A sphere is 50 mm mean diameter with a wall 0.5 mm thick. It has an inside pressure of 0.5 MPa greater than the outside pressure. Calculate the change in volume. Take E = 212 GPa and V = 0.25 (Note: Provide answer with at least two decimal places. (the answer is in cubic millimeter, mm³)

Q: A relatively thin disc with uniformly distributed mass is mounted on a shaft which rotates at 1000…

A: Draw the location of correction mass measured from y-axis.

Q: As shown, a frictionless pulley hangs from a system of springs and a cable. The pulley is…

A:

Q: P₁ 3 m E B P₂ -3m- D 4 m c

A:

Q: 2.19 Consider a 300 mm x 300 mm window in an aircraft. For a temperature difference of 80°C from the…

A:

Q: How many stages of compression are required to produce a pressure ratio of stages of AT, = 50°C…

A: Givenrp=24∆Tt=50°Cec=0.9

Q: The driver of a truck has an acceleration of 0.65g as the truck passes over the top of a hump in the…

A:

Q: Write about of the following related to shell and tube heat exchanger: (i) Tube sheet and tube pitch…

A: Given Shell and tube exchanger To find Relation Tube sheet and tube pitch Baffle and baffle spacing…

Q: 11. The pressure of a boiler is 9.5 kg/sq. cm. The barometric pressure of the atmosphere is 768 mm…

A: Given data: PBoilerGauge=9.5 kg/cm2PAtm=768 mm of Hg Need to determine the absolute pressure in the…

Q: (b) An experimental balloon filled with helium is equipped with meteorological instruments is…

A:

Q: Example of Vibration System Analysis. Include appropriate model and complete label for mass,…

A: Dear Students Example of Vibration system analysis is given in below-

Q: find an appropriate dimensionless

A:

Q: 4. An open-ended can 1 ft long is originally full of air at 70°F. The can is now immersed in water,…

A: Given data: Heiht of can (h)=1 ftDepth of can (d)=10 ft Need to determine the height of water inside…

Q: 14. What is the pressure 2000 m below the surface of the ocean is SI Units The specific gravity of…

A: Given:  h = 2000 m Specific gravity (S) = 1.025 Hence density of ocean water = 1.025 x 1000 = 1025…

Q: a) Distinguish between the characteristics of the two instruments in Fig. Q2(a). You may present…

A: Given questions are related to robotics engineering.

Q: 2/208 Cylinder B has a downward velocity of 0.6 m/s and an upward acceleration of 0.15 m/s².…

A: We have to slove above questions Determine the velocity and acceleration of block A

Q: minimum damping coefficient such that there is no oscillation

A:

Q: Q.6. For the figure shown below : A) Determine the location (Xe, ye) of the centroid C of the shaded…

A: For the given figure, we have to find : A) The location of the centroid C of the shaded areaB) The…

Q: On a warm summer day, a large mass of air (atmospheric pressure 1.01 x 105 Pa) is heated by the…

A: Given data: Atmospheric pressure = P1 =  1.01 x 105 Pa Initial temperature = T1 = 30°C = 30 + 273 K…

Q: A uniform tube is used to siphon water from the large tank. If the pressure on the outside of the…

A:

Q: QI A steam power plant that operates on a regenerative Rankine cycle and has a net power output of…

A: given; net power output(wnet)=175MW

Q: approximated 101.325 (1 1-110 The average atmospheric pressure on earth is as a function of altitude…

A: Given data: Patm=101.3251-0.02256z5.256 Need to determine the atmospheric pressure at Atlanta,…

Q: 16. A water tank of 18 ft wide, 14 ft long and 4 ft high, calculate the pressure at the bottom of…

A:

Q: A-Given that the volumetric flow rate for a fluid within a circular cross-section tube can be…

A: Given:Volumetric flow rate for a fluid within a circular cross-section tube, Q=π r4 ∆P8 μ LLength of…

Q: What is the proper amount of belt deflection, and what tool is used to determine the amount of belt…

A: ■ The proper amount of belt deflection is 1" (1 inch) for every 64" (64 inch) length of the belt.…

Q: n object of mass 2 kg is attached to a spring of stiffness 200 N / m on a horizontal frictionless…

A: Frequency is given by,ω=kmω=2002ω=10 radian/s

Q: Determine the Resultant of the forces acting on the T-BAR structure.

