A) Consider solar PV system with following details: Radiation power input=980 W/m^2 Efficiency =30 % Current at maximum power point=9 A Open circuit voltage=36 V Fill factor=80 % Calculate the following: i) Voltage at maximum power point ii) Short circuit current iii) Maximum power

A) Consider solar PV system with following details: Radiation power input=980 W/m^2 Efficiency =30 % Current at maximum power point=9 A Open circuit voltage=36 V Fill factor=80 % Calculate the following: i) Voltage at maximum power point ii) Short circuit current iii) Maximum power

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: Solar water heating is less efficient than PV systems for exploiting solar energy. True False

A: Given Solar water heater is less efficient then pv cell True or false

Q: 4. A solar cell has an efficiency n of 27%. Calculate the fill factor if illumination with AM1.5…

Q: 10. It has been estimated that a minimum run-off of approximately 94 m3/sec will be available at a…

A: to determine the firm capacity and yearly gross output Qmin=94m3sec will be available throughout the…

Q: Calculate EIRP EIRP Data sent 400 mW +19 dBi Intentional -9 dB Radiator (IR) 6.

Q: An electric radiator is required to dissipate 1 kW when connected to a 220 V supply. If the coils of…

A: GivenPower dissipated by radiator=1KWsupply volatge=220 vdiameter of wire…

Q: Which of the following advantages correct of solar energy systems? O High system efficiency. Many…

A: Solar system is a renewable energy source or it is a free source of energy. Solar energy is a…

Q: Charging Station Solar Powered Charging time trial Design and Implementation of a Solar Powered…

A: Here a block diagram of a solar charging station is given. It represents the design and…

Q: 4. It has been estimated that a minimum run-off of approximately 94 m/sec will be available at a…

Q: Solar PV systems have large potential to produce large amounts of electricity in desert regions such…

Q: Assuming a global population of 9 billion people, each using approximately 100 W of power…

A: Total power consumed can be calculated as,

Q: A solar car has a roof dimensions of 133am x 95cm for solar cells. Calculate the electrical power…

A: Given that area of solar car = 133*95cm^2= 1 2635 m^2 Energy loss = 84% Constant light = 1031w/m^2

Q: Calculate the loss in PV power generation if the solar intensity is reduced to 800W/m2 and 500W/m2…

A: Given P=15kW 20 years Peak shine hours =6 hours Intensity=1000W/m2 To find loss in PV power if…

Q: If the dark saturation current of a solar cell is 1.7X10-8 A/m2, the cell temperature is 27 oC, and…

A: Given: Dark saturation current (Io)=1.7×10-8 A/m2Short circuit current (Isc)=250 A/m2Temprature…

Q: 13. Cell- System – Array _ module arrange the followings to be in the right way :

A: Solar energy is a form of renewable source of energy. It is converted to be used in the electrical…

Q: A PV module produces 294W maximum power at 1500 W/m2. Calculate the maximum power output at an…

A: In a PV module Maximum power output (P) is directly proportional to the irradiance level (G). P1=294…

Q: Under insolation conditions of 500 W/m2 (direct sunlight), and 10% solar cell efficiency (defined as…

A: Since vehicle is running at half power so power = 20 hp 20 hp = 20 * 745.7 = 14914 W…

Q: consumption in Oman is OR 0.020/unit (where, 1 unit = 1 kWH), Calculate the monthly electricity bill…

Q: Decide in key elements of energy management dter step 3 "set goals"then the next step is Option 1:…

A: The process is Set goals--->create action plan----->implement action plan----->evaluate…

Q: Which energy source would you prefer – geothermal or hydropower? Justify your answer.

A: Geothermal energy :the energy which presents in earth crust in form of heat is know as geothermal…

Q: The effective power of a motor, which is connected to a 220 V electricity network, is 400 W. Please,…

A: We need to find current for given power and voltage

Q: A 250 V, 1.5 kW single element electric furnace is to employ a nichrome wire operating at 900°C.…

Q: A) Consider solar PV system with following details: Radiation power input=990 W/m^2 Efficiency =26 %…

A: Dear student as per our guidelines we are supposed to solve only one question kindly repost the…

Q: It has been estimated that a minimum run-off of approximately 94 m3/sec will be available at a…

A: Given: Head, H=39 m Minimum run-off is approximately 94 m3/sec.

Q: c) A church building has the outside dimensions of 100 feet x 200 feet, if the volt-ampare required…

A: Minimum lighting load: It is obtained by multiplying the square foot by a minimum factor 3. This is…

Q: A 44KV, 50 Hz overhead transmission line connects Ibra and Muscat. There are three units in a string…

A: Given, Csh=0.2Cs where, Csh is the shunt capacitance and Cs is the series capacitance.

