a) In a Power System, Define the following         (i) Peak Load       (ii) Spinning Reserve

Q: An ac source in series with an impedance of (0.5 + j10)N

A:

Q: A coil of 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 micro-farad ...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: 1)-What happens if different voltage and different current ratings of solar panels are connected tog...

A: (i) Panels of the different voltage and different current ratings are connected in series.  The out...

Q: A band pass filter is to be constructed using RC components that will only allow a range of frequenc...

A:

Q: Assume that a 600 2, 12 µV rms voltage source

A:

Q: he Illumination at any point of surface is , to the cosine of angle the luminous flux makes with the...

A: The illumination at any point of surface is directly proportional to the cosine of angle the luminou...

Q: onsider the Boolean function F along with the don’t–care condition d: F(A,B,C,D) = Σ  m(0, 1, 7, 13,...

A:

Q: j2 N 6 Q I, j4 Q 30/30° V Find I, in Fig. using mesh analysis. ll

A:

Q: Q1/ A piece of resistance wire, 15.6 m long and of cross-sectional area 12 mm at temperature of 0°C,...

A: It is Given that:  Length (L) = 15.6 m Cross-sectional area = 12 mm2 = 12 × 10-6 m2 At 0°C, Current ...

Q: QUESTION 6 Consider a Ptype silicon for which the dopant concentration NA-101/cm Find the olectron a...

A: For P-type silicon,The dopant concentration is,ND=1016 /cm3The intrinsic concentration is,ni=1.5×101...

Q: 2. How much kinetic energy will an electron gain (in joules and eV) if it accelerates through a pote...

A: In this question,  We need to determine the energy E and electric field.  We know energy E= qV q ele...

Q: In the circuit shown, find current I and I1. 180 200 100 100 10 001 A 001 100 100

A: In this question We need to determine the current I and I1  as shown in the circuit.  We are solving...

Q: . What are the possible energy losses in the building you are reciting now? List them, explain and d...

A:

Q: 2. Determine the output voltage (Vo) and current (I) for the circuit shown below. +16 V Si 4.7 ka 12...

A: Given circuit:

Q: a) Draw nominal - T model of Transmission Line.      b) Write ABCD Parameters of the nominal T mode...

A:

Q: If R, has twice the value of R2 and R2 has three times the value of R3, what would b voltage Vx in v...

A:

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A: Given, An RLC series resonance circuit has Capacitance, C=22 μF Resistance, R=1200 Ω Inductance, L=3...

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 A B R1 R3 R5 10 V1 12 R...

A:

Q: Solve: (1-item) If R; = 27 Q and R2 = 66 N, determine the equivalent resistance of the circuit in oh...

A:

Q: Consider the following block diagram:

A:

Q: E3.9 Use nodal analysis to find I, in the network in Fig. E3.9.

A:

Q: юа 8Ω 5/45° A j10 2 Find Thevenin's Resistance. ww

A:

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A:

Q: Differentiate between the cable tester with multi mete

A: Following are the difference between cable tester and multi meter-  

Q: Graph the following functions. Create a table for the range. Use the domain (x) = {-2, -1, 0, 1, 2} ...

A: Solve the problem

Q: What is a resistor? What is an internal resistance? What is a dry cell

A: I clearly define the meaning and the uses of above elements. Please go through it. Thank you. 

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A: Given, A series RLC resonance circuit has Capacitance, C=22 μF Resistance, R=1200 Ω Inductance, L=34...

Q: arallel branches have admittances 0.3 + j0.4 and 0.2 – j0.25, respectively. If the curren first bran...

A: Solve the problem

Q: What is the value of Vx in volts if I = 1.2 A and V = 9 volts. 50 10Ω 150 V + Answer:

A:

Q: Two resistors RI = 100 Ô and R2 200 Q, has temperature of 300 K and 400 K, respectively. If the two ...

A:

Q: 2. Sketch the waveform of vo. Indicate the maximum, minimum and average values.vipk =15V

A: The solution is given below 

Q: How to convert between transfer function and state-space models

A: Transfer functions and state space models- Transfer functions and state space models are mathematica...

Q: A 1-phase, 20 km line delivers a load of 12 MW at 11 kV having a lagging p.f. of 0.9 at the receivin...

A: Sending end voltage= receiving end voltage+voltage drop in line . Regulation =( sending end voltage-...

Q: to be amplified by a noiseless amplifier having a voltage gain of 75 and a bandwidth of 100 kHz. A m...

A: Here,The voltage gain of the amplifier is,Av=75The bandwidth is,BW1=100kHzThe output voltage of the ...

Q: 12V 鲁12 :252 中3A 9元 I3

A:

Q: 4. The Silicon semiconductor (doped with 3 donor atoms per 6x10° si atoms) is subjected to a 300 deg...

A:

Q: When the load impedance is equal to the characteristic impedance of the transmission lines, then the...

A: Given a transmission line, where load impedance is equal to characteristics impedance, Load impedanc...

Q: 2. A load Z draws 12 kVA at a power factor of 0.856 lagging from a 120-V rms sinusoidal source. Calc...

A:

Q: Determine the efficiency of a 1,500 kVA, 2,300 V, 3 phase, Y-connected alternator which operates at ...

A: Efficiency = output power / input power Input power = output power + losses Losses= copper losses + ...

Q: Example 1 For the circuit shown in Figure 1, find the diode current (Ip), the diode voltage (Vp), an...

A:

Q: If your cellphone camera needs at least 1000 photons per second to detect light of wavelength 502 nm...

A: Given  Number of photons n=1000wavelength λ=502 nmc=2.998×1018 m/sh=6.626×10-34 J.s

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

A: In this case, from the given options, the correct option corresponding to the sampling rate change o...

Q: What are the expected readings of the following in the figure below? (R640 0, Av7.00 V) R. AV 10.0 0...

A:

Q: A capacitor branch having a ratio of Xc to R of 5 is paralleled with an impedance consisting of a 4 ...

A: In this question one parallel circuit is given which includes RL and RC branch... Overall power fact...

Q: R, 5 kN 12 – R2 R3 1 kN 14 1 kN 15 + Vs R5 V5 R4 V4 5 kN 1 kN

A: Referring to the circuit below, Ammeter is connected in series with 16V source while a voltmeter is ...

Q: 2. A 3-phase delta connected alternator supplies a wye connected load, each phase of which has a res...

A:

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Air Blast Circuit Breaker....

A: link https://circuitglobe.com/air-blast-circuit-breaker.html

Q: Q3/ Using nodal analysis, find the branch currents in circuit below. V3 12 8 R1 R3 R5 10 V1 12 R2 6....

A: Given circuit shown    

Q: j4 2 ll 4. Find current Io in the ww network of Fig. 1.32. I, 5/0° A -j2 2 -j2 2 Fig. 1.32

A:

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.