A time-proportioning (PWM) controller with a DC output voltage of 35 volts will produce an average voltage of ____________________ volts if it is switched ON for 0.72 of the time. Note provide an answer to include two decimal places.

Q: What does the inlet air temperature sensor mean? Explain how to verify the integrity of the wires…

A: The Intake Air Temperature sensor (IAT) screens the temperature of the air entering the motor. The…

Q: Switching, Cords and Cables, Motors, and Related Systems 15.a. Information such as manufacturer's…

A: Motor:- Motors are used for the conversion of electrical energy into mechanical energy. On the basis…

Q: Given the image below, what are the control signals needed to perform the NOT operation (OR (x, y)).

A: The control signal needed to perform the NOToperation (OR(x,y) ) are:Since,zx =1, then x = 0, the…

Q: A time-proportioning controller with a DC output voltage of 25 volts will produce an average voltage…

A:

Q: Draw a simple block diagram of 'Open-Loop Control System' and 'Closed-Loop Control System' Not…

A: CS - control system

Q: What is the scope and limitation of the automatic fence light controller?

A: Scope of the automatic fence light controller: The automatic fence light controller is very…

Q: Identify and describe the basic functional elements that could be used in closed loop control for…

A: Closed-loop Control system -  A closed-loop control system, also termed a feedback control system,…

Q: 1- Which type of instruction dose INTO normally follow? Which flag does is test?

A: The signals that are directly available from the devices are analog. Hence a conversion is required…

Q: The process variable that is adjusted to bring the controlled variable back to the set point is…

A: The correct answers to given questions are as follows.

Q: What is an indicating instrument? Which torques are essential for functioning of indicating…

A: Given that What is an indicating instrument? Which torques are essential for functioning of…

Q: Question: 1:- What is the advantage of the adding a Lag controller for the SS model?

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Explain telemetry, command control system in detail. tracking and

A:

Q: Aligners with a video display unit have this mounted in a console. These are computerised units that…

A: Aligners comprise four alignment heads which are mounted on the vehicle wheels and also have sensors…

Q: From what location are the first computer instruction ?available on boot up

A: using the bootup process one can make it ready to use by putting in the instructions which it needs…

Q: For what load an AC voltage controller can be regarded as a constant voltage source?

A:

Q: Briefly explained the function of the hold device in a digital control system.

A: The hold device is used to convert discrete signal into continuous or analog signal which can be…

Q: Explain the meaning of CASCADE Control system (Serie ). a.Give a practical example of this Cascade…

A: When there are multiple measurements but only one control variable available, then the system called…

Q: Determine the input and output connections for an oven with automatic temperature regulation. Cite…

A: According to the question, we need to determine the input and output connections for an oven with…

Q: b) Differentiate between modern and classical control system?

A: Since both questions are different so we are supposed to answer any one.  b)  In systems described…

Q: 1. How will you check? And what instrument will you use to determine whether the power supply is…

A: According to our policy we can provide solution. For other solutions repost the questions with…

Q: Connect the AC speed control device given below in a way that it connects Star to the motor.

A: Explanation: There are three windings in the armature of any three-phase motor they are To connect…

Q: Is Refrigerator an open loop or closed loop system? Write the reason for your answer. For the…

A: Open loop system- Open loop system is nothing but a system in which for a given input the output…

Q: Q 127. technician a says a throttle by wire system [ETC] eliminate the need for a cruise control…

A: ETC SYSTEM-   ETC stands for the Electronic throttle system.    It is an automatic technology…

Q: Consider the block diagram shown is for a closed-loop temperature control system. Where is the…

A: Given: The block diagram for a closed loop temperature controlled system is,

Q: 1. Consider one of the advanced driver assistance system(ADAS) called as adaptive cruise…

A: (i) Explain how the ACC system works. What are the minimum required sensors? (I) solution :  Q1.What…

Q: timer/counter working modes?

A: ADC-Full form of ADC is analog to digital conversions. And the electronics device used for…

Q: Explain how wiring the control components for sump pumps and fill tanks differs.

A: Wiring: Electrical wiring involves the installation of cabling and associated equipment in a…

Q: What is position control system ??

A:

Q: the block diagram model for a computerized control system?

A:

Q: Give 5 examples of Open-loop controlled systems and 5 Closed-loop control systems found at home and…

A: Open loop control systemsare simple system which does not change output automatically and only…

Q: Q/ Do you observe any relation between the system damping ratio and the system settling time.

A: We need to tell about relationships between damping ratio and settling time

Q: Describe about one of the control section component which is used to operate double acting actuator…

A:

Q: What is a bus controller?

A: Note:-Hence the question is asked in the electrical engineering section I'm considering the Bus…

Q: Define in short about PLC.

A: In this question we have to define PLC in short..

Q: What will happen to the system if the power amplifier is not used in the Infrared Remote controller…

A: The infrared remote control systems have a infrared controlled switch which can be used in number of…

Q: Design a PLC program and prepare a typical I/O connection diagram and ladder logic program for the…

A: In the question, the following data is given. A motor named M and three controlling START/STOP…

Q: Instruction: Identify the parts/components as illustrated in the pictures and write down the…

A: The Basic Elements of the computing system can be identified based on the function of those devices.

Q: Name 5 types of the control system for micro air vehicle

A: A new type of remotely controlled aircraft is known as a micro air vehicle (MAV) or micro aerial…

Q: What is the name of the wires that connect the memory?

A: Memory: Memory serves as the computer's electrical storage facility for the instructions and data…

Q: Question 1: Why is the voltage decresed at no-load operation? What is that voltage called?

A: According to guidelines we need to solve only the first question.  According to the question we have…

Q: What is the difference between a one function and a multifunction electronic control device

A: A one function electronic control device operate only one function, Those equipment which uses…

Q: what is the most common control voltage use in intrinsically safe system?

A: Intrinsic safety is the method of protection for control and instrumentation circuits where the…

Solar Cell

A solar cell, or photovoltaic cell, is a device that converts light into electricity directly through a photovoltaic effect, i.e., a physical and chemical event. It is a type of electromagnetic cell, defined as being used for its electrical properties, current, voltage, or resistance, which vary when exposed to light. Everyday cellular gadgets are usually the building blocks of photovoltaic modules, collectively known as solar panels. Single junction silicon solar cell can generate an open circuit of about 0.5 to 0.6 volts.