- A solar energy installation utilize a three – phase bridge converter to feed energy into power system through a transformer of 400 V/400 V, as shown below. The energy is collected in a bank of 400 V battery and is connected to converter through a large filter choke of resistance 10 N.

- A solar energy installation utilize a three – phase bridge converter to feed energy into power system through a transformer of 400 V/400 V, as shown below. The energy is collected in a bank of 400 V battery and is connected to converter through a large filter choke of resistance 10 N.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.10P: A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding...

See similar textbooks

Related questions

Q: SS 4-27 For the circuit in Figure P4-27: (a) Find vo in terms of us. (b) Find io for us = 1 V.…

A: Given Data: An Op-Amp circuit with, Output voltage = v0 Input voltage = vs Load Resistor RL=22 kΩ…

Q: Consider a GaAs LED with a refractive index of 3.66. The LED's surface is coated with a dielectric…

Q: (a) Option 1:- Given that the precision temperature sensor produces an output voltage (V, : sensor…

A: Given data Vs=11.69 mVT°C+1.8663 V T=Vs-1.8663/0.01169 When, T=0°C, Vo=0 V T=100°C, Vo=10 V To find…

Q: In the circuit shown, the component values are: C = 100nF, L = 10μH, and R₁ = R₂ = 10. The two…

Q: 6) In the circuit below is the LED on or off? 12V + T 10000 1000 N-Mosfet

Q: The following sets of values for voltage and current i pertain to the circuit seen in (Figure 1).…

A: We need to find out the power for for given current and voltage for given circuit.

Q: i) Draw an RC phase shift oscillator What are the sensitive arms frequencies? Write the oscillation…

A: According to the question, we need to i) Draw an RC phase shift oscillator. What are the sensitive…

Q: For the circuit shown in Figure 1(a), calculate the voltage across the 4 2 resistor using the…

A: We need to find out the voltage across given resistor in the given circuit by using of superposition…

Q: Draw the differential-mode and common mode half-circuits for the differential

Q: Consider the following step up converter with a resistive load of value R=5 ohms. It is supplied by…

A: In this question we need to choose a correct option.

Q: + Vtest i'test B' E' Bib E TT + Ube + ve Im Vbe RE ic C C' E + v'out E'

Q: Find (t) for t> 0 for the circuit given below. Let w = ✓LC

A: For the given parallel RLC circuit the value of voltage across the capacitor needs to be calculated…

Q: For a certain electrical circuit the applicable differential equation is 100(d2i/dt2) + 200(di/dt)+…

A: Type of control system Open loop control system Closed Loop control system

Q: So what is the connection between solar cells and GPS?

A: Global Positioning Systems: Global Positioning Systems (GPS) is a satellite-based navigation system…

Q: The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 46…

Q: A four-pole induction motor drives a load at 2478 rpm. This is to be accomplished by using an…

A: speed of the induction motor Nr = 2478 rpm dc voltage V = 400 V number of poles P= 4 slip =…

Q: Find the Norton equivalent of the circuit. R₁ www + R₂ www www R3 wwww RA

Q: When a sinusoidal voltage with an effective value of 5V is applied to the circuit below, find the…

A: Input voltage is sinusoidal. (Vin)rms= 5 v. We need to evaluate the total current drawn from source…

Q: Find the impulse response h[n] for the filter below. -IT 2 3 --A 2 2 3″ <--1 - IL 2 H(ej®) 1 RIN 2 2…

Q: (a) Use the characteristic equation for the gated D latch to implement a two-level, NAND-gate…

A: SOLUTION: DETERMINE: here first find using characteristic equation for gate d latch implement for…

Q: What is the principle of operation of an inductor and how does it behave in an AC circuit?

A: An inductor is a passive electrical component that stores energy in the form of a magnetic field. It…

Q: What are the key design considerations that need to be taken into account while designing a Flyback…

A: When designing a Flyback Converter or a Push-Pull Converter for a specific electrical power…

Q: 2. Given the circuit diagram as shown below, solve for IT, R₁, R2, V2, V3, V5, V6, 12, 14, and I5. E…

Q: O A transfer function is given by 120(8+1) 8(8+10) T (s) where s = jw. NOTE: This is a multi-part…

Q: Consider a solar cell made of Alo.3Ga0.7As. When exposed to sunlight, it generates a photocurrent of…

A: Photocurrent (Iph)= 0.096 A Open circuit voltage(Voc)= 0.6 volts Here we will use the…

Q: Problem 10. For the negative feedback systems having the following open-loop transfer functions,…

A: The open-loop transfer function of two negative feedback systems are given as i KGsHs=Kss+2s+5s+8,ii…

Q: A balanced delta-connected load is supplied by a 60-Hz three-phase source with a line voltage of 410…

Q: 4-39 For the circuit of Figure P4-39: (a) Find the output in terms of v₁. (b) Draw a block diagram…

Q: G(s) = K(s + 6) (s+2) (s² + 10s +29)

A: Control systems has steady state error of 8%

Q: Question No. 9 The average power delivered to an impedance (4-j3) by a current 5 cos(100nt + 100) A…

A: Given- Impedance, Z=4-j3 Ω. Current, I=5 cos100πt+100 A. To find- The average power delivered.

Q: What is the current 13 (mA)? Multimeter-XMM3 10 V A V Set... - 4₁ X G LE -30 V XMM3 R1 1kQ +V₁- VA…

Q: What is the voltage V2?

A: For the given circuit, the voltage across the resistor R2 needs to be calculated and the same can be…

Q: I need some clarification of how the angle of V1 is -174.93141°.

