a hydraulic piston with a face area of 2E-4m^2 is paired with another, larger, hydraulic piston. if pushing on the smaller person with a force of 20 N causes the bigger piston to push with a force of 3E 4 N what is the larger Pistons face area

a hydraulic piston with a face area of 2E-4m^2 is paired with another, larger, hydraulic piston. if pushing on the smaller person with a force of 20 N causes the bigger piston to push with a force of 3E 4 N what is the larger Pistons face area

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter15: Fluids

Section: Chapter Questions

Problem 43PQ

See similar textbooks

Related questions

Q: A lamp weighing 1.75 kg rests on a night table. What is the normal force th the table excerts on the...

A: GivenMass of lamp , m=1.75 kg

Q: at is the direction of the force on the wire if both are parallel to the ground? B) Calculate the ...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: QUESTION 1 "Speedy" the super-tortoise accelerates from a dead stop to 1 m/s in 60 s. What is his av...

A: Given value--- initial speed = 0 m/s. final speed = 1 m/s. time = 60 sec. We have to find--- acce...

Q: A 4.5kg suitcase on a platform was pulled by a lady. She applied 50 N at an angle 20 degrees above h...

A: The normal force is given by the Newton's third law. The normal force is a reaction force that is eq...

Q: Two boats leave the shore at the same time and travel in the directions shown. If VA = 20 ft/s and v...

Q: Lexy throws a dart with an initial velocity of 25 m/s at an angle of 60° relative to the ground. Wha...

Q: A volcano erupted and spit a rock in the atmosphere at an angle of 35 degrees with the horizontal wi...

A: In this question we have to find the downward velocity of the rock before it hits the ground. Please...

Q: Three point particles of masses 1.0 kg, 1.5 kg and 2.5 kg are placed at three corners of a right ang...

Q: 4. A capacitor composed of two metal plates separated by an air gap of 1 mm has a voltage of 15 V. (...

Q: QI a) A cylindrical glass rod in air has index of refraction 1.52. One end is ground to a hemispheri...

Q: As shown below, a bullet of mass m and speed v is fired at an at rest pendulum bob. The bullet goes ...

Q: 2 crates are connected to each other by a rope. One crate(m=17kg) is sitting by the ledge of a cliff...

Q: Two astronauts (figure), each having a mass of 72.0 kg, are connected by ad = 11.0-m rope of negligi...

A: Please note : As per answering guidelines I can answer the first three subparts of a multisub-part q...

Q: You have an equilateral triangle and you happen to place three charges (32C q1) (-48 C q2) (64C q3) ...

Q: 75kg skater starts with initial speed of 0m/s 10m above geound. Just before he reaches the ground wh...

Q: A 200 g B 6.0 N 400 g W600 g Lower magnet Open FIGURE P7.26 FIGURE P7.27 27. || FIGURE P7.27 shows a...

Q: 18 A projectile is fired from level ground with initial speed V at an angle of 0 to the horizontal. ...

Q: Consider the figure shown in the following figure. You are lowering two boxes, one on top of the oth...

Q: 2. A weight of mass 2 kg is placed on a long vertical spring with spring constant k = 20. The dampin...

Q: A positive charge of mass, 6.68 x 10-27 kg, passes through a velocity selector in a horizontal path ...

Q: X-component of the resultant velocity of the ship, U sx + Vwx - 27.7128 + 15.9747 - 11.7381 km Ux %3...

A: The answer is below

Q: rrent I = 11 A is directed along the positive x-axis and perpendicular to a magnetic field. A magnet...

A: We know that the formula of the magnetic force is given as F = ILBsinθ where I is the current L is...

Q: Determine the sound intensity level 30.0 m from a sound source that emits 20.0 W of acoustical power...

Q: The mass of Mars is 6.42 × 10^23 kg. Its moon Phobos is 9378 kilometers away from Mars and has a mas...

Q: When a body possessed a total KE of 69J, and is moving at a speed of 66m/s, find the weight of the b...

A: Kinetic energy is the motion energy, An object that has motion - whether it is perpendicular or para...

Q: 5.7 g quarter sits 25 cm from the axis of rotation on a turntable that has a period of rotation of 1...

A: Given Time period T = 1.8 sec Mass m = 5.7 g = 5.7 × 10-3 kg Distance from axis of rotation r = 25 c...

Q: 2. A weight of mass 2 kg is placed on a long vertical spring with spring constant k = 20. The dampin...

A: The spring force is: The weight is:

Q: A thoughtful person on a bridge reflecting on his awesome Physics class sees a small stone by his fe...

A: Given Information The person nudge the stone off the surface. Initial speed of the stone is v0=0 Ti...

Q: If a cart sits motionless on level ground, no forces are acting on the cart. ( True or False )

Q: 1- What time is it when the hour angle is 30°.

A: Given, Hour angle is 30°

Q: 5) The diagram below shows a wave with various measurements taken along the wave. 50m 5m 20m 100m a)...

Q: A small car with mass 1810 [kg] travels at constant speed on the inside of a track that is a vertica...

Q: 1. Write down the derivation of formulas and describe each variable for each of the following discus...

Q: Question 16 (4 points) The maximum applied force a plastic grocery bag can withstand before ripping ...

Q: A light ray passes through a glass lens, shown in cross-section in the figure below. Find the angle ...

