resistance Rs We know current I= V/R

Q: Note: Show your solutions, no solutions means wrong answers VCC Vin = 5v Ov Find Icsat,Ibsat, Vrc,…

A: According to the question, for the given circuit shown below We need to find IC,sat ; IB, sat ; VRc…

Q: VIO VDD 下 QP 19.75 pF ΟΝ E Vo 5 pF Capacitors to gind.

A: Since you have asked multiple questions, we will solve the first question for you as per Bartleby's…

Q: A 10hp, 230V, 1200 rpm DC series motor has the total armature circuit resistance Ra + Rf = 1.1Ω. The…

Q: Homework 2// If x(t) = 5(1+0.5 cos(4π10³)) cos3n106, determine (a) Type of modulation. (b)…

A: In this question, We need to determine the type of modulation, modulation index, carrier amplitude…

Q: Q1): Find the T.F of DE (h[n]) Y[n]=2X[n] -Y[n-1] +X[n-1] -Y[n-1] + 6Y[n-2]+4Y[n-2]-2Y[n-2] +X[n-1]

Q: O 0.02 S/cm

Q: What is the main difference between modern and classical induction motors?

A: Induction motor- An AC operated is electrical motor is known as Induction motor. In these type of…

Q: . The cones θ = 21◦ and θ = 159◦ are conducting surfaces and carry total currents of 40 A, as shown…

A: Applying the ampere's circuital law for the symmetrical shape. H will be in the direction aφ and…

Q: + 1=06 125 nF Ε και 4 ΚΩ ww 0.5 Η

Q: Voltage across capacitor is ve. With ve and it as a set of state variables derive the state model.

Q: Using Superposition Theorem, determine the current IL for each network. www XL 4Ω Xc₁ voo I 3Ω 6Ω E…

Q: j 1k 10 k a 100 Vp j 800 40 k

Q: ystems. 2. For a system,the input signal is r(t)-1-e* and the output is c(t)-1-e2 the transfer…

Q: Problems: 1. Use open collector inverters to implement the following logic expressions: (a) X = ABC…

A: The given logic expression can be obtained by using the inverter based on the expression.

Q: Q2. For the following filter circuit in Figure 2: find the transfer function H(s) and draw the…

Q: Determine the following: - Voltage across R₁ Current through R₁ Current through R₂ - Voltage across…

Q: I need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given handwritten circuit,

Q: 22. A commercial strain gauge has Gauge Factor GF=2 and initial resistance Ro = 120Ω. If the strain…

Q: 1. In the midrange of an amplifier's bandwidth, the peak voltage is 10V. What would be its value at…

Q: A 4 pole 3 phase induction when operating from a phase voltage of 2G50 V and 50 Hz supply freque per…

Q: 15. The output function Vout= A(V₂ - V₁) of a differential op-amp circuit is used in si…

A: The differential amplifier are nothing but the specific arrangement of operational amplifier in…

Q: Consider the following circuit below, assume V = 1.2 V and k = 0.5 mA/V². DS a. Determine I (in mA),…

A: The MOSFET circuit is given as Threshold voltageVth=1.2VTransconductance parameterk=0.5mAV2

Q: The one-line diagram of a 3-bus system is shown. The regulating transformer RT with a ratio…

A: Bus admittance matrix: It is a matrix formed by the admittances. These admittances are of nodal…

Q: 27. A closed-loop control system requires the sensing unit (i.e. sensor) to send the system. (a) no…

A: In this answer we will find the correct option to which a closed-loop control system requires the…

Q: how do you make p-doped semiconductors? What does the p stand for?

Q: Find the numerical value of the volume charge density at the point specified: D = rsinθcosΦ aθ C/m2…

Q: X D8.2. The field B-2a, +3a, +4a, mT is present in free space. Find the vector force exerted on a…

Q: An amplifier has a voltage gain of 20, an input resistance of 500 (and an output voltage of 50). The…

Q: I need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given handwritten circuit,

Q: difference between capacitor and resistor

Question

AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected in
series. If the circuit is supplied by 12.9 V rms, 60 Hz voltage source, calculate dissipated power in "W"
through the resistor 18.7 Q

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?
2, In a circuit, the capacitance of a capacitor is 3.2 microfarads and the rms voltage of the generator is 50 volts. Frequency (a) 100 Hz and (b) what is the rms current in the circuit when it is 1000 Hz?
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 13099 B) 14999 O C) 15099 O D) None
Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in current in the other coil. O True O False O Hard to say
The voltage applied to the metal grid of CRO is negative with respect to cathode. Select one: O True O False The sinusoidal current waveform having the maximum value of 30 A. then the R.M.S value is Three coils each having resistance of 29 0 are connected in star across 436 V. 50 Hz supply. Then the total power consumed is O 19665.10 W O 3784.66 W O 755.20 W O 226.05 W
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS
An alternating current varying sinusoidally with a frequency of 50 Hz has anrms value of 20 A.a) Determine the instantaneous value at 0.0025 seconds.b) Determine the instantaneous value, 0.0125 seconds after passingthrough a positive maximum value.c) At what time, measured from a positive maximum value, will theinstantaneous current be 14.14 A?