A water has the following analysis (mg/L as ion or compound): Na+ 20 mg/L 40 mg/L K 30 mg/L 67 mg/L Ca²+ 15 mg/L 0 mg/L 20 mg/L 5 mg/L 2 mg/L 10 mg/L Mg2+ Sr²+ CI HCO3 2- CO3²- SO₂²- NO3 Atomic weight of Na = 23, K = 39.10, Ca = 40.08, Mg = 24.31, Sr= 87.62, Cl = 35.45, H = 1, C = 12, 0 = 16, S = 32.07, and N = 14) What is the total hardness in mg/L as CaCO3? What is the carbonate hardness in mg/L as CaCO3? A/ What is the noncarbonate hardness in mg/L as CaCO3? A

A water has the following analysis (mg/L as ion or compound): Na+ 20 mg/L 40 mg/L K 30 mg/L 67 mg/L Ca²+ 15 mg/L 0 mg/L 20 mg/L 5 mg/L 2 mg/L 10 mg/L Mg2+ Sr²+ CI HCO3 2- CO3²- SO₂²- NO3 Atomic weight of Na = 23, K = 39.10, Ca = 40.08, Mg = 24.31, Sr= 87.62, Cl = 35.45, H = 1, C = 12, 0 = 16, S = 32.07, and N = 14) What is the total hardness in mg/L as CaCO3? What is the carbonate hardness in mg/L as CaCO3? A/ What is the noncarbonate hardness in mg/L as CaCO3? A

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The pH scale was designed to make it convenient to express hydrogen ion concentrations that are small in aqueous solutions. The definiton of pH is in terms of base 10 logarithms. pH – log[H*] where H+ is the hydrogen ion concentration. a. If the hydrogen ion concentration in a solution is 2.51 × 10-4 mol/L, the pH is b. If the pH of a solution is 3.433, the hydrogen ion concentration is mol/L.
2. A compound used in automobile antifreeze, is 38.7 % C, 9.7% H, and 51.6 % O by mass. Its molar mass is 62.1 g/mol. (a) What is the empirical formula of this compound? (b) What is its molecular formula? (.
(b) Demonstrate that the following equation is dimensionally homogenous. [10 %] Ixc Yp = ye+ Ayc fluid mechanics
What is the Henry’s law constant in dimensionless form and atmospheres for a compound that has a Henry’s law constant of 2.0 atm/ (mol/L)? What is the dimensionless Henry’s law constant for a compound that has a value of 200 atm? Assume the temperature is 10? C.
Convert the following from mg/L as the ion or compound to mg/L as CaCO3: 90 mg/L Ca2+ 00 mg/L HCO3- 0 mg/L MgO 40 mg/L CO2
To prepare 7% glycerin solution by weight. The solution was found to have a density of 1.0149 g/cm³ at 20 °C. Glycerin has a molecular weigh of 92.0473 g/mol and density of 1.2609 g/cm³ at 20 °C. What is the weight (in g) of the solute? What is the moles of solute? What is the weight (in kg) of solvent? What is the molality of the solution?What is the molarity of the solution?
The following mineral analysis was reported for a water sample taken from a municipal groundwater water well. Determine the total, carbonate and non carbonate hardness in mg/L as CaCO3 using the predominant polyvalent cation definition of hardness. All reported as "mg/L as the ion" Iron 0.2 Manganese 0.6 Ammonium 0.5 Sodium 4.7 Potassium 0.9 Calcium 67.2 Magnesium 39 Barium 0.5 Silica 20 Flouride 0.35 Boron 0.1 Nitrate 0 Chloride 4.5 Sulfate 29 Alkalinity 284 as CaCo3 pH 7.6 units
Body ( A ) as shown in Figure below has weight equal to ( 175N ) and the homogenous bar ( E ) has weight equal ( SON ) Draw a free body diagrain of each two bodies
Asap
A water sample contains the following dissolved ions: [Na+] = 75 mg/l [HCO]=250 mg/1 [CH] = 100 mg/l [Ca²+] = 45 mg/l [Mg²+] = 48 mg/1 [A1³+] = 5 mg/1 Atomic weight: H = 1; C = 12; O=16; Na = 23, Ca = 40, Mg = 24; Al = 27; CI = 35.5 The total hardness of the sample in mg// as CaCO3 is
If the Ksp of Sn(OH)2 (s) is 5.33 x 10-27, what is the solubility of it in the unit of mg/L?
The following information is given for n-pentane at 1 atm:boiling point = 36.20°C ΔHvap (36.20°C) = 357.6 J/g melting point = − 129.7°C ΔHfus (−129.7°C) = 116.7 J/g specific heat gas = 1.650 J/g ⋅ °C specific heat liquid = 2.280 J/g ⋅ °C A 26.10-g sample of liquid n-pentane is initially at −51.40°C. If the sample is heated at constant pressure (P = 1 atm), how many kJ of energy are needed to raise the temperature of the sample to 65.30°C?