A test tube is prepare using a concentrated stock solution with a concentration of 10.4 mg/mL. The test tube is prepared with 357ul of stock solution, 211 µL of solution A, 220 µL of solution B and 257 µl of distilled water. What is the concentration of thediluted solution?Give the answer with 1 decimal placeType your numeric answer and submit

Answered: A test tube is prepare using a…

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter16: Solutions

Section: Chapter Questions

Problem 14E

See similar textbooks

Similar questions

Every pure substance has a definite and fixed set of physical and chemical properties. A solution is prepared by dissolving one pure substance in another. Is it reasonable to expect that the solution will also have a definite and fixed set of properties that are different from the properties of either component? Explain your answer.
Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.
What happens if you add a very small amount of solid salt (NaCl) to each beaker described below? Include a statement comparing the amount of solid eventually found in the beaker with the amount you added: a a beaker containing saturated NaCl solution, b a beaker with unsaturated NaCl solution, c a beaker containing supersaturated NaCl solution. A saturated sodium chloride solution.

Recommended textbooks for you

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781285199030

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781337399425

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Introductory Chemistry: A Foundation

Chemistry

ISBN:

9781285199030

Author:

Steven S. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

General, Organic, and Biological Chemistry

Chemistry

ISBN:

9781285853918

Author:

H. Stephen Stoker

Publisher:

Cengage Learning

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS