Answered: A solution is prepared by mixing 145 mL…

A solution is prepared by mixing 145 mL of 0.800 M NH3 and 130 mL of 0.800 M HCI. Assuming that the volumes are additive, what is the pH of the resulting mixture?

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter13: Acids And Bases

Section: Chapter Questions

Problem 32QAP: What is the pH of a solution obtained by mixing 235 mL of NaOH with a pH of 11.57 and 316 mL of...

See similar textbooks

Related questions

Q: How to classify the ionic compounds according to the mole ratio between the cation and anion?

A: An ionic compound is made up of ions that form charged particles when an atom gains or loses…

Q: Problem 7.6 Show how the synthetic scheme in Example 7.6 might be modified to give the following.…

A: Solution:7.6 Solution:a) To modify the synthetic scheme in Example 7.6 to give 1-heptanol, the…

Q: 10. (3 pts) Draw the most likely mechanism for each of the following transformations: a. NO₂ b. Br…

A: 1: This is an aromatic nucleophilic substitution. rate of nucleophilic aromatic substitution the…

Q: 1,000,000- y Ice, CO₂(s), does not melt or freeze at atmospheric pressure. It sublimes and deposits…

A: The objective of the question is to find the lowest pressure (in kPa) at which will condense to…

Q: Payalben

A: The objective of the question is to estimate the concentration of E. coli bacteria at the end of the…

Q: K Problem 29 of 34 Submit Draw the products of the four step reaction sequence shown below. Ignore…

A: Friedel crafts acylation occurs in the 1st step then the product of friedel craft acylation…

Q: Predict the major product of the following reaction: OH Na2Cr2O7 H2SO4, H₂O ? ○ There is no…

A: Step 1:The reagent combination Na2Cr2O7, H2SO4, and H2O is commonly known as chromic acid. It is a…

Q: 3) Draw equations of the following reactions and and explain to which direction is the respective…

A: Approach to solving the question:

Q: Assessment 8.50 Predict the products you would get when the following alkenes react under the…

A: Step 1: Step 2: Step 3: Step 4:

Q: A certain half-reaction has a standard reduction potential Ered = -0.08 V. An engineer proposes…

Q: how to make the compound on the right from the compound за on the left igh

Q: hello, can you please this according to chemical kinetics?

A: t(min)CA (mol/L)02.00101.00300.50400.40700.25Step 1: Plot this CA vs. time relationship. This will…

Q: Calculate: A. Total Hardness of water as CaCO3 B. ppm of Ca and Mg

A: Volume of sample = 100 mLConcentration of EDTA = 0.010 MVolume of EDTA used when EBT is used as…

Q: Use the following Lewis diagram for ethyl methyl ether to answer the questions: H- H H H + H -H 1 2…

A: Step 1: Step 2: Step 3: Step 4:

Q: None

A: Step 1:

Q: The maximum level of lead allowed in drinking water is 15 mg/kg. What is this concentration in units…

A: The objective of the question is to convert the concentration of lead in drinking water from…

Q: The solubility of Fe(OH)2 is measured and found to be 1.15×10-3 g/L. Use this information to…

A: The objective of this question is to calculate the solubility product constant (Ksp) for iron(II)…

Q: Identify the major product. A B AICI 3 ہے C D

Q: 0.0020 moles of benzaldehyde was used along with 0.0010 moles of acetone. A 2:1 molar ratio. This…

A: The objective of the question is to determine the theoretical yield of a chemical reaction involving…

Q: What is the name of this structure?

A: Step 1: Step 2: Step 3: Step 4:

Q: Give the major organic product(s) 4. CH3 CH3 HBr

Q: An analytical chemist is titrating 228.8 mL of a 0.6100M solution of hydrazoic acid (HN3) with a…

Q: None

Q: If we start with 5.2 g of Benzoic acid, calculate the minimum amount of acid to fully protonate…

A: Protonate of Benzoate to Benzoic Acid Addition of a proton (H⁺) to the benzoate ion, so the…

Q: Highlight each of the positions on the benzene ring that you expect will be most likely to react by…

A: In electrophilic aromatic substitution, the position at which the benzene reacts is based on the…

Q: Which of the following describes a metallic substance? A tightly packed lattice of positively and…

A: The objective of the question is to identify the correct description of a metallic substance among…

Q: The great expert Hand written solution is not allowed.

A: Step 1:Step 2:

Q: 22. The first-order decomposition of N2O5 at 328 K has a rate constant of 1.70 × 10-3 s¹. If the…

Q: A buffer solution is 0.341 M in CH3COOH and 0.270 M in CH3COONa. If Ka for CH3COOH is 1.8x 10^-5 ,…

A: The objective of this question is to calculate the pH of a buffer solution. The buffer solution is a…

Q: None

A: Step 1:This is a subsitution reaction. Br is a good leaving group. We also have a primary alkyl…

Q: By titration, it is found that 62.5 mL of 0.176 M NaOH(aq) is needed to neutralize 25.0 mL of…

A: Step 1:To find the concentration of the HCl solution, we can use the equation for neutralization…

Q: A multivitamin sample has a label claim of 500 mg ascorbic acid (176.12 g/mol). According to quality…

A: The objective of the question is to identify the expiration date.

Q: A 23.0-liter gas cylinder contains 8.6 moles of nitrogen gas and 1.6 moles of oxygen gas. If the…

A: We can find the total pressure inside the cylinder using the ideal gas law. Ideal Gas LawThe ideal…

Q: b. Explain why alkylation of 2-ethylcyclohexanone at different temperatures results in different…

A: Strong and bulky bases like LDA preferentially form less substituted enolate because they remove…

Q: Calculate the volume percent of solute in each of the solutions. A solution made by adding 20.1 mL…

A: Number 1:Given:volume of solute = 20.1 mlvolume of solution = 485 mlFormula:the volume percentage of…

Q: After heating a solution of allyl tert-butyl sulfide and sodium ethoxide in ethanol for several…

A: In general, compounds are said to be acidic if they easily release hydrogen ions…

Q: Arrange the following from lowest to highest entropy: H2O (l) , H2O2 (l), H2O (g) , CuO (s). Assume…

A: The objective of the question is to arrange the given substances in the order of increasing entropy.…

Q: Which type of intermolecular force is the WEAKEST? dipole-dipole interaction hydrogen bond…

A: The question is asking us to identify the weakest type of intermolecular force among dipole-dipole…

Q: The following data were recorded from an experiment to measure the activity of a peptidase enzyme. A…

A: To determine the maximum velocity (Vmax) and Michaelis constant (KM) for an enzyme-catalyzed…

Q: Given Steps step solution

A: Protonation occurs in the first step and by this electrophilicity of the electrophilic centre…

Q: PhO Q. 2 Propose structures for A and B and mechanisms for the following transformations. Pho A [A]…

A: The objective of the question is to propose the structures for compounds A and B and the mechanisms…

Q: The enthalpy of vaporization of Substance X is 18.0- and its normal boiling point is -93. °C.…

A: Step 1: Convert the initial and final temperatures from °C to Kelvin.Step 2: The relation between…

Q: The IUPAC name for the compound shown is Save for Later Submit Answer

Q: Be sure to answer all parts. In a first-order decomposition reaction, 50.0% of a compound decomposes…

A: Given,50.0% of a compound decomposed in 18.5 minutes.Thus, half-life (t1/2) = 18.5 min

Q: Based on your ICE table (Part 1) and the definition of Ka, set up the expression for Ka in order to…

Q: 1. Some commercial hydrogen peroxide products used as alkali metal oxalate or phosphate stabilizers.…

A: The objective of the question is to tell how alkali metal oxalate or phosphate stabilizers affect…

Q: analyte minimum concentration maximum concentration slope (A/C) uncertainty Caffeine 0.153 0.5067…

A: Uncertainty is the measurement of error in the graph.It can be calculated by the formula:Given Data:…

Q: 25 26 27 28 29 3 8 3.5 4 4.5 8 288 401 8 201 20 10 5 4. Molecular weight = 86; with 10 MICRONS 5.5 6…

A: Rule of thirteen is a simple mathematical calculation which can be used to determine the molecular…

Q: Assuming that the dipole moment of a molecule is zero in its electronic ground state (S0) and is µ…

A: The objective of the question is to find the the time evolution of the fluorescence spectrum…

Q: Part A The standard Gibbs free energy of formation of (a) Co(s) (b) Cl2(g) (c) Cr(s) (a) only (b)…

A: Step 1: Step 2: Step 3: Step 4:

Question

Payalben

A solution is prepared by mixing 145 mL of 0.800 M NH3 and 130 mL of 0.800 M HCI. Assuming that the volumes are additive, what is
the pH of the resulting mixture?

AI-Generated Solution

AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.

Unlock instant AI solutions

Tap the button
to generate a solution

Click the button to generate
a solution

SEE SOLUTION

Similar questions

A student prepares 455 mL of a KOH solution, but neglects to write down the mass of KOH added. His TA suggests that he take the pH of the solution. The pH is 13.33. How many grams of KOH were added?
. Using Fig. 16.3, list the approximate pH value of live “everyday” solutions. How do the familiar properties (such as the sour taste for acids) of these solutions correspond to their indicated pH?
Why have chemists not tabulated the fraction ionized for different acids? Such a table would make problems such as calculating the pH of an acid solution quite simple.
The weak base, CIO (hypochlorite ion), is used in the form of NaCIO as a disinfectant in swimming pools and water treatment plants. What are the concentrations of HCIO and OH and the pH of a 0.015 M solution of NaCIO?
What is the pH of a solution obtained by mixing 235 mL of NaOH with a pH of 11.57 and 316 mL of Sr(OH)2 with a pH of 12.09? Assume that volumes are additive.
You are asked to determine whether an unknown white solid is acidic or basic. You also need to say whether the acid or base is weak or strong. You are given the molar mass of the solid and told that it is soluble in water. Describe an experiment that you can perform to obtain the desired characteristics of the white solid.
. Write the formulas for three combinations of weak acid and salt that would act as buffered solutions. For each of your combinations, write chemical equations showing how the components of the buffered solution would consume added acid and base.
How many grams of HI should be added to 265 mL of 0.215 M HCI so that the resulting solution has a pH of 0.38? Assume that the addition of HI does not change the volume of the resulting solution.
Consider two weak acids, HA (MM=138g/mol)and HB (MM=72.0g/mol). A solution consisting of 11.0 g of HA in 745 mL has the same pH as a solution made up of 5.00 g of HB in 525 mL. Which of the two acids is stronger? Justify your answer by an appropriate calculation.
A 1000.-mL solution of hydrochloric acid has a pH of 1.3. Calculate the mass (g) of HCl dissolved in the solution.
For oxyacids, how does acid strength depend on a. the strength of the bond to the acidic hydrogen atom? b. the electronegativity of the element bonded to the oxygen atom that bears the acidic hydrogen? c. the number of oxygen atoms? How does the strength of a conjugate base depend on these factors? What type of solution forms when a nonmetal oxide dissolves in water? Give an example of such an oxide. What type of solution forms when a metal oxide dissolves in water? Give an example of such an oxide.