Num3 3.A sample of KHP, KHCaH.O., weighing 2.035 g is titrated with NaOH andbacktitrated with HCI. NaOH required = 23.20 ml: HCI required = 2.675 ml. Ifeach ml of HCl is equivalent (*) to 0.01600 g of Na:0, what volume of 6.00 NNaOH must be added to 500 ml of above NaOH to bring it to 0.5000N?

Given: Mass of sample of KHP =2.035 g Volume of NaOH required =23.20 mL Volume of HCl required…

A sample of KHP, KHCaH.O., weighing 2.035 g is titrated with NaOH and backtitrated with HCI. NoOH required 23.20 ml: HCI required = 2.675 ml. If each ml of HCI is equivalent (*) to 0.01600 g of Na:O, what volume of 6.00 N NaOH must be added to 500 ml of above NaOH to bring it to 0.50OON

A sample of KHP, KHCaH.O., weighing 2.035 g is titrated with NaOH and backtitrated with HCI. NoOH required 23.20 ml: HCI required = 2.675 ml. If each ml of HCI is equivalent (*) to 0.01600 g of Na:O, what volume of 6.00 N NaOH must be added to 500 ml of above NaOH to bring it to 0.50OON

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.97E

See similar textbooks

Similar questions

A bottle of concentrated hydroiodic acid is 57% HI by weight and has a density of 1.70 g/mL. A solution of this strong and corrosive acid is made by adding exactly 10.0 mL to some water and diluting to 250.0 mL. If the information on the label is correct, what volume of 0.988 M NaOH is needed to neutralize the HI solution? Suggest an indicator for the titration.
A 2.500-g sample of a mixture of sodium carbonate and sodium chloride is dissolved in 25.00 mL of 0.798 M HCl. Some acid remains after the treatment of the sample. a Write the net ionic equation for the complete reaction of sodium carbonate with hydrochloric acid b If 28.7 mL of 0.108 M NaOH were required to titrate the excess hydrochloric acid, how many moles of sodium carbonate were present in the original sample? c What is the percent composition of the original sample?
An acid is titrated with NaOH. The following beakers are illustrations of the contents of the beaker at various times during the titration. These are presented out of order. Note: Counter-ions and water molecules have been omitted from the illustrations for clarity. (a) (b) (c) (d) (e) a. Is the acid a weak or strong acid? How can you tell? b. Arrange the beakers in order of what the contents would look like as the titration progresses. c. For which beaker would pH = pKa? Explain your answer. d. Which beaker represents the equivalence point of the titration? Explain your answer. e. For which beaker would the Ka value for the acid not be necessary to determine the pH? Explain your answer.
Follow the directions of Question 64. Consider two beakers: Beaker A has a weak acid(K a=1105). Beaker B has HCI. The volume and molarity of each acid in the beakers are the same. Both acids are to be titrated with a 0.1 M solution of NaOH. (a) Before titration starts (at zero time), the pH of the solution in Beaker A is the pH of the solution in Beaker B. (b) At half-neutralization (halfway to the equivalence point), the pH of the solution in Beaker A the pH of the solution in Beaker B. (c) When each solution has reached its equivalence point, the pH of the solution in Beaker A the pH of the solution in Beaker B. (d) At the equivalence point, the volume of NaOH used to titrate HCI in Beaker B the volume of NaOH used to titrate the weak acid in Beaker A.
Consider the nanoscale-level representations for Question 111 of the titration of the aqueous strong acid HA with aqueous NaOH, the titrant. Water molecules and Na+ ions are omitted for clarity. Which diagram corresponds to the situation: (a) After a very small volume of titrant has been added to the initial HA solution? (b) Halfway to the equivalence point? (c) When enough titrant has been added to take the solution just past the equivalence point? (d) At the equivalence point? Nanoscale representations for Question 111.
8-115 When a solution prepared by dissolving 0.125 g of an unknown diprotic acid in 25.0 mL of water is titrated with 0.200 M NaOH, 30.0 ml, of the NaOH solution is needed to neutralize the acid. Determine the molarity of the acid solution. What is the molar mass of the unknown diprotic acid?
Sketch the titration curve for a weak acid titrated by a strong base. When performing calculations concerning weak acidstrong base titrations, the general two-slep procedure is to solve a stoichiometry problem first, then to solve an equilibrium problem to determine the pH. What reaction takes place in the stoichiometry part of the problem? What is assumed about this reaction? At the various points in your titration curve, list the major species present after the strong base (NaOH, for example) reacts to completion with the weak acid, HA. What equilibrium problem would you solve at the various points in your titration curve to calculate the pH? Why is pH 7.0 at the equivalence point of a weak acid-strong base titration? Does the pH at the halfway point to equivalence have to be less than 7.0? What does the pH at the halfway point equal? Compare and contrast the titration curves for a strong acidstrong base titration and a weak acidstrong base titration.
Another way to treat data from a pH titration is to graph the absolute value of the change in pH per change in milliliters added versus milliliters added (pH/mL versus mL added). Make this graph using your results from Exercise 61. What advantage might this method have over the traditional method for treating titration data?
Consider the titration curve in Exercise 115 for the titration of Na2Cr3 with HCl. a. If a mixture of NaHCO3 and Na2CO3 was titrated, what would be the relative sizes of V1, and V2? b. If a mixture of NaOH and Na2CO3 was titrated, what would be the relative sizes of V1 and V2? c. A sample contains a mixture of NaHCO3 and Na2CO3. When this sample was titrated with 0.100 M HCl, it took 18.9 mL to reach the first stoichiometric point and an additional 36.7 mL to reach the second stoichiometric point. What is the composition in mass percent of the sample?
You have a solution of the weak acid HA and add some HCl to it. What are the major species in the solution? What do you need to know to calculate the pH of the solution, and how would you use this information? How does the pH of the solution of just the HA compare with that of the final mixture? Explain.
A 5.36-g sample of NH4Cl was added to 25.0 mL of 1.00 M NaOH and the resulting solution diluted to 0.100 L.. (a) What is the pH of this buffer solution?. (b) Is the solution acidic or basic?. (c) What is the pH of a solution that results when 3.00 mL of 0.034 M HCl is added to the solution?

Recommended textbooks for you

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Introduction to General, Organic and Biochemistry

Chemistry

ISBN:

9781285869759

Author:

Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:

Cengage Learning

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Introductory Chemistry For Today

Chemistry

ISBN:

9781285644561

Author:

Seager

Publisher:

Cengage

Introduction to General, Organic and Biochemistry

Chemistry

ISBN:

9781285869759

Author:

Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:

Cengage Learning

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS