A submarine is modeled as a cylinder with a length of 320 ft, a diameter of 50 ft, and a conning tower, as shown in the figure below. The submarine can dive a distance of 50 ft from the floating position in about 30 s. Diving is accomplished by taking water into the ballast tank so the submarine will sink. When the submarine reaches the desired depth, some of the water in the ballast tank is discharged leaving the submarine in "neutral buoyancy" (i.e., it will neither rise nor sink). 3% of cylinder 7% of cylinder volume volume Y' water = 64 lb/ft³

A submarine is modeled as a cylinder with a length of 320 ft, a diameter of 50 ft, and a conning tower, as shown in the figure below. The submarine can dive a distance of 50 ft from the floating position in about 30 s. Diving is accomplished by taking water into the ballast tank so the submarine will sink. When the submarine reaches the desired depth, some of the water in the ballast tank is discharged leaving the submarine in "neutral buoyancy" (i.e., it will neither rise nor sink). 3% of cylinder 7% of cylinder volume volume Y' water = 64 lb/ft³

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q4/ SAE 30 oil at 60 °F flows through a 2-in.-diameter pipe with a mean velocity of 5 ft/s. Determine the value of the Reynolds number Take density = 1.77 (slugs/ft³) and dynamic viscosity = 8.0x10-3 (lb.s/ft²)
A calibration test of a 15-mm diameter circular sharp-edged orifice in a vertical side of a large tank showed a discharge of 760 N of water in 60 seconds at a constant head of 6.50 m. Measurement of the jet showed that it traveled 3.20 m. horizontally while dropping 450 mm. Compute for the nearest value of the coeficient of discharge. O 0.60724 O 0.67240 O None of the above O 0.64702 O 0.64027
An open cylindrical vessel having a height equal to its diameter is half filled with water and revolved about its own vertical axis with a constaat angular speed of 130 rpm. Find its minimum diameter so that there can be no liquid spilled. Unit of the Correct Answer: meter O 2.43 0.423 O 0.342 O 0.234
An open circular vessel is 1m in diameter and 2m height. It contains water filled to a depth of 1.5m. If the cylinder rotates about its vertical axis, what constant angular velocity can be obtained without spilling? Unit of the Correct Answer: rad/sec Decimal Places required in the final answer: 3 PLS 3 DECIMALS..
When the accumulated liquid along the bottom of the pipe or in a well reaches a certain level and "plugs" the pipe, the higher velocity gas gets blocked. Select one: O True O False
II. Typically, the length (or height) of a portable cylindrical liquid container is longer than its diameter. In determining its thickness, the cylinder must be considered in a vertical position. Why?
Q3: A pitot-static tube is used to measure the flow velocity of turpentine flowing in a pipeline if the manometer reading is 8 cm of mercury, calculate the average velocity, pressure drop, and volumetric flow rate at that point in the pipe line. Also evaluate Reynold number for turpentine and which type of flow in the pipe. Ph J Re Density of turpentine is 850 kg/m³, density of mercury is 13600 kg/m³, cv = 1, D=10 cm, turpentine 0.001375 and 0 = 45°. =
1. A venturi meter is introduced in a 300 mm diameter horizontal pipeline carrying a liquid under a pressure of 150 kPa. The throat diameter of the me-ter is 100 mm and the pressure at the throat is 400 mm of mercury below atmosphere. If 3% of the differential pressure is lost between inlet and thethroat, determine the flow rate of the pipeline and draw the figure.
In a given setup, distilled water flows towards the inside and goes outside of the vessel as shown in the figure. What is the rate of change of the water's mass (dm/dt) in the vessel? 3 in. Q = 0.3 ft3/sec V = 30 ft/sec Device m = 0.3 slug/sec %3D
A 10 cm diameter solid cylinder of height 10 cm weighing 0.40 kg is immersed in a liquid (800 kg/cm^3) contained in a tall metal cylinder having a diameter of 13 cm. Before immersion, the liquid was 8 cm deep. At what level from the bottom will the solid cylinder float? W. = 0.40kg %3D 10cmo tank New L.S. Original L.S. F.
(a) how many pounds of lead weighing 700lb/ft^3 must be fastened to the outside bottom to make the cylinder float vertically with 3ft submerged? (b) how many pounds of lead if placed inside the cylinder? answer in complete , 3 decimals and with diagrams
A submarine is 109.36 yards. The shape of its hull is roughly cylindrical with a diameterof 15m. When it is submerged, it cruises at a speed of about 40 knots or approximately20m/s. Compute Reynold’s number, if the viscosity is 0.01 Poise.