A dye cell at the Acme Clothing Factory uses 500 pounds ofdye each day. Th e dye is moved in vats at a rate of approximatelyone per hour. Each vat holds 10 pounds of dye. Management hasset safety stock at 10 percent. Th e facility operates 8 hours per day.How many vats should be used?

Q: ________ is a substance that may be used to keep food frozen while a component is being replaced on…

A: Solution:

Q: What is a solution to the following environmental risks in a SADA system Temperature Corrosion…

A: SADA system stands for Solar Array Drive Assemblies. These are the system in which the solar array…

Q: A family wishes to buy a 2020 Toyota Camry. The two options the consider are (a) a standard…

A: Given:Economy of SI engine, Vs=34 mpgFixed cost of SI engine, Fs=$18,000Economy of hybrid engine,…

Q: F G H 15 ft E A B C 10 ft 10 ft 10 ft 10 ft 10 ft 10 ft 10 ft 10 ft

A: Reaction At A and D are Ra and Rd lb. For drawing influence line we have apply imaginary unit load…

Q: tell whether the if work is done by the system (-), work is done on the system (+), or no work done.…

A: Work done on the system – when the work is done by the surroundings on the system, then it is known…

Q: Explain the statement: " Safeguards must not create new hazards.

A: Safeguards (guards, protective-devices) are protective measures that utilize particular…

Q: kilogram of wet steam is taken as a sample for study. It has a pressure of 0.805 MPa and an enthalpy…

A: For 0.805 MPa we have to use interpolation to get the values for saturation enthalpy

Q: The following instruments are used to measure the temperature: Select one: O a. Bi-metallic…

A:

Q: In cooling tower the blow down loss means a. the total water loss due to blowing of very fast air in…

A: When water evaporates in cooling tower dissolved solids such as Ca, Mg, Silica etc.remain in the…

Q: A water pump increases the water pressure from 10psia to 50psia. On your procedure sheet, check that…

A: Given: Initial pressure→Pi=10 psia Final pressure→Pf=50 psia So difference of…

Q: Suggest remedial measures for cleaning up the polluted environment in cities.

A: The remedial measures for cleaning up the polluted environment in cities are:

Q: In a service station vehicles arrive at the rate of 4 num- bers per hour. If service time per…

A: The arrival rate and service rate are,

Q: The dry bulb of a wet/dry thermometer reads 120°F. What is the relative humidity if the wet bulb…

A:

Q: Differential pressure flow sensors measure flow by measuring the pressure difference across a/an…

A: Following is the answer for the question

Q: Atmospheric air at 30°C & 30% relative humidity is cooled down through evaporative cooling What wil…

A:

Q: Answer the following: 1. What are the things we need to ensure when it comes to the sound and noise…

A: Solution:

Q: The critical point of a substance is th Select one: O True O False

A: False.

Q: rate of heat transfer. Wi

A:

Q: Employees with diabetes and other conditions often need to inject themselves at workplace to keep…

A: The answer to your question is:- Providing the education and training to all employees.

Q: How much should you charge to wash alI the windows in Seattle?

A: How much should you charge to wash all the windows in seattle? Assumptions  Seattle consists of…

Q: how do civil contractor check that they have reached 95% of the maximum dry density (proctor test)…

A: 95% compaction implies that the soil on the development location has been compacted to 95% of the…

Q: What percentage of microorganisms survive following treatment if the population is redu log…

A: L= percentage log reduction

Q: Heat that is added to, or subtracted from, a substance that changes its temperature but not in…

A: The heat that is added or subtracted from the substance that changes its temperature but not changes…

Q: Write equation for finding relative humidity and explain the procedure of finding relative humidity…

A:

Q: Q: Carry out calculations to mark the critical path and also complete the table? Activity…

A: The table for the data is given below, Activity duration Earliest start Earliest finish…

Q: Part A What pressure would you expect in a rigid container of 0° C gas cooled to -273° C? O zero…

A: Answer- zero pressure  When molecular momentum of the system becomes zero , the pressure reaches its…

Q: Differentiate between corrective and improvement maintenance.

A:

Q: Choose correct answer: ercury does not wet the wall of the tube of thermometer. Select one: True…

A:

General safety guidelines

Safety guidelines are the set of rules and codes that must be followed in the workplace for the occupational safety of workers, the machines, and the equipment that are present inside the workshop premise. There are many unsafe conditions and hazardous materials inside the workshop that makes prey for certain risk factors associated with health conditions. Extreme safety precautions must be taken inside the work area just like the precautions and practices that are been followed for Corona Virus Disease 2019 (COVID-19). People can also educate themselves by joining various health programs and camps. These will provide them with the necessary skills and knowledge about safety awareness. Occupational Safety and Health Administration (OSHA) thrives to create a safe and healthy environment for the workers working in the industries and provides them with proper education and training.