A student has a mixture of two possible compounds. The student performs recrystallization to separate the two compounds. The student decides to identify the separated compound by melting point. The student observes that their isolated compound does not melt. The start temperature was 150 °C and the end temperature was 230 °C with a ramp rate of 2 °C/min. The student's partner believes that they isolated compound 2, while the student thinks they have compound 1. Choose the best answer to go with this scenario. Compound 1 Literature Melting point: 204 °C Compound 2 Literature Melting point: 188 °C

Q: A solution is saturated at 25oC . It is then slowly cooled to 20oC with no change to the appearance…

A:

Q: What is the function of a desiccant in a set-up of volatilization gravimetry?   To remove nitrogen…

A: Volatilization gravimetry is a technique used to separate the components of the mixture by heating…

Q: An ideal solvent to use for recrystallization is one that: Group of answer choices dissolves the…

A: Recrystallisation process is one of the very important method use to separate the pure compound from…

Q: At 1 atm, a mixture of octane and methylbenzene boils at 135.8 degrees Celsius with a composition of…

A: We need to plot the boiling point-composition diagram for the octane-methylbenzene system.

Q: A 7.2g sample of potassium chloride is dissolved in 100g of water at 65*C. The solution is cooled to…

A: Solubility Vs Temperature graph of different salts

Q: Which type of distillation is used for miscible liquids with very small gap of boiling temperature?…

A:

Q: What would we do if the melting point range were wide? Assume that the product that has formed is…

A: 4 statements are given . One statement is correct out of these 4 statements . We have to choose that…

Q: s the water of crystallization a chemical constituent of the salt where it is present?  What proves…

A: Some salts are present as hydrated form and some are in anhydrous form.

Q: A student takes the following steps during an experiment: Measure 15mL concentrated HCl (student…

A: Possible source of error that may have contributed to the student's disappointing yield: 1. May be…

Q: After water and benzene are mixed, we see two layers. A True False

A: After water and benzene are mixed, we see two layers.   This is a True statement.

Q: A glass plummet weighs 15 grams in air. When immersed in water, it weighs 8.5 g. When immersed in…

A: Given the mass of plummet in air, mair = 15 g  Mass of plummet in water, mwater = 8.5 g  Mass of…

Q: Use a temperature-composition diagram to explain why fractional distillation of two components is…

A:

Q: One of the problems that can be encountered in recrystallization is the failure of the solute to…

A: The reason for failure of the solute to crystallize during a recrystallization is needed to be…

Q: The question is:   A student preforms a crystallization on an impure sample of biphenyl. The sample…

A: Benzene is a very bad solvent to use to recrystallize biphenyl.If the solubility properties of two…

Q: In 2017, the atmospheric mixing ratio of CO2 is approximately 410 ppmv. In order to bring the…

A: Parts per million by volume is denoted as ppmv. It is given that 1 ppmv of CO2 = 2184.82 Tg…

Q: Why the temperature in the thermometer go up and down in distillation for multi component compound?

A: Solution :     Distillation is a separating technique for the different compounds by vaporization…

Q: 1. An organic student did an experiment extracting benzoic acid from a mixture of other organic…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 1. Because carbon tetrachloride (CC14) is not soluble in water, a test tube containing the two…

A: The density of carbon tetrachloride (CCl4) and water (H2O) are 1.59 gm/ml and 0.997 gm/ml means…

Q: 2. How would each of the following procedural errors affect the results to be expected in this…

A: Hello. Since the question contains multiple subparts, the first three subparts are solved. In case…

Q: Which type of distillation set-up is appropriate for the given condition? Stable component of…

A:

Q: Determine ΔT (T1 – T2), where T1 is the melting point of pure lauric acid and T2 is the melting…

A: We need to calculate the temperature difference for the solution of lauric acid and Benzoic acid…

Q: 6) If the pressure on a liquid is changed from 200 kpa to 300 kpa, the temperature at which the…

A: 6) If the pressure on a liquid is changed from 200kpa to 300kpa, the temperature at which liquid…

Q: Which of the following refers to a composition in which its components cannot be separated by…

A: Distillation :- It is a method of separation of mixture of liquids based on their difference in…

Q: Never heat the mixture until the distillation flask is dry as this may cause an explosion.  True…

A: Distillation is separation process.

Q: Assess the following statements about fractional distillation. Determine which are TRUE/FALSE…

A: 1. If the samples are of close boiling point we can seperate by using fractional distillation and ni…

Q: ways to separate diesel to a liquid mixture and its step by step process

A: Mixtures of liquid can be separated by different ways three of them are stated below; 1.…

Q: See attached problem

A: Recrystallization is a technique used to purify chemicals. Recrystallization, also known as…

Q: Determine each statement if it describes dissolution or disintegration.   It is mainly affected by…

A: Dissolution means the disove of substances in different solvents. It is applicable for solids,…

Q: coffee cup calorimeter was used to measure the heat of solution, the change in enthalpy that occurs…

A:

Q: Which of the following statements is true when considering temperature during a recrystallization?…

A: For crystallization, it is important to prepare a saturated solution of the sample in minimum amount…

Q: MAKE A FLOWCHART/SCHEMATIC DIAGRAM Procedure: Place 20 drops of each of 0.2M CuSO4 in a centrifuge…

A: A flowchart is a diagrammatic representation of process in sequential steps.  In this flowchart…

Q: Simple Distillation The temperature was 76o C when the first drop of distillate was collected.…

A: Distillation is a method to separate miscible liquids at different temperatures.

Q: Describe the characteristics that a crystal obtained through recrystallization must have, the final…

A: Recrystallization is basically a purification technique. Recrystallization is a process in which the…

Q: What are the purposes of the following in recrystallization of solids?  I) boiling stones – II)…

A: The addition of seed crystals leads to create nucleation sites which help in forming crystals. The…

Q: All of the following is true about crystallization EXCEPT * A common practice is to dissolve the…

A: Ans. Crystallization is the process of obtaining the pure crystals of the sample from the sample…

Q: Saturated steam at 232 ° C is used to sterilize a liquid solution. The temperature of the process…

A: At 232°C for steam,         λs=1803,57 kJ/kg Given that, it can be assumed that the liquid solution…

Q: Explain the principle behind vacuum distillation.

A: Vacuum distillation is one of the processes that made industrial wastewater reusable. In this…

Q: A rubbing alcohol sample composed of 60% isopropyl alcohol and water was distilled using a simple…

A: The process of distillation is is inspired by nature. In this process, liquid is heated to form a…

Q: The distillation flask is best     completely filled with mixture   as large as available…

A: At the beginning of the distillation, the distillation pot should be between one-half full and…

Q: Based on the data below, which explanation BEST explains what state of matter the compound being…

A: In cases of gases solubility of gases in liquid increases with increase in pressure while solubility…

Q: Based on the melting point of your impure solid, you look at the given samples and believe you have…

A: Recrystallization is used to purify compound. It is based on the fact that the solubility of a…

Q: Discuss the basic principles of the two distillation operations. Explain the difference of the…

A: 1) The two types of distillation operations are, Simple distillation Fractional distillation…

Q: One gram of caffeine dissolves in 55 ml of water, 7 ml of dichloromethane (DCM), 530 ml of diethyl…

A: The solubility of a compound in a solvent depends on the type of compound and the solvent. Polar…

Q: A 532 mg of a mixture of fluorene and benzoic acid was weighed out and subjected to an extraction…

A: After purification, Mass of fluorene=174 mg Mass of benzoic acid=249 mg Total mass after…

Q: Only water or dilute aqueous solution or non toxic chemicals may be disposed of down the drain with…

A: true

Q: What do you call the process wherein a newly-formed precipitate is subjected at elevated temperature…

A:

Q: A lower and/or broader melting point range for a compound after recrystallization most likely…

A: The temperature, at which the physical state of the substance changes from solid to liquid, when the…

Q: An ideal property of a solvent to be suitable for recrystallization of a solid sample is: Group of…

A: In recrystallization process an impure solid compound is dissolved (the impurities must also be…

Q: Draw a BFD for a desalination process. This process will vaporize water and condense the vapour to…

A: desalination the process in which the minerals are removed from seawater. combination of…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.