A tank ABCDEF shown in given figure is filled with water. A small opening at E keeps the pressure at E atmospheric. (a) Calculate the acceleration a, required to cause onset of cavitation at A. (b) What will be the pressures at that acceleration at points B, C, D and F? [Assume local atmospheric pressure head 10.0 m of water and vapour pressure head = 0.5 m (abs) of water] 1.2 m Opening 5.0 m- 1.5 m 2.3 m A 0.8 m в 1 6.2 m

A tank ABCDEF shown in given figure is filled with water. A small opening at E keeps the pressure at E atmospheric. (a) Calculate the acceleration a, required to cause onset of cavitation at A. (b) What will be the pressures at that acceleration at points B, C, D and F? [Assume local atmospheric pressure head 10.0 m of water and vapour pressure head = 0.5 m (abs) of water] 1.2 m Opening 5.0 m- 1.5 m 2.3 m A 0.8 m в 1 6.2 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 4. The open tank shown in the figure have 2 piezometers attached on one side, containing two different liquids, A (SG=0.83) and B (SG=2.50). Find the (.- El 5m a. elevation of liquid surface in piezometer B b. total pressure at the bottom of the tank. Liquid A El Im Liquid B El Om
Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in the figure below. A horizontal force of 12 N is required to hold the plate in place. Determine the reading on the pressure gage. Assume the flow to be incompressible and frictionless. (Dı=0.3 m, D2=0.1 m, F=12 N) P=? F A2 A1
(4) Consider that we have a horizentral pipe, like shown in the sketh, which is carrying in this case, cooling water at 10 °C. The elevation of the big tank of cooling water is 100 m, the elevation of the center line of the pipe is 20 m, the length of the pipe is 2000 m. Head loss in the pipe is 0. 07 L / D) V? H. D=20 cm, the rate of flow is 0.0 a=1 ase calculate the 2g pressure in the pipe. Elevation = 100 m Elevation = 20 m L=2000 m %3D II ||
plzzzz help meee right nowww plzzz what will be the pressure gradient (kpa/m) at L=30 cm through the nozzle? At L=0, the liquid flows inside the nozzle has a specific gravity S=7.5, at L=0, the velocity is 2 m/s while at L=70 cm, the velocity is 6 m/s. Assume steady and inviscid flow. The velocity varies linearly with distance through the nozzle
Bernoulli's theorem demonstration: D Water is flowing through the above venturimeter (D=22 mm and d=15 mm). What is the pressure difference (P1- P2) (in kPa) for a volumetric flow rate of 0.60 L/s? g = 9.8 m/s² and y=9.8 kN/m³
Q2. Water Is flowlng downwards in the arrangement shown in figure below at a flow-rate of 0.4 m/s. What must be the value of d for the two pressure gauges to show the same reading? Assume energy loss is insignificant. diameter 300 mm 3 m Diameter d
At 20 degree celsius, gage A in the figure reads 295 kPa absolute. The tank is 2m wide perpendicular to the figure. Assume atmospheric pressure to be 1 bar. Sp.gr. of mercury is 13.6. Determine the total pressure acting on side CD in kN. P = 183 kPa abs. show solution and diagram
Determine (a) the magnitude and (b) direction of the anchoring force needed to hold the horizontal elbow and nozzle combination shown in the figure below in place. Atmospheric pressure is 97.1 kPa. The gage pressure at section (1) is 103 kPa. At section (2), the water exits to the atmosphere. Assume p₁ = 103 kPa, V₁ = 4 m/s. (a) Kx = i 2260.24 (b) to the left N V₂ 160 mm Section (2) 300 mm V₁ Water Section (1) P1 V₁
Try to solving these problems: 1. Water at A has a pressure of 400 kPa and a velocity of 3 m/s. Determine the pressure and velocity at B and C. 150 mm 3 m/s 100 mm 50 mm B
Q2) What is the pressure at point (B)inside the pipe shown in figure below if the water jet velocity at point (A) is 18 m/s.. 15m D= 75 mm D 200 mm 0.5 m B-
Two chambers with the same fluid at their base are separated by a piston wnose weight is 25 N, as shown in the Figure below. Calculate the gage pressures in chambers A and B. Please discuss the result comparing the gage pressures you obtained in chambers A and B. • Calculation errors will not be tolerated. Solution procedure will be evaluated with the exact results. Please be careful. Piston A B Air Air D 50 cm За ст 25 cm 3b cm E, Water 90 сm
PLEASE USE EQUATIONS ATTACHED 9.95. The mean velocity of water in a 150 mm horizontal pipe is 0.9 m/s. Calculate the loss of head through an abrupt con- traction to 50 mm diameter. If the pressure in the 150 mm pipe is 345 kPa, what is the pressure in the 50 mm pipe, neglecting pipe friction? K₁ from Table 2 for abrrupt contraction find Using work- energy equation Az A₂/A₁ C K₂ 21102392 A1 2.A? 81000.0 1J0321 to 19 1200 to find the pressure. 14 or. Mive stolwlog si/s919 mE.0 P but mop, +V² F 2 P₂ + Cup 2.10 erived one wolf 829) NINY 2.0 = 9 . TABLE 2 Contraction, C., and Loss, Kr, Coefficients for Abrupt Contractions 0 0.617 0.50 0.1 0.624 0.46 0.2 0.632 0.41 0.3 0.643 0.36 0.4 0.659 0.30 V₂² + Z₂ +h₁0/₂ 2 milyot has 9919 0.5 0.681 0.24 0.6 0.712 0.18 0.7 0.755 0.12 0.8 0.813 0.06 0.9 0.892 0.02 1.0 1.00 0