A:

Q: Determine the equivalent spring stiffness constant of the following spring in series and parallel.…

A: For the given system of springs, we have to calculate the equivalent spring stiffness constant.…

Q: Derive an expression for the thermal resistance for one-dimensional heat conduction through a…

A: It is very basic question of heat transfer. Topic: one dimensional heat conduction through spherical…

Q: Q2. Calculate the allowable stress (reliability of 99%) on the swing joint using strength data…

A: Given data: Mean ± Standard deviation from testing = 170 ± 20 MPa We calculate the allowable stress…

Q: ᴛᴡᴏ ᴘʟᴀᴛᴇꜱ ᴀʀᴇ ꜰᴀꜱᴛᴇɴᴇᴅ ʙʏ ᴀ ʙᴏʟᴛ ᴀɴᴅ ɴᴜᴛ ᴀꜱ ꜱʜᴏᴡɴ. ᴛʜᴇ ɴᴜᴛ ɪꜱ ᴛɪɢʜᴛᴇɴᴇᴅ ᴛᴏ ᴘʀᴏᴅᴜᴄᴇ ᴀ ᴛᴇɴꜱɪʟᴇ ʟᴏᴀᴅ…

A:

Q: Find the forces at points A and B. C = 300 lb-ft R = 150 lb 4 ft. A 3 ft. B

A:

Q: A substance weighs 2 lbs in air and 1 lb in water. What is its weight in the moon if it is…

A: given data- weight of the substance in air on the earth w = 2 lbs acceleration due to gravity on the…

Q: 3) Two circular shafts (shown in Figure) made of the same material and have the same length are…

A:

Q: Determine the response of a system with a degree of freedom to an F impulse for the following data:…

A: Write the expression of motion of mass-spring-damper system. md2xdt2+cdxdt+kx=Fsinωt

Q: Q6/ In the mechanism shown in Fig. below, the crank AB is 75 mm long and rotate uniformly clockwise…

A: Given: Lets consider the given, Length of the link, AB=75 mm Length of BD=BC=DC=DE=300 mm Scale 0.1…

Q: Neglect friction, determine the natural frequency of the system: L/2 www L k L/2 W2

A: For solution refer below images.

Q: A metal tank wheel in the shape of a disc of radius R is lightened by cutting out six identical…

A: Given question: A metal tank wheel in the shape of a disc of radius R is lightened by cutting out…

Q: B- What the deference between particle imaging velocimetry and laser doppler velocimetry with…

A:

Q: 2. What is the moment of Inertia of the following cross section. Please give the moment of inertia…

A: Given

Q: Q5: For simply supported beam AB shown in Fig.(5), find the value of L so that absolute maximum…

A:

Q: How can you express the equations of compatibility?

A: Given question : How can you express the equations of compatibility?

Q: If block B has a leftward velocity of 1.2 m/s, deter- mine the velocity of cylinder A. Ans. UA 0.4…

A:

Q: 4/35 Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium…

A:

Q: A mass of 0.10 slug in space is subjected to an external vertical force of 4 lb. If the local…

A: given; mass(m)=0.10slugexternal vertical  force(F)=4lbgravity acceleration(g)=30.5fps2lets take…

Q: Determine the equivalent spring stiffness constant of the following spring in series and parallel.

A: Given: The stiffness of springs is 250 N/m, 175 N/m and 80 N/m.

Q: The Reynolds number is defined for a pipe as (velocity· diameter· density) / viscosity. What is the…

A:

Q: SITUATIONAL PROBLEM I: A composite wall constructed of 2.5 cm of steel (k= 60.5 W/m-K) and 5.0cm of…

A: Given data:- The thickness of the steel sheet ts= 2.5 cm or 0.025 m and the thermal conductivity of…

Q: 8-137. The three stone blocks have weights of W, 600 16, Wa 150 lb, and We- 500 th Determine the…

A:

Q: If K= 2.2 GPa is the bulk modulus of elasticity for water, what pressure is required to reduce a…

A: Given data : Percentage reduction in volume=∆VV Bulk modulus=K     Required : Pressure

Q: A cylindrical part of diameter d is loaded by an axial force P. This causes a stress of P/A, where A…

A: Given dat as per questionUncertainity in load=±11%Uncertainity in daimeter=±5%Uncertainity in…

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.