Q: The airplane on the amusement park ride moves along a path defined by the equations r = 4 m, 0 = (0....

A: The radial component is a bipolar radial head with two separate articulating surfaces

Q: 1. Find the total capacitance. CIEF All capacitors = 2uF

A: Given that:- Capacitance of each capacitor=2uF

Q: Residents of Hawaii are warned of the approach of a tsunami by sirens mounted on the top of towers. ...

A: decibel level of sound of siren at a distance of 2 m = 128 dB

Q: On an essentially frictionless, horizontal ice rink, a skater moving at v = 3.0 m/s encounters a ro...

Q: Calcylate The momentum of car that had tな of 17.0m/s. mass o 1550 kand f 'd velocity

Q: A 14-cm wire is placed in a uniform field of 0.3 T. If the wire carries a 6-A current, how much forc...

A: Given data: Length (L) = 14 cm = 0.14 m Magnetic field (B) = 0.3 T Current (I) = 6 A Angle (θ) = 45...

Q: An object is launched at a velocity of 26 m/s in a direction making an angle of 34 degrees upward wi...

A: Given value--- Initial speed = 26 m/s. angle = 34 degree . We have to find--- flight time?

Q: Two small conducting and identical sphere A and B have charges -15 nC and +5 nC, respectively. They ...

Q: Part A A sound source producing 1.20 kHz waves moves toward a stationary listener at one-half the sp...

A: frequency of sound source = 1200 Hz

Q: Part A A metal rod is 40.123 cm long at 20.5° C and 40.146 cm long at 45.2° C. Calculate the average...

Q: 37 ... You are standing on the edge of a swimming pool and looking directly across at the opposite s...

Q: For the configuration shown in the figure: C1 C2 C3 If the fem source is 120 V, C1= 21 µE, C2= 8 µE ...

A: According to question we need to find equivalent capacitance.

Q: A 1.9-m long gas column that is open at one end and closed at the other end has a fundamental resona...

A: Given Length of the pipe is given as l=1.9 m Fundamental frequency is given as f0=67.0 Hz The pipe i...

Q: Two capacitors (C1 and C2) joined at both ends are summed as follows: 1 1 1 a) Ceq C1 C2 b) Ceg = C1...

A: According to question we need to find equivalent capacitance.

Q: The Eiffel Tower in Paris is 984 ft tall and is made mostly of steel. For related problem-solving ti...

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Review. The tank in Figure P15.13 is filled with water of depth d = 2.00 m. At the bottom of one sidewall is a rectangular hatch of height h = 1.00 m and width w = 2.00 m that is hinged at the top of the hatch. (a) Determine the magnitude of the force the water exerts on the hatch. (b) Find the magnitude of the torque exerted by the water about the hinges.
The gravitational force exerted on a solid object is 5.00 N. When the object is suspended from a spring scale and submerged in water, the scale reads 3.50 N (Fig. P15.24). Find the density of the object. Figure P15.24 Problems 24 and 25.
Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
A host pours the remnants of several of wine into a jug a party. The host then inserts a cork with a 2.00-cm diameter into the bottle, placing it in direct contact with the wine. The host is amazed when the host pounds the cork into place and the bottom of the jug (with a 14.0-cm diameter) breaks away. Calculate the extra force exerted against the bottom if he pounded the cork with a 120-N force.
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
Figure 11.35(a) shows the effect of tube radius on the height to which capillary action can raise a fluid. (a) Calculate the height h for water in a glass tube with a radius of 0.900 cm—a rather large tube like the one on the left. (b) What is the radius of the glass tube on the right if it raises water to 4.00 cm?
The small piston of a hydraulic lift (Fig. P15.6) has a cross-sectional area of 3.00 cm2, and its large piston has a cross-sectional area of 200 cm2. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load whose weight is Fg = 15.0 kN? Figure P15.6
Review. The tank in Figure P15.13 is filled with water of depth d. At the bottom of one sidewall is a rectangular hatch of height h and width w that is hinged at the top of the hatch. (a) Determine the magnitude of the force the water exerts on the hatch. (b) Find the magnitude of the torque exerted by die water about die hinges.
Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the top, the cross-sectional area is 0.400 m2, and the pipe gradually widens so that its area near the ground is 0.800 m2. Water leaves the pipe at a speed of 16.8 m/s. What is the difference in the water pressure between the top and bottom of the pipe?
Figure P9.27 shows the essential parts of a hydraulic brake system. The area of the piston in the master cylinder is 1.8 cm2 and that of the piston in the brake cylinder is 6.4 cm2. The coefficient of friction between shoe and wheel drum is 0.50. If the wheel has a radius of 34 cm, determine the frictional torque about the axle when a force of 44 N is exerted on the brake pedal. Figure P9.27
The hydraulic system of a backhoe is used to lift a load as shown in Figure 11.45. (a) Calculate the force F the slave cylinder must exert to support the 400-kg load and the 150-kg brace and shovel. (b) What is the pressure in the hydraulic fluid if the slave cylinder is 2.50 cm in diameter? (c) What force would you have to exert on a lever with a mechanical advantage of 5.00 acting on a master cylinder 0.800 cm in diameter to create this pressure? Figure 11.45 Hydraulic and mechanical lever systems are used in heavy machinery such as this back hoe.