A circular cylinder of radius r and height h is located with its axis coincides with the z axis and its bottom sits on the x-y plane. Use the cylindrical coordinates system to find the area of the curved surface defined by r = 2 m, h = 5 m, and 30° ≤ ≤ 120°.

Q: (INPUT) 01 01 A B C BCD- to- 7 seg. decoder/ driver a 7- Seg. Display (output) What number will be…

A: In this question We need to determine the number will be display in the screen when input is 0101.…

Q: 4. For the base-biased npn transistor in Figure 4, Vcc= 10V, RB = 68 kilo-ohms and Rc = 1.0…

A: Apply KVL in the base to emitter loop                                                       10-1×IC…

Q: 3. An analog signal is given by v(t) = 2Vsin(2 450t) + 3Vsin(2¬250t + 300°) + 1.5Vsin(2+800t): a)…

A: According to the bartleby's guidelines we have to solve only first three subparts of a question so…

Q: 10.9 In a medium, -0.05x *sin (2 × 10³t - 2.x) a. V/m E = 16e find: (a) the propagation constant,…

A:

Q: A DC DC motor should be operated a strong field which is due to the What happens to suddenly goes a)…

A: motor operating in strong field due to current if suddenly if = 0 what happens to rotating motor

Q: a. Consider the following energy band diagram for the junction and determine the built-in potential…

A: given here  a energy band diagram and asked to find the built-in potential.

Q: 3. Encode a binary word 110101 into an even parity hamming code.

A: Here we have to find the encoded word.

Q: Figure 7.4 shows two 11 kV generators feeding a 132 kV double circuit line through gen- erator…

A: Given data Gen-1 11 kV, 125 MVA, X=28% Transformer-1 11/132 kV, 125 MVA, X=28% Transmission line…

Q: 1 4 Ω 20 ΩΣ 120 V 2 (40/3) in + + 2 Ω ΟΔ 40 Ω 3 0 8 Ω m 80 Ω 4 › 1.75 VA

A:

Q: 5. What charge is on a 75 micro-F capacitor when it is connected across a 120-V source?

A: Capacitance C= 75 micro farads.                                            = 75*10-6F Voltage V =…

Q: A single phase, 60Hz, short transmission line receives 700 MW at 0.95 lagging pr at 327.8 KV from…

A:

Q: 8. Design the network of the following circuit to maintain V₁ at 12V for a load variation (IL) from…

A: In this question We need to determine the rating of the zener diode.  We know  Power P= VZ IZ

Q: With reference to Figure 3 (b), use source transformations to determine the voltage Va R₁30 E₁7 8,60…

A: The resistance opposes the flow of  current.  The voltage source with series resistance is…

Q: Suppose that a certain npn transistor has UBE=0.7 V for ig = 11 mA. Assume that VT =26 mV. Part A…

A: What is NPN Transistor? Signal amplification is accomplished using NPN transistors, a three-layer…

Q: 11.35 Determine the complex power for the following cases: (a) P = 269 W, Q = 150 VAR (capacitive)…

A:

Q: Question-7b For an amplitude modulated double sideband full carrier wave, a peak unmodulated carrier…

A: Given- An amplitude modulated double sideband full carrier wave, Peak unmodulated carrier voltage-…

Q: 3. Given the sinusoid current i(t) = 74 cos(24t +7°) A, find the period and frequency.

A: In this question we need to find the time period and frequency of the given sinusoidal current.

Q: 3. Consider the circuit in Figure 3. (use ideal diode model in the related calculations) (a) What…

A:

Q: 10. Excitation losses in a transformer must be determined. When running the test, you should make…

A: Losses in Transformer  Ohmic loss  Excitation or Core loss Hysteresis loss Eddy current loss…

Q: A lossless transmission line of electrical length, 1 = 0.352, and of Zo= 100 [2] is terminated in a…

A: Given data, Length of the transmission line l=0.35λ Impedance Z0=100 Ω Load impedance ZL=60+j30 Ω

Q: 7. Determine the center frequency and bandwidth for the filter shown in Figure 7

A: The given circuit is a band pass filter designed by cascading the low pass and high pass filters.…

Q: 8.22 Consider a random variable X defined by the double-exponential density fx(x)= a exp(-bix).…

A: Probability Density Function In probability theory, the likelihood that a random variable will fall…

Q: solve for io(t)

A: Given: A network, To find: Value of i0(t).

