A ski resort consists of a few chairlifts and several interconnected downhill runs on the side of a mountain, with a lodge at the bottom. The lifts are analogous to batteries, and the runs are analogous to resistors. Describe how two runs can be in series. Describe how three runs can be in parallel. Sketch a junction of one lift and two runs. One of the skiers is carrying an altimeter. State Kirchhoff’s junction rule and Kirchhoff’s loop rule for ski resorts.

A ski resort consists of a few chairlifts and several interconnected downhill runs on the side of a mountain, with a lodge at the bottom. The lifts are analogous to batteries, and the runs are analogous to resistors. Describe how two runs can be in series. Describe how three runs can be in parallel. Sketch a junction of one lift and two runs. One of the skiers is carrying an altimeter. State Kirchhoff’s junction rule and Kirchhoff’s loop rule for ski resorts.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 82PQ

See similar textbooks

Similar questions

33. Parts (a) through (e) of this problem should be done by inspection-that is, mentally. The intent is to obtain an approximate solution without a lengthy series of calcula- tions. For the network in Fig. 102: a. What is the approximate value of I1, considering the magnitude of the parallel elements? b. What is the ratio I¡/I2? Based on the result of part (a), what is an approximate value of 12? c. What is the ratio I/I3? Based on the result, what is an approximate value of I3? d. What is the ratio I/I4? Based on the result, what is an approximate value of I4? e. What is the effect of the parallel 100 kN resistor on the above calculations? How much smaller will the current I4 be than the current I¡? f. Calculate the current through the 1 2 resistor using the current divider rule. How does it compare to the result of part (a)? g. Calculate the current through the 10 2 resistor. How does it compare to the result of part (b)? h. Calculate the current through the 1 kn resistor. How does…
Technician A says that a conductor has 1 to 3 electrons orbiting in its outer valance ring. Technician B says that an insulator has 4 electrons orbiting in its outer valance ring. Who is correct? Or both? Technician A says that a loose or corroded ground could cause a dimly lit bulb. Technician B says that a loose or corroded ground could cause a blown fuse.
4. Voltage. A cell has a terminal voltage of 50 V for a current of 10.0 A, and 54 V for a current of 6.0 A. Find the electromotive force and internal resistance of the cell. Hint: Use V = EMF – Ir for each set of given V and I, take note of the two equations formed then determine EMF and r by solving the two-variable linear equations.
Shown in the figure below is an electrical circuit containing three resistors and two batteries.Write down the Kirchhoff Junction equation and solve it for I1 in terms of I2 and I3. Write the result here:I1 = I2−I3 Write down the Kirchhoff Loop equation for a loop that starts at the lower left corner and follows the perimeter of the circuit diagram clockwise.0 = I3R3+10−I1R1+4 Write down the Kirchhoff Loop equation for a loop that starts at the lower left corner and touches the components 4V, R2, and R1.0 = −I2R2−I1R1+4 The resistors in the circuit have the following values: R1 = 3 Ω R2 = 5 Ω R3 = 11 Ω Solve for all the following (some answers may be negative):I1 = AmperesI2 = AmperesI3 = Amperes
des Constants | Periodic Table uce 365 Part B Determine the terminal voltage of each battery in the figure.(Eigure 1) Determine the terminal voltage of bottom battery. Express your answer to two significant figures and include the appropriate units. Figure < 1 of 1 HẢ r2 = 2.0 Q. Vierminal = 11.37 E = 18 V R = 6.6 Q O You have already submitted this answer. Enter a new answer. No credit lost. Try again. r; = 1.0 Q. E = 12 V Submit Previous Answers Request Answer
Four resistors (R1=A ohms, R2=B ohms, R3= C ohms, R4=D ohms) are connected in parallel. Find the current in R2 if the total voltage is 220 V. If the total voltage in the previous item is the potential difference between the two plates of a parallel plate capacitor, what is the capacitance if the amount of charge in one plate is A nanocoulombs?
Consider the circuit below. The switch is first closed and after a long time passes, the switch is reopened. Calculate the charge stored in the capacitor 7 x10s after the switch is reopened. Give your answer in x10 C to 3 sig figs. Switch R1 to 2 k2 20 V R, 3500 2 C: 100 µF R3 3 k2 GO
Consider the circuit shown in the figure below. The four capacitors have capacitances C1=10μF, C2=13μF, C3=77μF, C4=19μF and are connected to a battery of voltage V=46Volts. When all capacitors are fully charged, determine the charge on C4. Express your answer in units of μF using zero decimal places.
Consider the circuit in the diagram. where R1 = R2 = R3 = 19.0 Ω and R4 = 36.0 Ω. What is the potential difference between points A and B?
Use the following circuit to complete the accompanying table of Charges, Capacitances, and Voltages. Note 1: You may submit answers one blank at a time. You are not counted as using an attempt when an empty answer blank is submitted. Fill out the table in any order you want, one blank at a time to maximize your chances for success. Note 2: Drawing "equivalent circuits" is probably helpful. C₂ C3 HE C₁ C₂ C3 C4 C5 Ctotal C₁ HI 51 Vtotal Charge (μC) Capacitance (μF) Voltage (V) 29 57 C5 HH 29 CA 3.4 7.5
Answer the following with true, false, less than, greater than, or equal to. m1g is ..... Tp1 Tp1 is ..... Tp2 Tcp is ...... Tp1 + Tp2 m1g + M2g + Mpg is ..... Tcp
Solve the following Physics problem. Show your solutions. Round off your final answer in a whole number. A cell has a terminal voltage of 50 V for a current of 10.0 A and 54 V for a current of 6.0 A. Find the electromotive force and internal resistance of the cell.