A three phase motor canbe regarded as Balanced "Wye " load. A three motor draws 5.6 KW when the voltage is 225 V and the line current is 18.5 Amperes .Determine the apparent power and the power factor

Q: Develop expressions for the rise time, fall time, propagation delay, and power-delay product of CMOS…

A: CMOS: CMOS also known as Complementary Metal-oxide Semiconductor it consist of Series combination of…

Q: H.W Q1) A four pole, three-phase synchronous generator is rated 250 MVA, its term is 24 kV, the…

A: Armature winding leakage reactance and a reactance used to depict armature reaction are combined to…

Q: 5. Which of the following technology was used by Intel to design its first 8-bit microprocessor?

A: The correct option along with the explanation is provided in the following section.

Q: Consider the system having transfer given by: G(s) Determine the breakaway point. = K s(s+ 4) (s +4…

A: Given: Consider the system having transfer given by: Gs=Kss+4s+4∓j4 To find: Determine the breakaway…

Q: Time left 0.57 Consider an aperiodic continuous-time signal z(t) having the corresponding Fourier…

A: This question belongs to signal and system . It is based on the concept of Fourier transform of the…

Q: 38. If the current flowing through a 20 ohm resistor is given as, i(t) = 4 + 5 sin wot - 3 cos 3 wot…

A: Given data, Resistance R=20 Ω Current equation it=4+5sinωt-3cosωt

Q: QUESTION 4 Maximum Power transfer (CLO 5) The value of the load resistor R₁ to ensure the maximum…

A: Given circuit,

Q: 3) Determine whether or not each of the following continuous-time signals is periodic. If the signal…

A:

Q: POSSIBLE QUESTIONS 1. How much energy in jouls is read. to move a a potential differ ol 6x2 CU…

A: NOTE_ “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: 3. What is the reactive factor of a circuit that has an input impedance of 40L50 Q? Also, what…

A:

Q: The value of Planck's constant is 6.63 x 10-34 Js. The speed of light is -1 3 x 10¹7 nms ¹. Which…

A: Given, Planks constant, h= 6.63×10-34 Js. Speed of light, c = 3×1017nms-1 Frequency of light, f=…

Q: four-input EX-OR logic functions with the help of two-input EX-OR gates? Draw its logic

A:

Q: Transformers are electrical devices that A. generally have three to four moving parts. B. have a…

A: Transformers:- Transformer: A device that steps up or steps down the voltage as it transmits…

Q: the following circuit, find Vo

A: Given- Source voltage= 20 Volts Resistance, RA= 1kohm RB=2 kohm RL= 1 kohm To find- Output voltage,…

Q: find the value of RL for the given circuit if maximum power is transferred. www 50 12V 7 a 16V

A: Given, The circuit is

Q: Given X₁(e) = 5+2cos (5w), use inverse d) [.. DTFT to find the signal a[n].

A:

Q: 1. 1. Get the value of l1, si M = V1 12Vrms ~ 60Hz 0° R1 ww 2Q M L1 0.5H H, and the circuit is in…

A:

Q: (b) The characteristic equation of a feedback control system is s+20s +15² +2s+k=0 Determine the…

A: Given,For a feedback controller system,The characteristic equation is given…

Q: is transformer work with direct current supply ?

A: Transformer: Transformer is a static device. It is used to transfer power from one place to another…

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is to be converted to a 5 Amp-ammeter. What is the value of…

A:

Q: The number of bits required for a binary code to represent 4276 different possibilities is Select…

A: Given data, Total different possibilities are 4276.

