A tank has a volume of 3 ft3 and contains 6.2 ibm of ethanegas.Findm3and the density inkgthe specific volume inkgof the gas in the tank.Thank you!m3

Answered: Image /qna-images/answer/15dff975-a8fe-4960-a1a9-1d7aa5fe97dc.jpg

Answered: A tank has a volume of 3 ft3 and…

A tank has a volume of 3 ft3 and contains 6.2 ibm of ethane gas. Find the specific volume in m3 and the density in kg kg of the gas in the tank. m3 Thank you!

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: (b) A fragile instrument which comprises of two masses m1 = 50 kg and m2 = 200 kg is connected by a ...

Q: Calculate the air velocity at ports 1 and 2 if the water column pressure difference is 8.5 cm. Air a...

A: At 1, velocity = 0 At 2, velocity = 36.52 using Stagnation pressure = static pressure + dynamic pre...

Q: 1. Knowing that the ultimate load for cable BD (diameter is 20 mm) is 110 kN and that a factor of sa...

Q: The gate shown in the figure is used to contain the water in a reservoir. The gate is hinged at B wh...

A: Find the minimum force to hold gate in equilibrium. Weight of gate = 600lb Width of gate = 20ft Leng...

Q: Two large surfaces with a gap of 34 mm width were filled with oil having a kinematic viscosity of 0....

Q: Under the right conditions, it is possible, due to surface tension, to have metal objects float on w...

Q: The vacuum at the steam inlet to a condenser was found to be 716 mm of Hg and the temperature of ste...

A: The vacuum efficiency is ηvacuum = 99.7%.

Q: X1(s) 2. Solve for the transfer function G, (s) = F(s) X2(s) G3(s) F(s)' X3(s) , G2(s) %3D F(s) r3(1...

Q: Water in a rigid container has a pressure of 1000 kPa and specific volume of 0.1 m3/kg . The quality...

Q: plss make and introduction about speed control of pneuamtic cylinder and indirect control of cylinde...

A: The pneumatic cylinders can be directly controlled via the actuation of a final directional control ...

Q: actuator needs to re 6. Graphically position the links for the box used to load supplies onto airpla...

Q: . A block weighing 400 N is pulled along a level from at a constant speed by a rope which makes 40° ...

A: Ans: 0.42 Option (b) is correct.

Q: Determine the location of the centroid of a parabolic spandrel by direct integration

Q: Determine the force due to hydrostatic pressure on the flat vertical side of a tank which has the sh...

Q: A sprinter in a 100-m race accelerates uniformly for the first 35 m and then runs with constant velo...

Q: 1.2 A particle is allowed to fall under gravity from height h. If the air damping on it is proportio...

A: Let v be the instantaneous velocity of the particle. Then the damping force is ...

Q: A 0.7 kg. ball A is moving along a horizontal circular path t a constant speed of 5 m/s. Determine (...

A: Given:m=0.7 kgv=5 m/sL=1.8 m

Q: In a CAD package, a point P(6, 3, 2) is projected along a vector V (-2, 1,-1). The projection of thi...

Q: 3. 5 kg air with initial temperature of 100°C expands at a constant pressure of 2 bar to reach to a ...

A: Given data, For air, m= 5 kg T1= 100°C = 373 K Pressure is constant P= 2 bar = 200 KPa V2= 5m³

Q: A box that contains of a 250 kg fragile instrument is transported by a truck that is subjected to a ...

Q: he piston cylinder system shown below contains R-410a at 20°C and 100 kPa. If the temperature of the...

A: Given:R-410aT=210°CP1=100 kPaT2=50°C

Q: A heat source at 600 K loses 1000 kJ of heat to a sink at 300 K. The Entropy generated in this proce...

A: Write the given values with the suitable variables. T1=600 KQ=1000 kJT2=300 K Here, T1, Q, and T2 ar...

Q: The vacuum at the steam inlet to a condenser was found to be 716 mm of Hg and the temperature of ste...

A: If no air would have present in the condenser, the maximum vacuum pressure or minimum absolute press...

Q: nich of the following (B) Grubler'sc

Q: The pressure ratio across a gas turbine (for air specific heat at constant pressure, c, = 1040 J/kgk...

Q: If it takes 41.72 joules to heat a piece of gold weighing 18.69 g from 10.0 °C to 27.0 °C, what is t...

A: Given, Heat absorbed by a piece of gold = Q = 41.72 J Mass of a piece of gold = m = 18.69 g = 0.0186...

Q: If longitudinal strain for a wire is 0.03 and its Poisson's ratio is 0.5, then its lateral strain is

Q: Solve the following problems. Be sure to show your work. Answer without work shown will receive no c...

A: Drawing equivalent load diagram. and calculated magnitude and location of the resultant force with r...

Q: For a worker that exposed frequently to hand-arm vibration, it can lead to two forms of permanent il...

Q: Steam enters a turbine operating at steady state with a mass flow rate of 1.5 kg/s. The turbine deve...