Q: An electric radiator is required to dissipate 1 kW when connected to a 220 V supply. If the coils of…

A: Given that for an electric radiator: Power dissipated (P) = 1 kW; Supply voltage (V) = 220 Volt;…

Q: solar

Q: Subject: Renewable Energy System Describe the following; 1. Distributed Flexible Load…

A: 1. Distributed Flexible load The flexible load's role is to give distributed flexible energy in the…

Q: If a PV cell will produce 7-9 watts per square feet, suppose if the rooftop area is 19ftX7 ft then…

Q: e delivered. (ii) Calculate the voltage across R, then terminal A being positive 20 2 OA 40 2 SRL 10…

Q: Calculate the percentage efficiency of a solar PV module whose length is 139 cm and width is 117 cm…

A: For the given solar PV module length (l)=139 cm width (w)=117 cm solar irradiance, P/m2=971 W/m2…

Q: A school classroom with the general dimensions of 20 x 30 feet is lighted with 10 fluorescent lamp 4…

A: lux=lumens×Cu×mfarea

Q: 1. A small wind turbine has a blade of diameter 170 cm and is subjected to a wind turbine of…

A: Given Data: d = 170 cm radius = 0.85 m v = 6 m/s Cp = 0.3 density of air = 1.2 kg/m^3

Q: With improvement of efficiency of the PV Module, we can improve a. its Surface Area b. its output…

A: In this question , we will write With improvement of efficiency of the PV Module, we can improve..

Q: A three-axis stabilized satellite has two solar arrays. Each array has an area of 5m². At the…

A: According to the question we need to, a. Calculate the efficiency of the solar cells at beginning of…

Q: There is a thermoelectric power plant with an output of 500 MW, thermal insulation efficiency of…

A: Given: Output Power,Po = 150 MW = 150 x 106 W rat of coal consumption = 60 tons/h Heating value of…

Q: A solar car has a roof dimensions of 141cm x 105cm for solar cells . Calculate the electrical power…

A: solar car has a roof dimensions of 141cm x105cm Calculate the electrical power available, assuming…

Q: 3.2 A three-axis stabilized satellite has two solar arrays. Each array has an area of 5 m?. At the…

A: According to the question we have to calculate the value of efficiency of the solar cells at the end…

Q: A house installed PV system produces 25 kWh of power for 12h daylight hours when a peak value of the…

A: We need to calculate solar area for given system

Q: A PV module produces 254W maximum power at 1000 W/m². Calculate the maximum power output at an…

A: Given that Photovoltaic device (PV) produce maximum power of at . The output maximum power of a PV…

Q: B- Discuss the following claimed arguments: YOU HAVE TO USE YOUR OWN WORDS. DONT COPY AND PASTE FROM…

A: (1) Solution: Combined Power stations might be more successful considering the financial and…

Q: Q19. A site has a wind that blows at 1 atm pressure, 15°C and contained in 1 m² of: a- A steady 6…

A: Given that Atmospheric pressure =1 atm at 15 degree Celsius Air density at given temperature and…

Q: The process of developing engineering devices, products, and systems that use the available…

Q: ________ allows free will but within limits set by Allah a. None of the options b. Islam c.…

A: Freedom of choice for all. If he desires a good and righteous way, he has the power to do so; and if…

Q: A PV module produces 263W maximum power at 1100 W/m². Calculate the maximum power output at an…

A: The maximum power output at an irradiance level is given by maximum power x irradiance level/…

Q: A natural waterfalls, 50 meters high, constantly discharges 1.3m3 per second. A mini hydroelectric…

A: Given that h=50 mr=1.3 m3/sηm=90%ηT=70% Although for given power system , formula for electric…

Q: Renewable Energy Sources are readily available everywhere, whole year round. Select one: True False

A: Renewable energy sources are readily available everywhere, whole year round

Q: Maximum Power Point (MPP)- support your answer with a sketch (ii) Fill Factor (iii)…

A: (i) MAXIMUM POWER POINT (MPP): 1. When compared with other methods of energy, solar power technology…

Q: HOMEWORK 3: Design a grid-connected PV system for fulfilling the load energy requirement of 25…

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

A) Consider solar PV system with following details:
Radiation power input=980 W/m^2
Efficiency 30 %
Current at maximum power point=9 A
Open circuit voltage=36 V
Fill factor=80 %
Calculate the following:
i) Voltage at maximum power point
ii) Short circuit current
iii) Maximum power

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 120 V, 60 W lamp is to be operated on 220 V, 50 Hz supply mains. For the lamp to operate in correct voltage, calculate the value of (i) non-inductive resistance and (ii) pure inductance (U.P.T.U. 2005–06)
The type of output voltage from a Solar PV module is a. DC b. AC
aloulated m O1 the value you Up = A cos wt +1o Calaulate maarli)-min(i) =? Use constant voltage drop mad. Don7 to write units. . - 3.7V forget
Discuss typical structure of the modern electrical grid. Include all elements and provide short description of their role in the system
Discuss wind power in future power system
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
Discuss the prime mover and the conversion of power energy for thermal station
Explain V-I and PV characteristics of solar cell or PV systems
Magnetically coupled circuit example
Briefly explain environmental issues in regard to thermal power plants
Discuss solar energy in future power system
4.Suspension string has 3 units. Each unit can with stand a maximum voltage of 11kV. The capacitance of each joint and metal work is 30 percent of the capacitance of each disc. Find i) Maximum line voltage for which the string can be used?