A full Wave rectifier shown in the circuit has 12OV (rms) 50HZ input through a transformer. RL = 200 Ohm, If silicon diodes are employed, what is the dc voltage * ?available at the load 120 VAC RL 10:1 ele

Q: Q.7: Air-condition system being in every organization. How the Maintenance of Air Conditioning Syste...

A: Check refrigerant levels and inspect for leaks Clean and straighten condenser coils to ensure proper...

Q: Solve for the value of R that will result to an equivalent resistance of 13 Ohms. (Note: a negative ...

A: If two resistors R1 , R2 are connected in parallel then equivalent resistance is    (R1×R2)/(R1+R2)....

Q: What is the ripple factor of a DC signal having ripple voltage of 2 V and a DC voltage of 50 V? Answ...

A:

Q: Q7:- (a) Design the circuit in figure below to maintain VL at 12V for a load current (IL) variation ...

A:

Q: A 5-Ohm resistor is in parallel with a 20-Ohm resistor, is s current at the 5-Ohm resistor. O 1.6 A ...

A:

Q: What determines the voltage at which a Zener diode break down?

A:

Q: Solve L{t*u(t – 1) + 8(t – 1)}.

A:

Q: When installing a surge arrester at the service of less than 1000 volts, the grounding conductor sha...

A: Equipment Grounding Conductor (EGC) – A conductive path that 's a component of a decent ground-fault...

Q: z2+3z Find inverse Z-transform of (z-1)²(z²+1)' 1

A:

Q: 4- If the input signal is 100KHZ, can we make sampling for this signal when it applied to the analog...

A: It is given that input signal is of frequency of 100 KHz and needs to be fed to analog pin of Arduin...

Q: Consider the circuit below: 34j 0 1200:2400 -10j 2 ) 1200Z 30° V 50 Q 100 Q -3j Q The transformer ra...

A: The solution is given below 

Q: Q1) For the circuit shown in Fig. 1, find the current I30 and the average power. Let v(t) = 15 sin(w...

A: The circuit diagram is shown below, Where,V(t)=15sinωt+60°+10sin2ωt+30° VandI(t)=5 sinωt A

Q: Find FT of e-*. Hence find FT of (i) F(x) = e¬ax* , (a > 0), (ii) F (x) = e-**72 (iii) F(x) = e¬4(x-...

A:

Q: In No-Load test circuit of single-phase transformer input power is equal to? In short circuit test o...

A: In this question,  We need to define the input power in case of open circuit test and short circuit ...

Q: [Q1] A uiform plane electromagnetic wave of frequency of 1 GHz and rms electric field intensity of 1...

A:

Q: 2n 2n cos (t 3. Find LT of F(t) 2n 0, t <-

A: Given   

Q: Rc 180 2 RR Vcc 15 V 3.9 k2 Bpc = 50 VBB 5 V

A:

Q: Current can not flow through an insulator because they have O a. free electrons O b. no free protons...

A: The electrons in the insulator's atoms are strongly bonded, it means they have no free electrons so ...

Q: find the total voltage (VT) in the network * VI V2 V3 lov 5V 5V +1 VT

A:

Q: In PCM system, it is the ratio of the maximum input voltage level to the smallest voltage level that...

A: In PCM system, it is the ratio of the maximum input voltage level to the smallest voltage level that...

Q: Subject : Electronics Engineering Draw circuits for both inverting and non-inverting amplifier usin...

A:

Q: in figure 1. 20 N 45 15 N 10 N

A:

Q: 1. Refer to Figure 1. A Y-connected source supplies balanced 3-phase loads. The source has voltag Va...

A:

Q: The Voltage RMS value of the waveform shown below is 50 V OV 15.9 V 25 V 35.35 V

A: Answer = 25 ( V )

Q: For the continuous-time periodic signal ã(t) below, determine the fundamental period To and fundamen...

A: It is given that:

Q: In a certain region of space, the electric field intensity has been mea be: E(z,t) = 6 x 10 cos(100t...

A:

Q: A certain radio wave has a wavelength of 7 inches. a. Convert the wavelength of this radio wave into...

A:

Q: 1. The input power to a 50 ohms receiver is 200pW. Determine the receiver gain required to produce 3...

A: In this question,  We need to determine the receiver gain  and losses in the dB.  We know  Power in ...

Q: In the circuit shown in Fig. 7, find the potential difference Vx – Vy 122 12Ω 12Ω 0.5A 122 12 2 122 ...

A: Reduce the circuit by combining the resistors in series and parallel . Now draw the modified circuit...

Q: Determine the resistance value (including tolerance) for each of the following resistors. a. (yellow...

A: Given resistor, The first band of the resistor is of yellow color which represents the first digit ...

Q: Example: Applying a series of source transformation, simplify the following circult. Show the Theven...

A:

Q: What happens to  the diode if the applied reverse-bias voltage becomes too great?

A: Given that we need to enumerate what happens if applied reverse bias voltage is too greater in a dio...

Q: Consider the below circuit with Vs (t) = 220 cos (100t) Vrms, R=1002, L=0.2H. Find: 1. The Complex, ...

A:

Q: 16. At a particular moment, the current in the primary coil is clockwise, as viewed from the seconda...

A: Transformer- Transformer is a device which is used to get output as increase voltage or decreased vo...

Q: What is the total gain of amplifiers with a power gain of 6, 8, 5 when connected in series? Oi ) 24 ...

A:

Q: here are 240 square meters of floor area in a house that contains an electric range rated as 12 kW a...

A: total floor area =240 square meter electric range =12 kW electric dryer =5000 W

Q: -12 V 10 kQ 2.7 kn. Si B = 75 3.3 kn 1 kn

A:

Q: If an unknown voltage is to be measured using an analog multi-meter, you should start from the. mult...

A:

Q: Derive the differential equation for RLC circuits and find the charge on the capacitor in an RLC ser...

A:

Q: Use a K-map to simplify the Boolean expression * E = A'B C'D +A'CD + A'C' + C O E = A + C O E = A' +...

A:

Q: Vo1 of the following circuit is equal to Ge Si 12 k2 Vog -10 VoK Vo 3.3 k2 A6 Tov 9V -0 7V O

A:

Q: 2. Using KCL, find the unknown currents shown in the figure 2. 2 A 7A I4 4 A 3 A Is

A: Given circuit,

Q: vcc ng 741 Vo v(in)(t) R1 741 VEE VEE R2 • Vin (t) = Vm cos (@t) 1V Vm = IV w 2 6283 rad/s %3D Measu...

A:

Q: Which statements are correct APU can supply to both AC buses if needed During normal startup of the ...

A:

Q: To test a diode using analog multi-meter, you should use what function? a. dc voltmeter O b. ohmmete...

A: 1.Answer:a. Dc voltmeter  To check whether diode is working or not we wil connect to Dc voltmeter mo...

Q: A 1-hp, 220 V, 60 Hz capacitor-start motor has main and auxiliary winding impedance at starting of 3...

A:

Q: Use a K-map to simplify the Boolean expression * E = A'B C'D + A'CD + A'C' + C O E = A + C OE= A' +C...

A: This question belongs to digital electronics. It is based on the concept of simplification of Boolea...

Q: 18. Listed or labeled equipment shall be installed, used, or both, in accordance with (a.) the fob s...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Draw a three-bulb circuit in which one of the bulbs goes out when the switch is closed, and two of t...

A:

Q: In a single phase circuit VA = 84.85 + j84.85 V and VB = 96.59- j25.88 V with respect to a reference...

A: