A coil of 0.5 H inductance and 8 ohms resistance is connected in series with a capacitor across a 200 V, 50 Hz supply. If the current is in phase with the supply voltage, determine the capacitance of th the capacitor and the p.d. across its terminals. Answer: [20.26 µF, 3.928 k]

A coil of 0.5 H inductance and 8 ohms resistance is connected in series with a capacitor across a 200 V, 50 Hz supply. If the current is in phase with the supply voltage, determine the capacitance of th the capacitor and the p.d. across its terminals. Answer: [20.26 µF, 3.928 k]

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: 1. R1 1Ω V I 2 A E 24 V R2

A: We need to find out current and voltage for given circuit

Q: The value of form factor

Q: ОP-AMPS Derive the value of Vout in terms of V1, V2, R1, R2, Rf in the circuit below. V1 R1 1k2 1V…

A: In this question, We need to derive the value of Vout in terms of V1, V2, R1 and R2 and Rf .

Q: T-L with Zo=6000 ,ZR = 100 Q. Find the length and location of the single stub terminated by short…

Q: What is the low frequency break point due to the capacitor Cs for this BJT amplifier (Amplifier A)?…

A: According to the given data, the circuit will be as shown below,

Q: For the network function T(s) = the resonant frequency and s +2s +100 bandwidth are respectively.

Q: QV A: For the power system shown, calculate fault current and when a 3-phase fault occurs at point…

Q: Given the discrete time signal x[n] = cos((πn)/3) what are two different contiuous time signals…

Q: A 5 KVA , 240/2400v , 50hz. ,single phase transformer has the maximum value of flux density as 1.2…

Q: Given the analog signal x(t) = sin(480πt)−3sin(720πt) that is sample at 600 times per second, what…

Q: Derive the relationship between the output, and the input for the RLC network circuit shown below:…

Q: Discuss the potential risks to the operation of a DC motor associated with the application of a full…

A: In this solution, the discussion is about DC motor operation.

Q: JA single-phase, 250-kVA, 11-kV/415-V, 50-Hz transformer has 80 turns on the secondary. Calculate…

A: We need to analyse the given transformer .

Q: Compute for the Frequency Resonance of the Circuit

Q: a, (t) = 0.5e(180nt+ ) + 0.5e¬j(180zt+4) is sampled at F, 300 Hz.

Q: Compute for Z, (input impedance) of the given circuit. -022 V 5.6 k2 330 k2 Cc B= 80 T,= 40 k2 Cc Z,…

Q: 4. A superheterodyne receiver is to tune the range 88.1MHZ to 107.1MHZ. The RF circuit inductance is…

A: Since you have posted a question with multiple subparts, we will solve the first three subparts for…

Q: For the network function T(s) =7+2s +100° ,the resonant frequency and bandwidth are respectively.

Q: R1 = R'2 = 0.08 Q X1 = X'2 = 0.2 Q Re = 1000 Q; Xm = 400 Q It is supplied to the load Z' at 240 V, 6…

Q: Electrical Circuit Analysis Lab. 3. Calculate the value of the load for maximum power transter and…

Q: {Q.1} A three-phase induction motor runs at almost 1198 revolutions per minute (rpm) at no load…

Q: The FIR filter which its transfer function H(z)3D can be realized as shown in figure below

A: According to the question, for the circuit shown below We need to find the transfer function.

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

Q: 5.09 Transformer A: KVA=10 Transformer B: KVA=5 Re"=0.3 ohm Xe"=0.4 ohm 220:110 v Re"=0.6 ohm…

A: Given: Two transformers have the following parameters: Transformer A: kVA=10, Re''=0.3 Ω, Xe''=0.4…

Q: 2. How is transformer insulation divided? Briefly indicate the insulation arrangement indicating the…

A: Transformer insulation need to withstand very high impulse voltage.

Q: 1-(3coswo)z 1 1-(2coswo)z-1+9z-2 X(2) for the sequence x(n) =(3" coswon)u(n) is

Q: A second order system has damping ratio 0.2. The nature of step response will be a. straight line b.…

A: Given data, A second order system with Damping ratio, ζ=0.2

Q: 2. Express the unit vector å, in spherical components at the point: (a) r = 2, 0 = 1 rad, o = 0.8…

Q: O Presentation5 O File | file:///C:/Users/tphok/Downloads/HW%205.pdf Update : 3 / 4 | 90% +| E O…

Q: Three-phase transmission line 90 km long Line impedance z=(0.4+j0.88) ohm/km, Y=j5*10^- 6 S/Km,lf…

Q: -1,5z X(2) for the sequence x(n) = 2" u(-n - 1)-)" u(-n - 1) is- (z-2)(z

Q: Consider a stable LTI system with input x(n) and output y(n). The zero-pole pattern of y(n) consists…

A: In this question we need to find system function and the system impulse response.

Q: Discuss the importance of the capability curve of a synchronous machine. Explain how a capability…

Q: (a) Digital Convolution Consider an LTI system that has an impulse response h[n] given in the figure…

Q: Stepper motors are used to drive the two axes of a component placement machine used for electronic…

A: Stepper Motor: A stepper motor is an electric motor whose fundamental feature is that its shaft…

Q: The z-transform does not exist for the sequence x(n) = 3" u(n) - u(-n- 1) %3D

A: The solution is given below

Q: 28. Write the analytical expression for the waveform of Fig. 86 with the phase angle in degrees.

Q: R1=10 k2, R2=5 k2, R3=10 k2, R4-5 k2, determine the output voltage Vo of the circuit in Fig. 5 (V1…

Q: What is the complex expression for a given alternating current i = 250 sin(wt-25 deg)?

Q: To realize the system function shown below using IIR direct form I, you will need to 5 delay, adder,…

Q: A short single phase transmission line consists of two sections AB and BC. AB is 18km in length and…

A: The solution is given below

Q: *2. Using superposition, determine the current I for each network of Fig. 18.110. R Iz 32 62 E = 10…

Q: d=o 48 need to convert the drawing from a handwritten drawing to a typeface on the computer, please

A: Given, The drawing is,

Q: 2. Using mesh analysis, write the mesh equations for the following network and solve for the current…

Q: The ROC is null for the sequence x(n) = 2" u(n)-)" u(-n - 1)

Q: The figure below shows an electronic PID controller constructed using OP-AMPS. Determine the values…

Q: X(z) for the sequence x(n) = 2n-3 u(n – 3)is z-3. %3D (1-2z-3)

Q: using Laplace Transformation if v(0)=3[V] & v (0)=4[V] i(t) Vs(t) v(t) Solution:

Q: A counter counts in the sequence 1-3-4-5-6-9-8, then repeats. What is the MOD of the counter?

A: Counters are known to be sequential logic circuits. They can be synchronous or asynchronous.

Q: 50. Find the rms value of the periodic waveform in Fig. 101 over one full cycle. I ycle 6 7 $ 9 D 11…

A: We need to find out RMS value for waveform .p

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
Find the following. A, the phase angle between the supply voltage and current. B, the voltage across the inductor coil. C, voltage across the capacitor.
A capacitor has a capacitive reactance of 400 2 when connected to a 100 V, 25 Hz supply. Determine its capacitance and the current taken from the supply.
1:three 12f capacitor are connected in series across 750v supply .calculate A. The equivalent capacitance B.the charge on each capacitor C.the p.d across each capacitor.
Identify which of the following statement is true, if two capacitances of the same value are present in the circuit, the equivalent capacitancecan be half the value of given capacitance. a. If the capacitances are connected in series. b. None of the given option c. It is not possible d. If the capacitances are connected in parallel.