A: Given:m=1.5 kg/sP=2.7 MWh1=3506.2 kJ/kgc1=30 m/sh2=1671.67 kJ/kgc2=130 m/s

Q: 2. A square hollow steel strut with a wall thickness, t, = 10 mm is pin connected to two gusset plat...

Q: 1. What is Special Use of Airspace (Regulatory)? 2. What is Special Use of Airspace (Non-regulatory)...

A: Airspace The portion of the sky above a country, region or territory is called its airspace. This sp...

Q: A plate of 0.125 mm distant from a fixed plate, moves at 20cm/s and requires a force of 40 N per uni...

A: Given data, dy= 0.125 mm =0.000125 m du=u= 20 cm/s =0.2 m/s τ= 40 N/m²

Q: e velocity. Wh e v

Q: The pressure inside the aneroid is kept at sea level when it comes to the altimeter Smaller aircraft...

Q: el ratio at 6000 m altit sea level where air ter

Q: A laser emits light of frequency 851523504007150 Hz. What is the wavelength of the light in nm? Roun...

A: Given data, f= 851523504007150 Hz. Speed of light c= 3*10⁸ m/s

Q: Q.44. Give the different parameters value for different dielectric used in cable. Also, describe the...

A: When an electric field is applied to a dielectric material, electric charges do not flow through...

Q: on SN and the endicular to

Q: determine the distance d v

A: Need to find distance d.

Q: Problem 2 A barge is pulled by two tugboats. If the resultant of the forces exerted by the tugboats ...

Q: 4. Two cars A and B are travelling in the same direction at SLEX. Car A is traveling at a constant v...

Q: Find Rab for the circuit fn figure. 202 202 Rab 792 252

A: The circuit is shown below.

Q: 5 kg air with initial temperature of 100°C expands at a constant pressure of 2 bar to reach to a fin...

Q: A. Draw the F.B.D. of the frame shown in Fig. (4-A).

A: To Draw the FBD of the given loading

Q: load lifted by the large piston

A: To find the load lifted by large piston When pistons are at same level

Q: 18 kN 18 kN/m I W250 × 22.3 point B. Use E = 200 GPa. A For the beam and loading shown, determine th...

A: Castiglinos theorem δB=∂U∂PBP=0 at BStrain energyU=UAB+UBC∂U∂PB=∂UAB∂PB+∂UBC∂PC

Q: 3. 5 kg air with initial temperature of 100°C expands at a constant pressure of 2 bar to reach to a ...

A: (A) Work done in the process, WD = 464.74 kJ. (B) Heat supplied for expansion process, Q = 1627.39 k...

Q: What happens to the turbines as it is free to rotate?

A: Given Turbine To find Turbine as it free to rotate

Q: 1. Compute the area of bronze that will not exceed a stress in bronze of 95 mPa and load P is 81KN. ...

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

100%

A tank has a volume of 3 ft3 and contains 6.2 ibm of ethane
gas.
Find
m3
and the density in
kg
the specific volume in
kg
of the gas in the tank.
Thank you!
m3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
An air bubble is observed from the bottom up to the water surface The atmospheric pressure is 101 325 kPa The volume of the bubble at the bottom is 1/7 times the volume of the bubble at the surface Determine the height of the water in meters.
If the specific volume is 0.00135 m3/kg and volume is 0.85 liters. Find the (a) Density (b) Mass, (c) Weight density, and (d) Relative density of the liquid
Find the volume of the fluid in cm3 with a mass of 0.31kgm and density of 30 lbm/ ft3.
A volume of 400 cc of air is measured at a pressure of 740 mm Hg absolute and a temperature of 18 ˚C. What will be the volume (in cc) at 760 mm Hg and 0 ˚C?
For a gage pressure at B of -0.15 bar, find the relative density of the gage liquid A in the figure.
2. The tank shown contains alcohol (SG=D0.78) and covered by a circular plug 1.2 m in diameter. Calculate the hydrostatic force F Am acting on the plug and its center of pressure. 8m 1.2 m 3. The gate as shown is 3 m normal to the page. It keeps the two liquids from mixing with each onough clocuro botween the oil and
If A reservoir of oil has a mass of 1000 kg and volume of 440 L. then the: Weight of the oil is N
ASAP dont round off initial values, round off final ans only pls ty The pressure at a point in the seawater is 99 kPa, determine the pressure in kPa 48.13 meters below this point?
Figure Q4 5. A multifluid container is conneeted to a U-ube, as shown n Fig Q5. For the given specific gravities and fluid column heights, determne the gage pressure at A. Also determine the height of a mercury column that would create the same pressure at A Watr Gycers 50-126 Figure OS
A container filled with oil has a weight of 2 kilonewtons and an empty weight of 200 newtons. If the capacity of the container is 190 liters, caleulate the specific weight, mass density and the specific volume of the oil?
A ball of 15 cm diameter fell into a tank of water, 13% of its volume found under water. What is the density of the ball? Show the given and draw the diagram.