A pipeline has the following data at its two section A and B Item Section - A  Section - B Diameter (cm) 30 45 Elevation (m) 10 16 Pressure (k Pa) 40 30 Kinetic energy correction factor, α 1.08 1.25 Assume ahead loss equal to 20 times the velocity head of A and calculate the discharge of water through this pipeline when flowing from B to A.

Q: O 32,3 m a) Find the irreversible head loss of the system 22,8 m 29,7 m 25,4 m 26,7 m b) Since the…

A: For solution refer below images.

Q: Oil flows at 55.9L/s in a pipe of 160mm diameter and 50m length. SG of oil is 0.9 and viscosity is…

A:

Q: An orifice of 8 cm diameter is fitted in a 20 cm diameter pipe that carries oil of specific gravity…

A: From the given data,

Q: An elbow is to be attached to a pressurized water tank ptank = 15 kPa (gauge). Water is to flow out…

A: An elbow is to be attached to a pressurized water tank Ptank = 15 kPa (gauge). Water is to flow out…

Q: A smooth steel pipe of diameter 500 mm and length 850 m carry water at the rate of 0.05 m3/sec. Find…

A: As per policy, we can solve first one only from multiple questions. Kindly repost the remaining…

Q: Water flows at a rate of 0.185 m3/s through a 150 m long galvanized steel pipe of diameter 200 mm.…

A:

Q: 1. Water flows at a rate of 65 Li/min in a steel pipe of 45 mm diameter, K = 0.045x10-3 m, H = 0.001…

A:

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: The valve in a piping system causes a 3.1 m head loss. If the velocity of the flow is 4 m/s, the…

A: Give Data:  Head loss in the pipe is: He=3.1 m The velocity of the flow is: v = 4 m/s.

Q: Flow takes place between three reservoirs, as shown in Figure 1. The volume flow rate out of…

A:

Q: 04: Water flows from a large close tank, through pipe length 15m, diameter (30mm) and exits with…

A:

Q: The rate of flow of water in a 150 mm diameter is measured with a venturi meter with a 50 mm…

A: Given: The diameter of the pipe, D = 150 mm The diameter of cone at throat, d = 50 mm The pressure…

Q: The diameter of an open topped tank 1.5 m high increases uniformly from 4.2 m at the base to 6 m at…

A:

Q: A pitot tube is inserted in a 76 cm ID duct carrying air at 42.54C. A pitot tube reading is taken at…

A: Given that, T=35.46 °C,Cd=0.98h1=4 cm,h2=71 cm,Barometric Pressure=760 mm Hgρwater=1000 kg/m3

Q: A nozzle meter, with an orifice diameter of 3 cm, is being used to determine the velocity of ethanol…

A: Write the given data with suitable variables: Do=3 cm=0.03 mSG=0.789μ=0.986×10-3 Pa-s100 cm1 mD1=6…

Q: An oil of sp. gr. 0.9 is flowing through a venturimeter having inlet diameter 20 cm and throat…

A: We are authorized to answer one question at a time since you have not mentioned which part you are…

Q: Calculate the power required to pump water at 120 kg/s from a supply tank, through an 18 cm diameter…

A: Given data: Mass flow rate of water, m˙=120 kg/s Diameter of the pipe, d=18 cm=0.18m Also, the pipe…

Q: Q. No 3). A water supply pipe line is designed to supplying water to a nearby city. Determine…

A:

Q: Oil (p = 1100 kg/m³ ,µ = 5.6 X 10-4 kg/m· s) flows through a 4.3 cm diameter pipe. The flow rate…

A: GIven data: The diameter of the orifice meter is d=3 cm=0.03 m. The diameter flow through oil is…

Q: A venturi meter with a 1.0 in. diameter throat is mounted in a 2.0 in. diameter pipe carrying water…

A: Solution: Given Data: D=2 ind=1 inρ=63.36 lbm/ft3μ=7.536×10-4 lbm/ft-sSG=13.55∆P=5 in HgCD=0.98

Q: Three parallel pipes connected at the two ends have flow-rates Q₁, Q2 and Q3 respectively, and the…

A:

Q: A duct of rectangular cross-section 600mm X 400mm carries 90 m3/min of air having a density of 1.2…

A: Given data  Rectangular Cross-section of duct = 600 mm * 400 mm discharge = 90 m3/min density = 1.2…

Q: Water enters a pipe of diameter 22 mm with a venturi meter with a throat diameter of 12 mm. At the…

A:

Q: A pitot tube is inserted in a 76 cm ID duct carrying air at 42.54C . A pitot tube reading is taken…

A:

Q: A 3.81-cm diameter venturi meter is installed in a pipe with an internal diameter of 10.23 cm. A 127…

A:

Q: The power transmitted through a pipe is (where Y =Specific weight in N/m3, (Q = Discharge in m3/s,…

A: Power transmitted through a pipe,  Power=YQ(H-hf) Y is the specific weight (N/m3) hf is the head…

Q: What is the flow rate of the oil (sg = 0.73) in the pipe below based on the measurements in the…

A: Find the flow rate.

Q: Q2- Air at 59°F and standard atmospheric pressure flows through a furnace filter with an average…

A:

Q: C3. An oil of specific gravity 0.82 is flowing through a horizontal venturimeter fitted to a 278 mm…

A: Given data: Specific gravity flowing through a horizontal venturimeter, s=0.82; ⇒Density of oil,…

Q: b) Find an expression for the gauge pressure at point A, a distance L1 upstream of the narrow pipes.…

A: given;   lets take pressure at A=PAdischarge=Qdiameter=d1diameter=d2pipe loss coefficient=KLlarge…

Q: The water is flowing through a pipe having diameters 30 cm and 21 cm at sections 1and 2…

A:

Q: A pipeline of carrying oil of specific gravity 0.87, changes in diameter from 200 mm diameter at a…

A: Given  Q=118litre/s =0.118m3/s Specific gravity of oil =0.87  density = 0.87×1000    =870kg/m3 At…

Q: An oil of sp. gr. 0.8 is flowing through a venturimeter having inlet diameter 20 cm and throat…

A: Venturi-meter is a device used for measuring the flow of fluid through pipe. Principle: By reducing…

Q: A smooth pipe carries water at the rate of 300 L/s, kinematic viscosity is 10 m/s , with a head loss…

A: Given, Q = 300 L/s = 0.3 m3/s Kinematic viscosity = v = 10-6 m2/s Head loss = hf = 3 m Length of…

Q: In a wastewater treatment plant, Blower supplies air to the sequencing batch reactor. It is…

A: Write the given data. Cpitot=0.98ρair=1.2 kg/m3ρwater=1000 kg/m3hwater=75 mm

Q: A pump is being used to transport a liquid food product (density = 1000 Kg/m3, viscosity= 1.2 x 10…

A: GivenDensity of liquid=1000kg/m3viscosity=1.2×10-3Pa/smass flow rate Q=2kg/sdiameter of pipe=2inch…

Q: Water flows at a rate of 65 Li/min in a steel pipe of 45 mm diameter, K = 0.045x10-3 m, μ = 0.001…

A:

Q: A Pelton Wheel is supplied with fresh water, and arranged as given b Parameter Height of reservoir…

A: A Hydraulic machine is a machine that converts the rate of flowing of water into useful energy ie)…

Q: A pipe of unknown type, length and diameter includes a threaded union (KL = 0.08), 90° %3D threaded…

A: Given data  minor loss coefficients for threaded union = 0.08  minor loss coefficient for 90o…

Q: determine total head loss of the system and gauge pressure p2 in order to deliver water at 2…

A: For solution refer below images.

Q: Water flows through a 16-inch pipeline at 6.7 ft3/s. Calculate the Darcy friction factor using…

A:

Q: Rate the flow inside a pipe with Re = 1.8x10^4 and ε/D = 0.027

A: The quantity of surface roughness inside the pipe is referred to as relative roughness. The…

Q: The closed tank of a fire engine is partly filled with water, the air space above being under…

A: Given, Diameter of the pipe ,  d =6 cm Height of the building , h2 =2.5 m  =250 cm frictional…

Q: A horizontal Venturi meter, which has a throat diameter of cm, is installed in a pipeline with a…

A:

Q: Air flows through a Venturi channel of rectangular cross-section as shown in Figure 1. The constant…

A: Given data: - The constant width of the channel is b = 0.08 m. The height at the exit is h4 = 0.04…

Q: A lubricating oil of viscosity 1 poise and specific gravity 0.9 is pumped through a 30 mm diameter…

A:

Q: C3. An oil of specific gravity 0.82 is flowing through a horizontal venturimeter fitted to a 278 mm…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.