A: Need to provide clarification about the calculation of the phase angle term in the voltage V1.

Q: 4. A single phase circuit consists of three conductors each 5 mm diameter on one side of the line…

A: In the question it is mentioned that other side has two conductors. However, in figure it is showing…

Q: Q1 (a) (b) (c) Given arbitrary signals, x(t) and y(t) as shown in Figure Q1. 2 -2 x(t) 2 t Figure Q1…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: 3. The voltage and current at the input of a circuit are given by the expressions v(t) = 170 cos(wt…

A: Given data vt=170 cosωt+30° it=5 cosωt+45° To find out We have to calculate the average power…

Q: For a given system with transfer function T(s), initial conditions are (a) included in T(s) (b)…

A: In this question we need to choose a correct option

Q: T/F: direct current is a consistent flow of electrical charge in only one direction

A: Direct Current :- The current which flow consistently in only one direction is known as the as…

Q: A 4-pole DC shunt generator with wave-wound armature has 40 slots each having 12 conductors.…

A: In this question we need to find the voltage across load in case of wave wound and lap wound…

Q: . Find the Thevenin equivalent circuit as seen by the load impedance ZL • Find the value of Z, such…

Q: What are ultrasonic sensors in electrical engineering?

A: Ultrasonic sensors are a type of sensor used in electrical engineering that emits high-frequency…

Q: Calculate the drain-source voltage (V_DS) for the circuit in the figure. a) b) C) d) 4V 68 kn 20 kn…

Q: 7. Consider the following circuit: ε = 15.0 V C₁ = 25.0 μF C2 = 35.0 μF R₁ = 45.0 52 R2 = 55.0 22 R3…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: Problem 3(b): Consider the circuit shown below. A. Bo 10 92 ww ww 2092 40 92 + > 30 92 ww www 50 92…

Q: I need help building this BJT amp circuit on a breadboard. If possible would you be able to show how…

A: Need to provide the Breadboard layout for the given Voltage divider biased BJT circuit.

Q: 9. of V bc = 2002 -30° V rms. Determine the phase voltage of the source. A positive-sequence…

Q: Consider a series RLC circuit comprised of a resistor, an inductor, and a capacitor. In which of the…

A: For series RLC circuit comprised of a resistor, an inductor, and a capacitor: In which of the…

Q: part d

A: The value of the proportionality constant needs to be calculated for the given value of feedback and…

Q: What is the Z-transform of a signal in the context of digital signal processing? How is it different…

A: In digital signal processing, the Z-transform is a mathematical transformation that maps a…

Q: Sketch the voltage transfer characteristics of an ideal voltage amplifier and a real voltage…

A: To Find: Voltage transfer characteristic sketch of an ideal and practical (Real) voltage amplifier.…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Transmission line

A solar energy installation utilize a three phase
bridge converter to feed energy
into power system through a transformer of
400 V/400 V, as shown below.
The energy is collected in a bank of 400 V battery
and is connected to converter through a large
filter choke of resistance 10 N.
Q. The kVA rating of the input transformer is
#
38 H*
Filter choke
Battery

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Calculation:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding short-circuited, rated current flows when the voltage applied to the primary is 5.5 kV. The power input is read as 100 kW. Determine Req1andXeq1 in ohms referred to the high-voltage winding.
A single-phase semi-converter is operated form 120 V, 50 Hz AC supply at a firing angle of 30 degrees. The load is such that the load current is continuous and ripple-free. Displacement factor of the converter is: (a) 0.77 (c) 0.67 (b) 0.97 (d) 0.57
(5) Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor in Non- linear Load Figure 6 Analyse different methods of harmonics mitigation to eliminate the harmonic, which you have identify in above power system circuit. You can use harmonic filters, K or equivalent transformers or oversized neutral method depending upon the harmonic sources.
Q5. For the following center tapped transformer, show the waveform across each half of the secondary winding and across R, when a 100 V peak sine wave is applied to the primarywinding. What is the PIV rating must the diodeshave? (Use constant voltage drop model for the Silicon diode) D IN4001 OV 10 kN IN4001 DELL
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10N. The output voltage of the rectifier is 400 V DC. The rating of source side of three phase delta – star transformer is, (a) 14.875 kVA (b) 16.765 kVA (c) 15.475 kVA (d) 16.025 kVA
In a buck converter, what are the benefits and disadvantages if the changes of duty cycle is drastic i.e, fast system response? How about when duty cycle changes slowly i.e, slow system response?
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 10.The output voltage of the rectifier is 400 V DC. The rating of source side of three phasedelta – star transformer is
A voltage multiplier has 12 stages Capacitances, all equal to 0.08 μF. Thesupply transformer secondary voltage is 150 kV at a frequency of 100 Hz. Load current 0,006A.What is the percentage ripple, the regulation and the optimum number of stages for minimumregulation or voltage drop.
A three-phase uncontrolled bridge rectifier delivers power to a resistive load of 102.The output voltage of the rectifier is 400 V DC. The rating of source side of three phasedelta - star transformer is,
In the circuit in Figure 2, the capacitor connected to the a-b terminals of the transformer anda circuit consisting of resistance is defined as a load circuit. Find the average power spent by the load circuit?
In the circuit shown in the figure, a voltage with a peak value of 212.16 V is applied to the input of the secondary transformer with common winding. The ratio between transformer windings is 5: 2. Find the Vrms value on VS2. A 59,98 Vrms B 29,99 Vrms C 42,43 Vrms D 84,86 Vrms E 42,52,99 Vrms
A Buck Converter converts 24Vdc to 12Vdc with losses of 70W, and a load of 60Ohms. What is the current drawn from the power supply?