Q: 2. If a dry cell has an internal resistance of 0.50ohm and an emf of 2V, find the power delivered in…

A: Given: Internal resistance of dry cell, r=0.50 Ω EMF of cell, E=2 V Load resistance, R=1 Ω

Q: A teflon parallelepiped plate (= 2.25) of thickness a and infinite length is positioned

A: Given- For a Teflon parallelopiped  plate- Teflon plate permittivity, εr=2.25 Length = Infinite…

Q: Given X(w) Then X(0) = Select one: O 0.00 ο ο ο Ο 2 O j Ο 2/15 1 sin(2ω) J

A:

Q: (a) Consider the circuit shown in below R₁ ww u i) ÿ(t) +ÿ(t) + y(t) = u(t) ii) ÿ(t) + 2y(t) + y(t)…

A:

Q: In the circuit shown, find the total power absorbed by the three resistors. Then find the sum the…

A:

Q: Loop analysis (CLO 4) The value of 13 in the following electric circuit equals: 5 Ω 15 V Μ WW 13 Μ 6…

A: Given circuit,

Q: For the following transfer function H(s), as the frequency w becomes very large, the magnitude of…

A:

Q: How much demand factor is considered in the first 3000VA of hospital occupancy? 40% 35% 100% 20%

A: Demand factor:- It is defined as the ratio of maximum demand to the connected load on the system. It…

Q: U₂ (1) C * R Op-amp vo (1) •Find vo(t) if vi(t)=In(2t)sin(2t) mV.

A:

Q: Electrical Engineering 1) Design a PID control so that the system follows the reference given by the…

A: The most precise and reliable controllers are PID (proportional integral derivative) controllers,…

Q: Two wattmeters (W1 & W2) are connected as shown below to measure the total power for a balanced…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Find (mA) in the circuit in the figure. Round-off to 3 decimal place. Do not include units. 4 mA 3…

A: The detailed solution is provided below.

Q: A 50 kVA, 1100/230 V, distribution transformer has iron loss of 1 kW and full load copper loss of 2…

A:

Q: According to Sylvania, a light bulb manufacturer, its 75 W CFL floodlightconsumes 23 W and produces…

A: The efficacy is defined as the ratio of the luminous flux and input power. The expression is,…

Q: For Common - collector of Emitte Follower JB 3RB 270k 3=120 -Vo 13 RE JE 2,4K 3 VEE -24V

A:

Q: For the following circuit, find Vo a. 18.6V b. 19.6V c. 19.3V d. None 20V Si www 1k 2k Ge Si www Vo…

A:

Q: Simplify the following functions, and implement them with two level NAND gate circuits: F (A, B, C,…

A: It is given that: F (A, B, C, D)=A′B′C′D+CD+AC′D

Q: In a delta modulation system, how many bits per sample are transmitted by the transmitter?

A: The solution is provided in the following section.

Q: find the value of RL for the given circuit if maximum power is transferred. 40 Q ww 360 V w a 1000…

A:

Q: The voltage difference between points a and b is provided by a battery that has a voltage Vab= 24…

A:

Q: (b) A 200 kW, 200 V, 4-pole, 800 rpm, separately excited DC generator is suggested to deliver the…

A: Given: PI=200 kWVt=200 VP=4 poleN=800 RPMNF=800 turns/poleProt+Pcore=8kw

Q: 30/-35° V (+21) 16 f -j28 (1 Ht 80 36/15° V Fig. 13-38 12 Ո j20 le

A: Note : Since nothing is mentioned what should be answered . I1 and I2 is shown in diagram.  So we…

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A: 13. Given data, Terminal voltage V = 200 V Field resistance Rf=200 Ω Field current will be equal to,…

Q: . Do the following operation (i) (246 )8 + (521)8 (ii) (324 )8 + (631)8 (iii) (704 )8 - (103)8

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Obtain the z-transform of the following: A. B. C. D. X(z) = X(z)= = x(n) = 3 1 (1-3-¹) (1 -2 -1…

A:

Q: For the emitter-bias network, determine: a. Ig b. lc C. VCE d. Vc e. VE f. VB g. VBC 430 ΚΩ 10 μF…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Consider an aperiodic continuous-time signal x(t) having the corresponding Fourier transform X(jw).…

A:

Q: 1. A single phase circuit with a given load  5 ohm resistance and capacitive  reactance of 2 ohms as…

A:

Q: Implement the following Boolean function with a 4 × 1 multiplexer and external gates.1. (a)∗ F 1 ( A…

A: The given Boolean function can be implemented by using the truth table and by using the truth table…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.