A commutator segment has 556 segments. Indicate whether or not the winding is possible; triplex wave for 6 poles.

Q: What is the value of Vx in volts if I = 1.2 A and V = 9 volts. 50 10Ω 150 V + Answer:

A:

Q: Find inverse Laplace transform of 10 F(s) = (s + 2)(s² + 6s + 10)

A:

Q: Create a ladder diagram that will result to:  a. Lamp L2 and Lamp L3 deactivated while Lamp L1 acti...

A: It is asked to draw ladder diagram for the given conditions for three lamps. The given conditions ar...

Q: 100nF Input Voltage AC Voltage 1MQ 5 сарacitor 5V diode 1N4001 -5 3V

A:

Q: If R, has twice the value of R2 and R2 has three times the value of R3, what would b voltage Vx in v...

A:

Q: Determine the state of diode for the circuit shown in Fig. (i) and find Ip and Vo. Assume simplified...

A:

Q: VIII) Find  (i) 11010101.11102 + 10101011.1010112         (ii) 1010101.112 – 1100.1012 (iii) 110001....

A: As per our guidelines we are supposed to be answer the first 3 subparts. Kindly repost the other que...

Q: In the circuit of Figure 10-3, assume you found that I, was the same as the current in R3 and R4- (a...

A: Given circuit:

Q: Problem2. A noninverting current amplifier is shown below. Calculate the gain i/i, Take Ri = 8 kn an...

A: This question belongs to analog electronics . It is related to operational amplifier (op amp). It is...

Q: assume an operational amplifier is working on inverting amplifier in which it takes input resistance...

A: Given

Q: A DC motor with a shunt field winding has the following characteristics: Vr = 96.0 V R, = 1.50 2 K= ...

A: Given: A DC motor with shunt field winding have VT=96 VRA=1.50 ΩK=0.352 mT=18 Nm  

Q: Assume the source is Wye connected and the phase voltages are 2kV. What is the phase to phase voltag...

A: phase voltage- Phase Voltage is measured between an individual phase and Ground. Where line voltage ...

Q: Compute the energy stored in capacitor.* 6 H 10 A 16Ω 2Ω VC =4 F None of thechoices are correct 350 ...

A:

Q: The sum of 2D RCS vectors (A + B) is equal to 7a, + 13a, while their difference (A - B) is equal to ...

A:

Q: Design the CMOS diagram for the following Table: (A, B & C are the inputs and Y is the output in the...

A: We have to design the cmos diagram 

Q: Explain Moving coil instrument with principle, operation, advantages, disadvantages and diagram.

A: Principle: The basic moving coil instrument working principle is that when a current carrying conduc...

Q: Compute the resistance of a conductor whose resistivity is 20.54 ohm-CM per foot with circular cross...

A: Given Resistivity=20.54 ohm-cmcross sectional area=38mm2=38×(10-3)2m=38×10-6 mlength=5 Km=5000m

Q: Question: C Hindi In a digital oscilloscope, the A/D converters are usually

A: There are mainly two type of A/D converter are used in digital oscilloscope SAR type and flash conve...

Q: Explain with an example, the compromise between frequency resolution and time resolution in the esti...

A: Bartlett Method- Bartlett method is used for the estimation of power spectra. It gives a way to redu...

Q: Explain Transducer classification adding EXAMPLE to each category.

A: Transducer - A transducer is a machine that, when activated, converts one form of energy to another....

Q: Why there is a need to study about digital Electronics?

A: Given: Digital electronics

Q: Three concentric spherical shells carry charges of 10 mC, 6 mC, and 4 mC. The radius of the outer sh...

A:

Q: -10-22 eV Conduction band Band gap Ey blence band "Bands" are composed of closely spaced orbitals a ...

A:

Q: 3. C3 and C4 are connected in parallel with each other. And together, they are connected in series w...

A:

Q: A carbon resistor dissipated 60 W of power from a 120 V source at 20°C. How much energy will be disp...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: 3Ω 42 WW- I 452 64V

A: Given circuit diagram

Q: 1. Identify the different symbols seen in the schematic diagram. Write it in a piece of paper and ca...

A: The given circuit is as shown below, We need to identify the symbols in the circuit and make a bloc...

Q: If R1 is in series with a parallel combination of R2, R3, and R4, when the resistance value of R2 in...

A: This question belongs to circuit theory . It is based on the dependency of voltage and current on th...

Q: Explain Moving coil instrument with principle, operation, advantages, disadvantages and diagram

A:

Q: The armature winding of a 4-pole, 250 V d.c. shunt motor is lap connected. There are 120 slots, each...

A: Here, we have an armature winding. The slots and conductors are defined. The current taken by the mo...

Q: A transmission line operating at 500 MHz has Z, 80 2, a = 0.04 Np/m, B = 1.5 rad/m. Find the line pa...

A: It is given that: f=500 mHzZo=80Ωα=0.04 Npmβ=1.5 radsec

Q: Which one of the following equations is correct? The mesh at which each equation might be derived is...

A: While applying mesh-analysis in a loop, we take (+) sign while moving from - to + terminal of a batt...

Q: Problem 1: Write the differential equation (i = f(V)) of the given circuit   Procedure:   Apply ...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: specifications which includes the following information: Range: + 30 mm; Accuracy: 0.5%; Sensitivity...

A: According to problem given above, the Linear Variable Differential Amplifier will have: Range of ±30...

Q: In a series circuit of 2 resistors 22000 and 45000 with an impressed voltage of 10, what is the circ...

A: In this question,  We need to determine the current in the circuit?  If two resistances are connecte...

Q: 2µF |2µF 12v |2µF ]4μF

A: Brief description : In the given question they have mentioned a circuit which consists of series and...

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A:

Q: x 0.1j 1 Z12 =0.1 j Z23=0.1j YA 0.2AY 02 AY 0.1 j İLoad 1 Load 2 Load 3 Consider the single line dia...

A:

Q: Example(6): Determine the values of currents In ,2 &I3. RI R2 I1 V1 =10V+ V2-20V R3 0n 13

A: We need to find current for given circuit

Q: Find the Thevenin equivalent at terminals a-b of the circuit in Fig. J2 Ω ll 6Ω a b 75/20° V -j4 2 1...

A:

Q: Explain how you could use an ohmmeter to identify the cathode of an unmarked diode.

A: Given: Ohmmeter

Q: The image below shows a Simple resistor circuit with multimeter measuring current. What is the the ...

A: The given resistor circuit with multimeter measuring current is shown below, Where,R1= 240 ΩV1=5V

Q: Vz-0.98 - 0.06 j Z12 400 MW 250 Mvar Z13 Z4 24 Slack Bus 3 V = 1.05+0.0j V - 1.0-0.05j Va- 0.95 - 0....

A:

Q: 41. Two ac sources feed a common variable resistive load as shown in figure. Under the maximum power...

A:

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A: We need to find out output voltage for given input .

Q: station is delivering its full output. 3. A 65,000 kW steam power station uses coal of calorific val...

A: 3) Given data : Power, P= 65,000 kWLoad Factor = 40% = 0.4

Q: The bus voltages of the network

A:

Q: QUESTION 4 Simplify the following Boolean expression: AC' + A'C + A'C' + AC O A O AC 0 1

A:

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A: Brief description: According to the circuit arrangement we can easily say that the given circuit is ...

Q: What is that the sum of all the voltages, as you go around a dc circuit from some fixed point and re...

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.