Q: 3. A 20 ohm resistor is connected in series with a coil of inductance 80 mH and negligible…

A:

Q: 3. A plane wave with magnetic field ¹ = ŷ5e¯jkox/√²e-jkoz/√2 is incident at 45° from free space onto…

A: Given data Incident Magnetic field, H→i=y∧5e-jk0x/2e-jk0z/2 Incident angle, θi=45° Medium…

Q: Determine the closed-loop gain and output impedance of the two-stage op amp in Fig. 5. Hint: break…

A:

Q: The switches in the figure below have been closed (left switch) and open (right switch) for a long…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: solve Vo(t) with nodal analysis

A: In this question,  We need to determine the Vo  as shown the circuit using the nodal analysis.  We…

Q: Compute for the average and rms values of the voltage v(t) = 440cos(2513t + 195 degree) V.

A:

Q: VBV (GaAs). 100 V VBV (Si) Is (GaAs) 50 V I, (Si) VKV (Ge) 304 25 20 15 10 5 I, (Ge) ID (mA) 0.3 0.7…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: 1. Find i 2Ω 5Ω www 6V + 1Ω 4Ω 4) 3 A 12 V

A:

Q: (a) (b) (c) Sketch the spectra of m(t) = cos(2л50t) + 2 cos(27150t) and m(t) = sin (2n50t) sin…

A: As per Bartleby guidelines we need to answer the first three questions only.  Kindly repost the rest…

Q: Consider the given network, where Vx= 3.7 V. 45 92 Vx 75 92 12292 220 2 0.3 A Employ Thévenin's…

A:

Q: A long shunt compound generator has a shunt fiel winding of 1000 turns per pole, and a series field…

A: Given that The Field current to be increased is, ∆If=0.2 A Turns in the shunt field winding, Nf…

Q: For the CE voltage-divider configuration, calculate the input impedance. A B D 533 02 757 Ω 949 Ω…

A:

Q: There are 4 permutations: natural response and step response for both parallel and for series RLC…

A: From the  given questions it is asked to solve first. 4 permutations of natural and step response…

Q: For the circuit diagram below: a. Find the voltage Vout and the current Ix. b. Find the current Iy.…

A:

Q: 6. For the RC circuit given below. E 60 V R₁ ww 12 ΚΩ ic June C 6.8 μF vc a) Determine the time…

A:

Q: 33 For the following voltage and current phas calculate the complex power, apparent power, real…

A:

Q: 1.Equivalent resisitance through entire system 2.Current being drawn from battery 3.Current flowing…

A:

Q: Solve for the modulating voltage of an audio signal necessary to provide 99% modulation of a 225V…

A: Given data Modulation percentage, μ=99% Carrier voltage, vc=225 V The modulation percentage of 6…

Q: 3) For the circuit shown in Figure 3, determine the voltage gain. A= 4 B = 1 C = 5 D = 1 Answer:…

A: Given: In this question, the given details are, The given circuit diagram is, To find the voltage…

Q: Given the admittance below,  Y = 1/30  + j(1/10) The circuit is a. purely resistive b. not enough…

A: Given, The total admittance of circuit is Y = 1/30 + j(1/10) We need to determine whether the…

Q: In a series circuit, the current is The highest near the positive and negative terminals of the…

A: In this question We need to choose the correct options.  If two resistances R1  and R2  are…

Q: 5. What charge is on a 75 micro-F capacitor when it is connected across a 120-V source?

A: In this question,  We need to determine the charge across the capacitor.  We know Charge Q= CV

Q: 3. F(A,B,C,D,E) = A'B' + ABCD + A'B'C' + D'E' + AB'C'DE' + A'C'E' + C

A:

Q: Given the following system, determine the response of the system, the roots of the system, the…

A: Given,  Transfer function of system is C(s) /R(s) = 4/[s2+4s+4] We need to determine system…

Q: expression and draw the logic circuit. the standar 001 010 011 100 Table Q2 INPUTS ABC 000 OUTPUT X…

A: Given,

Q: 2. Find a 1/2RC for parallel and a-R/2L for series

A: 2) We need to find α for both series and parallel RLC circuit.

Q: An AM transmitter is modulated by two sine waves at 1.5 kHz

A: Given frequency f1=1.5 KHZ                            f2=2.5 KHZ                            m1=30…

Rectangular Coordinate System

In a rectangular coordinate system, each point based on the pair of coordinates is specified uniquely in the plane. From two fixed perpendicular lines, these coordinates are at a distance in the rectangular coordinate system. Each line is known as the reference axis and axes as plural. The point where they meet is called the origin (0,0).