A steel ring with a 2.5000-in. inside diameter at 20°C is to be warmed and slipped over a brass shaft with a 2.5020-in. outside diameter at 20°C. (a) to what temperature should the ring be warmed? (b) if the ring and the shaft together are cooled by some means such as liquid air, at what temperature will the ring just slip off the shaft?

A steel ring with a 2.5000-in. inside diameter at 20°C is to be warmed and slipped over a brass shaft with a 2.5020-in. outside diameter at 20°C. (a) to what temperature should the ring be warmed? (b) if the ring and the shaft together are cooled by some means such as liquid air, at what temperature will the ring just slip off the shaft?

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter18: Temperature

Section: Chapter Questions

Problem 13P

See similar textbooks

Similar questions

The thermal conductivities of human tissues vary greatly. Fat and skin have conductivities of about 0.20 W/m K and 0.020 W/m K, respectively, while other tissues inside the body have conductivities of about 0.50 W/m K. Assume that between the core region of the body and the skin sin face lies a skin layer of 1.0 mm, fat layer of 0.50 cm, and 3.2 cm of other tissues. (a) Find the R-factor for each of these layers, and the equivalent R-factor for all layers taken together, retaining two digits. (b) Find the rate of energy loss when the core temperature is 37C and the exterior temperature is 0C. Assume that both a protective layer of clothing and an insulating layer of unmoving air a absent, and a body area of 2.0 m2.
The height of the Washington Monument is measured to be 170.00 m on a day when the temperature is 35.0 . What will its height be on a day when the temperature falls to -10.0 ? Although the monument is made of limestone, assume that its coefficient of thermal expansion is the same as that of marble. Give your answer to five significant figures.
An aluminum rod 0.500 m in length and with a cross sectional area of 2.50 cm2 is inserted into a thermally insulated vessel containing liquid helium at 4.20 K. The rod is initially at 3(H) K. (a) If one-halt of the rod is inserted into the helium, how many liters of helium boil off by the time the inserted half cools to 4.20 K? Assume the upper half does not yet cool, (b) If the circular surface of the upper end of the rod is maintained at 300 K. what is the approximate boil-off rate of liquid helium in liters per second after the lower half has reached 4.20 K? (Aluminum has thermal conductivity of 3 100 YV/m K at 4.20 K; ignore its temperature variation. The density of liquid helium is 125 kg/m3.)
A high-end gas stove usually has at least one burner rated at 14 000 Btu/h. (a) If you place a 0.25-kg aluminum pot containing 2.0 liters of water at 20.C on this burner, how long will it take to bring the water to a boil, assuming all the heat from the burner goes into the pot? (b) Once boiling begins how much time is required to boil all the water out of the pot?
At 25.0 m below the surface of the sea, where the temperature is 5.00C, a diver exhales an air bubble having a volume of 1.00 cm3. If the surface temperature of the sea is 20.0C, what is the volume of the bubble just before it breaks the surface?
One easy way to reduce heating (and cooling) costs is to add extra insulation in the attic of a house. Suppose a single-story cubical house already had 15 cm of fiberglass insulation in the attic and in all the exterior surfaces. If you added an extra 8.0 cm of fiberglass to the attic, by what percentage would the heating cost of the house drop? Take the house to have dimensions 10 m by 15 m by 3.0 m. Ignore air infiltration and heat loss through windows and doors, and assume that the interior is uniformly at one temperature and the exterior is uniformly at another.
An astronaut performing an extra-vehicular activity (space walk) shaded from the Sun is wearing a spacesuit that can be approximated as perfectly white ( e=0 ) except for a 5 cm × 8 cm patch in the form of the astronaut's national flag. The patch has emissivity 0.300. The spacesuit under the patch is 0.500 cm thick, with a thermal conductivity k 0.0600 W/m , and its inner surface is at a temperature of 20.0 . What is the temperature of the patch, and what is the rate of heat loss through it? Assume the patch is so thin that its outer surface is at the same temperature as the outer surface of the spacesuit under it. Also assume the temperature of outer space is 0 K. You will get an equation that is very hand to solve in closed form, so can solve it numerically with a graphing calculator, with software, or even by trial and error with a calculator.
A construction worker uses a steel tape to measure the length of an aluminum support column. If the measured length is 18.700 m when the temperature is 21.2C, what is the measured length when the temperature rises to 29.4C? Note: Dont neglect the expansion of the tape.
At 22°C, an aluminum ring has an inner diameter of 6.000 0 cm and a brass rod has a diameter of 6.040 0 cm. (a) If only the ring is warmed, what temperature must it reach so that it will just slip over the rod?(b) If both the ring and the rod are warmed together, what temperature must they both reach so that the ring barely slips over the rod?
A homeowner is unhappy with her heating costs. One wall of her house is 4 meters tall and 8 meters wide and has no windows, and it is made of brick and mortar with a thermal conductivity of 1.0 W m K . It is 40 cm thick. The house is heated to a temperature of 20 ◦C inside. (a) What is the rate of heat loss through the wall on a day when it is 0◦C outside? (b) A layer of rock mineral wool, which has a thermal conductivity of 0.032 W m K is to be installed on the interior surface of the brick wall. How thick should the layer be to lower the rate of heat transfer through this wall to half its original value? (c) If the rock mineral wool is instead installed on the outer surface, is the thickness required the same?
A steel ring of 3.000 cm inside diameter at 20°C is to be heated and slipped over a brass shaft measuring 3.002 cm in diameter at 20°C. After being heated to the desired temperature. the ring and shaft together are cooled by some means such as liquid air, at what temperature will the ring just slip off the shaft?
A solid plate, with a thickness of 15 cm and a thermal conductivity of 80 W/m∙K, is being cooled at the upper surface by air. The air temperature is 10°C, while the temperatures at the upper and lower surfaces of the plate are 50 and 60°C, respectively. Determine the convection heat transfer coefficient of air at the upper surface and discuss whether the value is reasonable or not for force convection of air.