Answered: A resistance R = 10 ohms and and…

A resistance R = 10 ohms and and inductance of L = 5 mH are connected in parallel. The inductive branch is 5 sin (2000t - 45°) A. Determine the equation of the total current.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Consider the two signals c1(t) = cos(105nt) and c2(t) = sin(10°t). Consider also the two signals, m1...

Q: Find V. using superposition theorem. 4/0 A ww ell 10/0° V 3/0° A ww

A: In this question, We need to determine the voltage Vo using the superposition. We are solving this...

Q: List at least three advantages of analog transmission over digital transmission.

A: 1) Digital transmission is very desirable but a low-pass channel with a very large bandwidth is need...

Q: Question 2: Wny does the phase difference between la (main winding current) and ly (auxilary winding...

A: Since you have posted multiple different question. we will solve the first question for you. To get ...

Q: FIND I,: (Hint Supermade FiwD工。 with dependent Source) Vz V 土)1ZV YIo it,

A: This question belongs to circuit theory . It is based on the concept of super node and nodal analysi...

Q: A synchronous motor absorbing 60 kW is connected in parallel with a factory load of 240kW having a l...

A: From the given values find the active and reactive power of individual loads and total loads then ob...

Q: 6+j7 8-j

Q: Step Response 2 1.8 1.6 1.4 1.2 0.8 0.6 0.4 0.2 0.5 1.5 25 Time (seconds) O Stable with a steady-sta...

A: In this question, Step response of the any system is given. Choose the correct options.

Q: Applying the different laws and identities in Boolean algebra, determine the minterm expansion of th...

Q: 1. What is the Transfer function for shown a. Circuit Circuit

Q: Given the state diagram below, derive the state equation using J-K F/F 0/0 1/0 1/0 00 01 1/1 0/0 1/0...

Q: Consider a silicon pn junction at T 300K. Assume the doping concentration in the n region is 1020cm ...

Q: A set of conductors is used to supply residential unit with a total load current of 60 A at a single...

Q: A polarity test is performed upon a 7,620/230-Volt transformer. If the input voltage is 220 Volts, ...

A: In the given question, we have a transformer having the voltages as; Primary voltage, VP=7620V Secon...

Q: Q1. A certain material has a conductivity of 5 x 10s/m and a permittivity of 5F/m. A total charge of...

A: We need to find surface charge density for given sphere at given time .

Q: Following the analysis applied to the half-wave rectifier with capacitor filter, show how to arrive...

A: It is given that: half-wave rectifier with capacitor filter waveform:

Q: 1. A short-shunt compound generator delivers a load current of 30 A at 220 v and has armature, serie...

Q: According to Kirchhoff's rules, the reading of a voltmeter (in V) across R3 in the circuit shown to ...

Q: R1 750 R2 1250 R3 200 0 ww 10 O v1 = 2.8 V2 = 4V V3 = 3.2V O v1 = 1.11 V2 = 2.22 V3 = 1.66 O v1 = 1....

Q: Sketch the root locus for the followi

Q: Given the one-line diagram; a duplex switch controls each lamp A and B, individually. , and a lamp C...

A: The one-line diagram is shown below,

Q: Determine the magnitude of the common-mode gain, Acm

Q: 1- Find phase margin, gain margin, gain crossover frequency, phase Crossover frequency, delay margin...

A: The stability of the system can be calculated by using the bode plot. The Gain margin and Phase marg...

Q: Point charges of 50 nC each are located at B (-1,0,0). C(0,1,0) and D (0,-1,0) in free space. Find t...

A: We need to find out force on given charge particle due to others charge particle .

Q: How many lines are there in an NTSC signal?

A: In this case, from the given options, the correct option corresponding to the number of lines presen...

Q: 03: The output voltage of a transmitter is given by the following envelope wave form. This voltage i...

Q: foo=3 sin Ž

A: We need to find out the Laplace transform of given signal.

Q: Determine the magnitude of the current flowing through a 4.7 kΩ resistor if the voltage across it is...

Q: S; + Se A So Σ Sib Figure Q1(a)

Q: Compute a single equivalent impedance for this circuit for a source frequency of f = 60 Hz. Express ...

A: Solution Given that f=60HZ

Q: What is a rectifier circuit? Give at least 3 applications of rectifier circuit.

Q: Exercises 1. - 2. -

A: The given data represent the connection between the line bulb and the switch as a refer data for the...

Q: Step Response 1.8 1.6 1.4 1.2 0.8 0.6 0.4 0.2 0.5 1.5 2.5 3. Time (seconds) Amplitude 2

A: signal has stable value at t=(infinity)

Q: Give example problems for impedances and admittance.

Q: three phase inverter

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: * 15. For the cascaded system of Fig. 10.55 with two identical stages, determine: (a) The loaded vol...

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are...

Q: 3-ф, star-connected synchronous motor takes 48 kW at 693 V, the power factor being 0.6 lagging. The ...

Q: fox=e Sin 2x

A: GIVEN: f(x)=ex sin2x FIND: Laplace transform of given function

Q: The Frequency response of an LTI system is H(w) = The impulse response of the 1+w2" system is h(t). ...

Q: 1. Given the operational amplifier below. a. Solve for the input voltage, if the feedback resistors ...

A: Given data, (a) Output voltage is given, vo=-3 V Feedback resistance Rf=10 kΩ Input resistance is g...

Q: Consider a silicon pn junction at T= 300 Kwith an acceptor doping concentration (1 x 10cm-3) and a d...

Q: Q10/ At room temperature (300 K) with the Fermi level located exactly in the middle of the bandgap, ...

A: We need to find out the probability of a state being empty

Q: An R-L load connected to 250V supply is consuming 1.5kW. When a capacitor is connected parallel to t...

Q: Warmup: 1. Find the current in the circuit. 20 ohm 40 ohm 120V I 2. What is the voltage across the 4...

A: In this question, We need to determine the current I in the given series circuit. We know if two r...

Q: Solve completely the given circuit below by applying two ac theorems discussed. Choose among Kirchho...

Q: Question # 1: The equivalent circuit impedances of a 20 kVA, 8000/240 V, 60 Hz transformer are to be...

A: In this question we need to find a equivalent circuit impedance of the given transformer.

Q: Voo B carry out VDD sum

Q: A synchronous generator with 6 magnetic poles supplies an induction threephase motor. Considering th...

A: Pole: This is placed at the stator and on this winding will be done. With the help of the pole magne...

Q: Determine the current in the circuit in polar form. Write the magnitude only in four decimal places....

A: In this question we need to find a current i show in the given circuit.

Q: Convert 1000 W into its equivalent mechanical horsepower.

Question

A resistance R = 10 ohms and and inductance of L = 5 mH are connected in parallel. The
inductive branch is 5 sin (2000t - 45°) A. Determine the equation of the total current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.
Figure 2 shows three "LC" circuits, two of them with capacitors of capacitance "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitors "Cc" capacitors. inductance "L", the three circuits are coupled by means of two capacitors of capacitance "Cc". The currents circulating through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = -dQ/dt, find the system of coupled equations of the system and then find the angular normal frequencies of the system.
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
A resistance R. an inductancel =0.01H and a capacitance C are connected is series. When an alternating valtage v = 400 sin (3000t - 20°) is applied to the series combination the current flowing is 10/2sin(3000t -65°).Find the values of Rand C.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.
a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is
A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a 9-V DC source, determine the current (in amperes) through the circuit for a long time. The initial current is 100 mA. Express your answers accurate to four decimal places. No need to put the units.
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor?