A vacuum gage connected to a chamber reads 35 kPa at a location where the atmospheric pressure is 92 kPa. Determine the absolute pressure in the chamber. Answer: Pabs = 57 kPa 35 КРа Ps Pm = 92 kPa

A vacuum gage connected to a chamber reads 35 kPa at a location where the atmospheric pressure is 92 kPa. Determine the absolute pressure in the chamber. Answer: Pabs = 57 kPa 35 КРа Ps Pm = 92 kPa

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 17RQ: At a constant pressure, how does a volume of gas vary with respect to the absolute temperature?

See similar textbooks

Related questions

Q: Motive power for the experimental 17.9-Mg bus comes from the energy stored in a rotating flywheel wh...

Q: The bar AB in figure "a" has weight W, length L, and is articulated at point B. End A is supported b...

Q: HW) Can we create a hydraulic hand jack that can be used to lift heavy weights (say 1000 KN) by simp...

Q: 1. The wheel starts rotating from rest, 5) if its angular velocity @ as a function of angular positi...

Q: A manometer containing oil (p = 850 kg/m³) is attached to a tank filled with air. If the oil-level d...

A: ρ = 850 kg/m3 h = 80 cm = 0.8 m Patm = 98 kPa g = 9.81 m/s2 Find P

Q: please help with following problems, i have attached my figure (a) Calculate the amount of heat tr...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: 1. Steam enters an insulated turbine at a pressure of 1 MPa and temperature 200°C, and exits at 40°C...

A: Find the power developed and change in specific entropy.

Q: Air inlet to a gas turbine has conditions 275.79 kPa, 54.44°C while the outlet has conditions 14.7 p...

Q: You turned on the tape and fill you bath tub with water running at 0.5 liter/s. While doing that the...

A: The standard capacity of a bath tub is usually 180 litres. Since water was coming at the rate of 0....

Q: A power cycle operates between two thermal reservoirs at 1200 K and 400 K, respectively. For each of...

Q: Which of the three air-conditioning possible systems listed below should be used to maintain the ind...

Q: Problem 3: For a given strain gage below; Ea = 0.001 %3D Eb = 0.002 ɛc = 0.004 60 60 Using the above...

Q: A pitot tube directed into a water stream. having a velocity of 2.7 m/sec. It has gauge difference o...

A: A pitot tube directed into a water stream with a velocity of 2.7 m/sec is known to work. The water m...

Q: Define the given terms related to mechanical properties of materials. 1. elastic material 2....

Q: Q6. The spring of constant k is unstretched when the slider of mass m passes position B. If the slid...

Q: Prove the following derivation

Q: a) Compute the bearing of line BC. b) Compute the distance of line DE. C) Compute the area of the lo...

A: Given data

Q: Evaluate whether this refrigerator is possible. The inside temperature is -10degC in the icebox. The...

A: Given Data TH=25°C=298 K Tc=-10°C=263 K COP=7.5

Q: Q8. Enthalpy is defined sum of kinetic and flow energy (True False). 09. Cyclic process is defined a...

Q: 10.) R-134a is the working fluid in the two stage vapor compression refrigeration system using a dir...

Q: passes point C, determine the work done by friction on the system over this portion of the motion

Q: each of three barges has a mass of 30 Mg.Whereas the tugboat has a mass of 12 Mg.As the barges are b...

Q: 2) Determine the mass of each of the two cylinders if they cause a sag of s equal to 0.85 m when sus...

Q: • Water evaporates from the surface of a pond and the vapour diffuses through the stagnant film of a...

Q: A fluid flows through a sudden expansion as shown in the figure. The pressures before and after the ...

Q: The gearing arrangement suitable for this application is?

A: Given; A motor is connected to a stirrer and is running at; Nstirrer=36 rev/minPower of motor is=1...

Q: When waves approach an irregular shoreline, do the waves refract (bend) towards the parts of the coa...

A: Waves are generated by the wind and many other factors.when waves generated then most of the energy ...

Q: Problem 3 A gate is 1.5m in wi dth and hinged at point A. Another point on the gate, B. is resting a...

Q: À hydrogen atom in its first excited (2p) state is placed in a cavity. At what tenperature of the ca...

Q: Determine the diameter of the penstock, Runner

Q: Give an example problem with this topic:Dynamic Equilibrium in Translation (Analysis as a Rigid Body...

Q: The figure shows a horizontal steel bar of thickness h loaded in steady tension and welded to a vert...

A: As per the guidelines we have to solve only first question. So kindly you post the second question i...

Q: Qx-Abeam tuadet with distributed Load as in figure Determine the madimny deflection and EI- 16-7x1 N...

Q: A car moves in a straight line such that for a short time its velocity is defined by v= (3t^2+ 2t) m...

Q: 3/ calculate the moment of the 60N force about point O for the condition 0 30

A: The moment of a force is the product of the force with the perpendicular distance from the point of ...

Q: the beam are as follows: IPN 280 section, L = 3.5 m, P = 18 kN, and a = 26.57°. (Note: See Table E-2...

Q: A rigid vessel contains 2kg of steam at 6.35 MPa and 3750C. Determine its enthalpy in kJ using steam...

Q: B A Two cables are tied together at C and loaded as shown. Determine the tension (a) in cable AC, (b...

A: Find the tension force in AC and AB.

Q: If the velocity field is defined by V =-2xyi + y°j, determine the circulation around a path enclosed...

Q: 28. A locomotive coupling rod, 2-5 m between centres, is of symmetrical I- section: the outside dime...

Q: The gearing arrangement suitable for this

A: Given; A 2.7 motor is running at 1850 rev/min Power,P=2.7 kW Running at, N=1850 rev/minIt is to be c...

Q: PROBLEM 2. A structure shown in the figure weighs 3 kN/m each member supported by hinges at A and C....

Q: Problem#1 Draw the shear and bending diagram for the hanged beam shown below using section method an...

A: Given length of the beam→L=4+2=6 m Uniform distributed load→w=6 KN/m Let consider vertical reaction ...

Q: Consider water is flowing through a pipe with a 10 cm diameter at a flow rate of 0.2 kg/s. The inlet...

Q: 2. Use the compressibility charts to calculate the temperature of SO2 in a 5 ft3 rigid tank contain...

A: Given: Volume of the rigid tank→V=5 ft3=5×28.31×10-3 m3=0.141 m3 mass of the gas→m=50 lb=50×453.59×1...

Q: An object will possess uniform motion as long as the resultant force acting on it begins to decrease...

A: It is required to choose correct answer

Q: In blanking operation the clearance is provided

A: Given; Blanking operation the clearance is provided on;

Q: A truck is traveling at 40 mph when the brakes are applied on all of its wheels, causing it to skid ...

A: Given: The initial velocity of the truck is 40 mph. The skidding distance is 33 feet. The weight of ...

Q: Is it easier to solve for the head loss when it's a laminar flow than turbulent flow?

A: It is easier to solve for the head loss when it's a laminar flow than turbulent flow. By Darcy Weisb...

Q: A particle travels along a straight line with a speed ?? = (0.5?3 − 8?) m/s, where t is in seconds. ...

A: Given: Speed, v= 0.5t3- 8t, where t is in seconds. To find: Acceleration of the particle when t = 3s...

Concept explainers

Thermodynamic Relations

Thermodynamics is the division of physics that deals with the transfer of any kind of energy, whether it be heat, temperature, or work, from one object to another.

Question

100%

A vacuum gage connected to a chamber reads 35 kPa at a location where the
atmospheric pressure is 92 kPa. Determine the absolute pressure in the chamber.
Answer: Pabs = 57 kPa
35 kPa
Pabs
Pam = 92 kPa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A vacuum gage connected to a tank reads 30 kPa at a location where the barometric readings is 755mmHg. Determine the absolute pressure in the tank in kPa?
A vacuum gauge connected to a chamber reads 42.4 kPakPa at a location where the atmospheric pressure is 94 kPakPa. Determine the absolute pressure in the chambe
The average atmospheric pressure on earth is approximated as a function of altitude by the relation Patm = 101.325 (1 − 0.02256z)5.256, where Patm is the atmospheric pressure in kPa and z is the altitude in km with z = 0 at sea level. Determine the approximate atmospheric pressures at Atlanta (z = 306 m), Denver (z = 1610 m), Mexico City (z = 2309 m), and the top of Mount Everest (z = 8848 m).
The average atmospheric pressure on earth is approximated as a function of altitude by the relation Patm 5 101.325 (1 2 0.02256z)5.256, where Patm is the atmospheric pressure in kPa and z is the altitude in km with z = 0 at sea level. Determine the approximate atmospheric pressures in Atlanta (z = 306 m), Denver (z = 1610 m), Mexico City (z = 2309 m), and the top of Mount Everest (z = 8848 m).
A vacuum gage connected to a tank reads 45 kPa at a location where the barometric reading is 755 mmHg. Determine the absolute pressure in the tank. Take ?Hg = 13,590 kg/m3.
A vessel is initially connected to a reservoir open to the atmosphere. The connecting valve is closed, and a vacuum of 19.37 in. Hg is applied to the vessel. What is the absolute pressure (psf) in the vessel?
When measuring small pressure differences with a manometer, one arm of the manometer may be inclined to improve the accuracy of the reading. (The pressure difference is still proportional to the vertical distance and not the actual length of ghr fluid along the tube.) The air pressure in a circular duct is to be measured using a manometer whose open arm is inclined 25 degrees from horizontal. The density of the fluid in the manometer is 900 kg/m³, and the vertical distance between the fluid levels in the two arms of the manometer is 7.8 inches. Determine the gauge pressure of the air in the duct and the length of the fluid column in the inclined arm above the fluid level in the vertical arm.
The absolute pressure in a tank is measured to be 35 kPa. If the atmospheric pressure is 100 kPa, the vacuum pressure in the tank is
Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on the pressure gage is P kPa, determine the distance between the two fluid levels of the manometer if the fluid is (a) mercury (p = 13,600 kg/m³) or (b) water (p = 1000 kg/m³). %3D Gas h = ? P (kPa) -22
The barometric pressure at the base of a building is 105 kPa and on the roof it is 98 kPa. If the density of air is 1.2 kg/m3, what is the height of the building?
The vacuum pressure of a condenser is given to be 65 kPa. If the atmospheric pressure is 98 kPa, what is the gage pressure and absolute pressure in kPa, kN/m2, lbf/in2, psi, and mmHg
Consider a cylindrical tank contains pressurized oxygen gas. The gage on the tank reads 100 kPa. A manometer is attached to the tank to verify its pressure. The manometer fluid has a density of 13,600 kg/m3. Determine the manometer reading in cm. (g = 9.80 m/s2 ; gc = 1 kgm/ Ns2).