A Thevenin equivalent circuit with a 4V source and 3000 ohms resistance in series can be converted to a Norton Equivalent Circuit containing what? A. 1.33 V source and a 3000 ohms resistance in parallel B. 1.33 mA source and a 0.33 K-ohms resistance in parallel C. 1.33 mV source and a 0.3 k-ohms resistance in parallel   D. None of the choices are correct   E. 1.33 mA source and a 3000 ohms resistance in parallel

Q: 1. When was the time that C1 and C2 charges and releases stored electrical voltage? 2. Which Capacit...

A:

Q: A semiconductor is a material that has _____ energy band gap. a)no b)wide c)narrow d)nuclear

A: Energy band gap is the difference in the energy between the conduction band and the valance band. A ...

Q: What is the speed of a 100 Kw, 230 Volts , 3 phase , 4 pole , 60 Hz , alternator 1800 RPM 1700 RPM 1...

A: Consider the formula for the speed is, N=120fp Here, f is the frequency  and p is pole.

Q: Problem 5 Compute the power delivered to the load by the three-phase generator in the circuit shown ...

A: The solution is given below 

Q: A 4-pole, wave-wound, 750 rpm shunt generator has field resistances of 0.4 ohm and 200 ohms, respect...

A: The solution is given below 

Q: A hydroelectric power station is supplied from a reservoir having an area of 50 km2 and a head of 5...

A: Here, we have provided some information about the hydroelectric power station,  The area, head and t...

Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure. Deter...

A: Capacitance value not given It might be 50 Hz or 60 Hz  So taking both the cases... It is a simple s...

Q: If you wanted to wire a 4-way switch circuit that was controlled from five locations, how many 4-way...

A: Brief description : Here they have mentioned a four way switch circuit. And they have also given tha...

Q: Use this graphic for questions 6, 7, 8, 9, and 10. The total power from the supply is 500mW. R6 R4 R...

A:

Q: 1.) A common-emitter amplifier circuit is shown below. The BJT parameter values are B = 100, gm = 24...

A: Brief description: Bipolar junction is known as bipolar because of their is a conduction of electric...

Q: A 4-pole, 500 V d.c. shunt motor has 720 wave-connected conductors on its armature. The full-load ar...

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: How many different 3-bit binary state encodings are possible in a controller with 4 states? How many...

A:

Q: E. The equivalent resistance between points 1 and 2 of the circuit shown is: sng a bobnano as owr be...

A: Given circuit:

Q: The circuit shown in the following in figure has: VIN 10 V, Vz 7.2 V@ Iz-40 mA, IzK =2 mA, Iz= 100 m...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: For two charges Q at (4,0,-3) and Q, at (2,0,1), find Q if Q, = 4 nC for force F at (5,0,6) has no x...

A: Since you have asked multiple questions, we will solve the first question for you . If you want any ...

Q: 100 kN 15 V = 10 V 56 kN RL (©) figure also for Norton's theorem

A:

Q: An electric field of 0.151 N/C passes through a vector area of 3.1 cm?. Calculate the electric flux.

A: We have given the following problem

Q: A multiple choice examinations has 200 questions each with 4 possible answers of which only one is c...

A:

Q: Write atleast 3 advantages of PLC.

A:

Q: Find the cross-sectional area of a round conductor in square mils if the conductor's diameter is 11/...

A: To find the cross section area of a round conductor in square mils  Diameter of conductor = 11/16 in...

Q: Given the circuit below. i, (t) = V210 cos(377t). Give your answer in four decimal places if it is n...

A:

Q: 8. An electric field of 0.151 N/C passes through a vector area of 3.1 cm? . Calculate the electric f...

A:

Q: 40Ω 20Ω 50Ω 20V 30Ω 10Ω

A:

Q: A magnetic vector potential A is defined as; A = - a, Wbim Calculate the total magnetic flux o cross...

A: Brief description:  In the above given question they have mentioned magnetic vector potential A' whi...

Q: Explain why Covalent Bonding is used in bonding of semiconductor materials.

A:

Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two c...

A:

Q: In the given circuit, find the DE Model and TF Model.

A:

Q: T (s) = s+2 s2+9

A: "As per our guidelines, we are supposed to answer only three subparts. Kindly repost the other subpa...

Q: Problem 10.9 For the circuit shown in Fig. 10.7, find the current at t> switch is closed at t = 0. A...

A:

Q: 13 A R1 R3 1k 2k2 V1 V2 R2 V 12 +, 2k2 12V 24V 1) +1

A:

Q: Sketch the output waveform. Show your complete analysis. 1. at E IN RSI"

A:

Q: Given the following resistance R, = 100, R2 = 50, and R3 = 50, and voltage V, = 20V and V, = 12V, So...

A: We have given the following problem

Q: 5. Use the circuit below to solve this problem. a) Find vo. b) Find vx. c) Find the power delivered ...

A:

Q: 22. Given a set of capacitors: 12nF, 6nF, 9nF, 4µF, 2pF and 7µF, solve the following problems: a. So...

A:

Q: Why is the circuit critically damped? Explain.

A:

Q: A CE amplifier uses a BJT with B = 100 biased IC = 0.5 mA and has a collector resistance RC = 15 kN ...

A: Please refer the attached images for the complete answer..

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm? at temperature of 0°C...

A: (1) It is given that: L=15.6 mA=12 mm2=12×10-6 m2V=240 VI0=7.9 A  (At 0°C)        

Q: With the assistance of a figure, briefly describe the major difference between synchronous and async...

A:

Q: 4. Given the parallel circuit, solve for the a. Total resistance 12 VE 1.2 03 0.6 0 0.4 0g b. Curren...

A: Brief description : Resistor is an electrical element which is used to limit the amount of current f...

Q: A 25 kVA, 220V, 3φ alternator delivers rated kVA at a power factor of 0.84. The effective ac resista...

A: Pout= 250.84 = 21KWI0 =250003×220=65.61ARa =Rt2=0.182=0.09 ohmLosses:-a) armature winding-   Pa = 3I...

Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below.

A:

Q: In the circuit, the current through R2 in mA is __

A:

Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A s...

A:

Q: A pacemaker has an RC circuit that control the time of voltage giving out. A suitable time constant ...

A:

Q: 5. For the given circuit below, determine (a) the voltage across each capacitor and (b) the energy s...

A: Here, we have given an electrical circuit having, no. of capacitor connected in series and parallel ...

Q: Find the total Capacitance in the circuit. A 4 µF 6 pF 5 µF * 8 uF :2 pF Ст — *6 µF B 3 uF 10 uF 6uF

A:

Q: For the system described by v() - 블피(0) + 를c0s (()) 글피(1) + 을cos(x(4)) where x(t) is the input and y...

A:

Q: Write atleast 2 diadvantages of PLC.

A: 1 . PLC is the Fixed circuit Operation 2.  There are limitations of operation of              PLC un...

Q: 1. A 1Ø, 2 wire distribution line, 1280m long has an impedance per conductor per km of 1+j2.52. The ...

A:

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 R1 R3 R5 10 V1 12 R2 R4...

A:  Given circuit shown      

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.