A complex flow system expands helium from 1500 K, 1000 kPa to 500 K, 100 kPa. In the process this produces 4595 kJ/kg of work. The process exchanges heat with a reservoir at TR. If the process is reversible, find the unknown reservoir temperature (K). You can work this with either Thermofluids or the equations... Your choice. If equations, Cp=5.19 kJ/kg-K, Cv=3.12 kJ/kg-K, R=2.08 kJ/kg-K. Helium 1500 K 1000 kPa TR q 500 K 100 kPa W=4595 kJ/kg

A complex flow system expands helium from 1500 K, 1000 kPa to 500 K, 100 kPa. In the process this produces 4595 kJ/kg of work. The process exchanges heat with a reservoir at TR. If the process is reversible, find the unknown reservoir temperature (K). You can work this with either Thermofluids or the equations... Your choice. If equations, Cp=5.19 kJ/kg-K, Cv=3.12 kJ/kg-K, R=2.08 kJ/kg-K. Helium 1500 K 1000 kPa TR q 500 K 100 kPa W=4595 kJ/kg

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 30RQ: A gas is compressed inside a compressor's cylinder. When the piston is at its bottom dead center,...

See similar textbooks

Similar questions

During an isentropic non-flow process with air, the pressure drops from 75psia to 30psia. The air has mass of 0.25 lbm and the initial temperature was 265°F. Find: a. The final temperature, in °F b. The heat transferred, in BTU C. The change in internal energy, in BTU d. The work done, in BTU
During an isentropic non-flow process with air, the pressure drops from 75psia to 30psia. The airhas mass of 0.25 lbm and the initial temperature was 265°F. Find: a. The final temperature, in °Fb. The heat transferred, in BTUc. The change in internal energy, in BTUd. The work done, in BTU
An automobile tire is inflated to 105 kPa at 30 deg. C. After being driven the temperature rises to 55 deg. C. Find the final pressure under isochoric process.
For a system entropy is constant if initialvolume & Pressure of a gas is 10m^3 ,7 barrespectively. Final volume is 5m^3 then find the final pressure.
Two vessels A and B of different sizes are connected by a pipe with a valve. Vessel A contains 142 L of air at 2,767.92 kPa, 93.330C. Vessel B, of unknown volume, contains air at 68.95 kPa, 4.440C. The valve is opened and, when the properties have been determined, it is found that pm = 1378.96 kPa, tm = 43.330C. What is the volume of vessel B?
Q1. A vapour compression refrigeration uses R-12 as a refrigerant and the liquid evaporates in the evaporator at - 15°C. The temperature of this refrigerant at the delivery from the compressor is 15°C when the vapour is condensed at 10°C. Find the C.O.P. if (i) there is no under cooling (ii) the liquid is cooled by 5°C before expansion by throttling. Take specific heat at constant pressure for the superheated vapour as 0.64KJ/kg k. and that for liquid as 0.94KJ/kg k the other properties of refrigerant are as follow: a) Temperature b) 0°С с) Enthalpy(KЈK)) d) Entropy(KJ/kg k) e) liquid _j) 22.3 0) 45.4 f) Vapour k) 180.88 g) liquid 1) 0.0904 9) 0.1750 h) Vapour m) 0.7051 i) -15 n) 10 p) 191.76 r) 0.6921
Find the work posses for a carbon dioxide gas at 1,995.59 C in kJ/kg. (Use W = mRT)
Example 4-2:A rigid tank of 1 m contains nitrogen gas at 600 kPa, 400 K. By mistake someone lets 0.5 kg flow out. If the final temperature is 375 K what is then the final pressure?
2) Water vapor enters a continuous flow adiabatic turbine at 15 MPa pressure, 500 °C temperature and 90 m/s velocity, and exits at 20 kPa pressure, 92% dryness and 80 m/s speed. Since the mass flow rate of the steam is 43.2 tons/h, a) The power produced in the turbine (in MW, HP, ton.km/h), b) Find the turbine inlet and outlet cross-sectional areas (in m2, cm2).
1 kg of steam at initial conditions of 5.1 MPa and 370 °C expands in a turbine until it becomes saturated. It is withdrawn and reheated to 340°C. After further expansion in the turbine to 160 , part of the steam is extracted for feedwater heating. The remaining steam expands to the condenser pressure of 0.018 MPa. find Wnet, Ec, Ee and the ideal steam rate. Remember, 1. For values taken from the steam tables: Use them as is, do not round off. 2. For values obtained by interpolation and final answers obtained by solving, use FOUR (4) decimal places. 3. PLEASE USE THE STEAM TABLE PROVIDED: https://drive.google.com/drive/folders/15t3WMv7xSTHmwXWXp0X2ZV6aYWhXuRCS?usp=sharing
Steam to a turbine at a mass flow rate of 1.4 kg/s, 700 kPa pressure and 400 °C enters the temperature. Steam at 100 kPa pressure and 1.4 m3/kg specific volume exits the turbine. Heat transfer from turbine to environment 50 kW, with turbine Since the boundary temperature between the environment is 70 °C, a) Find the power produced by the turbine, entropy produced in the turbine and isentropic efficiency of the turbine. Note: The changes in kinetic and potential energies will be neglected and T (K) = 273 + °C will be taken.
A closed constant-volume system receives 10Kj of paddle work. The system contains a nitrogen at 340kpa, 5C and occupies 0.1m^3. Find the heat in KJ (Gain or Loss) if the final temperature is 127C. Please use: Q=AU+W (Observe direction) ideal gas equation to find mass table.