A uniform diving board, of length 5.00 m and mass 57.0kg, is supported at two points; one support is located3.40 m from the end of the board and the second is at4.60 m from the end. A diver of mass 52.0 kg stands atthe end of the board over the water. What is the forceacting on the board due to the left-hand support? Ifthe force acting is downward, enter a negative valueand if the force acting is upward, enter a positive value.

Given that,Length of the board, 5.00mMass of the board , 57.0kgd1=3.4m;d2=4.6mMass of diver…

Answered: A uniform diving board, of length 5.00…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 500 lb buoy, with a 2 ft radius is tied to the bed of a lake using a steel cable. What is the tensile force in the cable? W 44 2' CB CM T FB Yw = 62.4 Ibs/ft3
... 4m 2m Hinge Water 50cm 420cm 30cm B.
6. The steel gate 2.61m square of thickness 36.1mm is to be lifted by a frictionless pulley. The coefficient of friction between the dam and plate is 0.216 ,calculate the minimum force required to lift the gate if it is fully submerged to a depth of 1.61m. Use specific gravity of steel 8.0 PLEASE ANSWER THIS ASAP!!!
The gate holding back the oil (S=0.8) is 80 cm high and 120 cm long. If it is held in place only along the bottom edge, what is the magnitude of the force that must be applied at the bottom to keep the gate closed? binge- 40 cm 80 cm gate Select one: O a. 3.52 kN O b. 4.40 kN O c. 3.01 kN O d. 4.68 kN
A closed cylindrical drum is 30cm in diameter and 50cm high as shown, contains a liquid (SG liquid = 0.83) and a depth of 20cm. The drum is then submerged in water and attached to a beam using a tension wire. Neglect the outer and inner thickness of the drum. To keep the beam in horizontal position, determine the following: a) The force "B" if the specific gravity of the drum is 1.65; force "B" is ____ KN b) The specific gravity of the drum if the force B is 160 kg; SG of drum is _____
HYDRAULICS PROBLEM: The 600lb, 20ft wide rectangular gate shown is hinged at B and leans against the floor at A making an angle of 45degrees with the horizontal. The gate is to be opened from its lower edge by applying a normal force P at its center. a.) Determine the magnitude of the hydrostatic force acting on the gate using the HYDROSTATIC PANEL EQUATIONS. Express your answer in kips. b.) Determine the minimum force P required to open the seawater gate. Express your answer in kips. *STRICTLY SHOW COMPLETE FBD AND SOLUTIONS
10:58 1 Seatwork 1 (Normal Stress) A NAME: DATE COURSE/YEAR/SECTION: SEATWORK #1 01. The two-bar structure shown is pinned at A, B, and C. A sign weighing 20 kN is suspended from bar BCat points Dand E, which are located at 0.8 m and 0.4 m, respectively, from the ends of the bar BC. If member AB is a steel pipe with inside diameter 20 mm, determine the smallest permissible outer diameter of the member if the working stress in steel is not to exceed 140 MPa. SUMMARY OF ANSWERS 2.0 m do D 0.9 m -0.9 m 0.8 m 04 m W= 20 kN 02. Determine the smallest allowable cross-sectional areas of members JK, DK, and DE of the truss shown. The working stresses are 120 MPa in tension and 80 MPa in compression. (A reduced stress in compression is specified to reduce the danger of buckling.)
HYDRAULICS PROBLEM: The 600lb, 20ft wide rectangular gate shown is hinged at B and leans against the floor at A making an angle of 45degrees with the horizontal. The gate is to be opened from its lower edge by applying a normal force P at its center. a.) Determine the magnitude of the hydrostatic force acting on the gate using the HYDROSTATIC PANEL EQUATIONS. Express your answer in kips. b.) Determine the minimum force P required to open the seawater gate. Express your answer in kips. *STRICTLY SHOW COMPLETE FBD
W = 5 lb 3. The bottom of a 5-lb vertical plunger is in the dashed position in resting equilibrium against the spring with a stiffness k of 10 lb/in. The upper and lower end of the spring is welded to the plunger and the base plate. (So, the spring can carry compressive or tensile loads.) If the plunger is lifted 1.5 k = 10 lb/in. inches above its equilibrium position and released from rest, what is its velocity v as it strikes the button A. Neglect friction.
B 12 m No. 3 Please note, this is an Equilibrium problem. 8 m 10 m 1.2 m A O C 200kg P 2 m SAMPLE PROBLEM 2.9 A 200-kg cylinder is hung by means of two cables AB and AC, which are attached to the top of a vertical wall. A horizontal force P perpendicular to the wall holds the cylinder in the position shown. Determine the magnitude of P and the tension in each cable.
Q3. Consider a buoy attached to a supporting cable as shown. The buoy is 3 m long, it has a diameter of 200 mm, and its specific gravity relative to seawater is 0.60. In a coastal environment at low tide, the buoy is not fully submerged and inclines as shown. At high tide, the buoy is fully submerged and is oriented vertically. Density of Seawater is 1023 kg/m³. (a) What is the tension in the support cable at low tide? (b) What is the tension in the support cable at high tide? Buoy. 200 mm Low tide. Seawater 3 m 0.5 m Support cable Support -
Air RD -0.75 Q3-A reducer bend having an outlet diameter of 15 cm discharges freely. The bend, connected to a pipe of 20 cm diameter, has a deflection of 667 and lies a horizontal plane. Determine the magnitude and direction of force on the anchor block supporting the pipe when a discharge of 03 m²/s passes through the pipe

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS