A child on a sled starts from rest at the top of a 15.0° slope. If the trip to the bottom takes 15.2 s, how long is the slope? Assume that frictional forces may be neglected. a) 147 m b) 586 m c) 294 m d) 923 m

A child on a sled starts from rest at the top of a 15.0° slope. If the trip to the bottom takes 15.2 s, how long is the slope? Assume that frictional forces may be neglected. a) 147 m b) 586 m c) 294 m d) 923 m

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter5: Newton's Law Of Motion

Section: Chapter Questions

Problem 89AP: In building a house, carpenters use nails from a large box. The box is suspended from a spring twice...

See similar textbooks

Similar questions

A basin surrounding a drain has the shape of a circular cone opening upward, having everywhere an angle of 35.0 with the horizontal. A 25.0-g ice cube is set sliding around the cone without friction in a horizontal circle of radius R. (a) Find the speed the ice cube must have as a function of R. (b) Is any piece of data unnecessary for the solution? Suppose R is made two times larger. (c) Will the required speed increase, decrease, or stay constant? If it changes, by what factor? (d) Will the time interval required for each revolution increase, decrease, or stay constant? If it changes, by what factor? (e) Do the answers to parts (c) and (d) seem contradictory ? Explain.
In building a house, carpenters use nails from a large box. The box is suspended from a spring twice dining the day to measure the usage of nails. At the beginning of the day, the spring stretches 50 cm. At the end of the day, the spring stretches 30 cm. What fraction or percentages of the nails have been used?
1 V:IV H.W.docx H.W: Two boxes are connected by a cord running over a pulley. The coefficient of kinetic friction between m, (5kg) and the table is 0.20. We ignore the mass of the cord and pulley and any friction in the pulley, which means we can assume that a force applied to one end of the cord will have the same magnitude at the other end. We wish to find the acceleration, a, of the system, which will have the same magnitude for both boxes assuming the cord doesn't stretch, As m (2Kg) move down, m,move to the right. m. د قوة الشد Tو تسارع النظام .a علما بأن البكرة مهملة الكتلة والاحتكاك؟ 出 1
1 V:IV H.W.docx H.W: Two boxes are connected by a cord running over a pulley. The coefficient of kinetic friction between m, (5kg) and the table is 0.20. We ignore the mass of the cord and pulley and any friction in the pulley, which means we can assume that a force applied to one end of the cord will have the same magnitude at the other end. We wish to find the acceleration, a, of the system, which will have the same magnitude for both boxes assuming the cord doesn't stretch. As m; (2Kg) move down, m, move to the right. m. د قوة الشد Tو تسارع النظام .a علما بأن البكرة مهملة الكتلة والاحتكاك؟ 出 l20 Son la 1
You place a crate of mass 39.9 kg on a frictionless 2.08-meter-long incline. You release the crate from rest, and it begins to slide down, eventually reaching the bottom 1.40s after you released it. What is the angle of the incline? A) 16.3 degreesB) 12.5 degreesC) 20.0 degreesD) 30.0 degrees
You push a box (mass 3 kg) so that its initial speed is 2.2 m/s. It slides across a rough floor (coefficient of kinetic friction 0.48). How far will it slide before it stops? Give your answer in m and report your answer to 2 decimal places.
Q1.2:Resolve the horizontal 600-lb force in Figure into components acting along the u and axes and determine the magnitudes of 600 tb these components
A 1.80x10^4 kg semi-trailer truck drives up a 200 m hill [θ = 30 degrees above horizontal], at a constant speed of 25.0 m/s. The force of friction is 6.00x10^2 N. Write an equation to isolate and solve for P.
At an accident scene on a level road, investigators measure a car's skid mark to be 88 m long. It was a rainy day and the coefficient of friction was estimated to be 0.35. a.)Use these data to determine the speed of the car when the driver slammed on (and locked) the brakes. Express your answer to two significant figures and include the appropriate units.
42. A block initially at rest slides down a ramp of length L that makes an angle of θ with the horizontal. (a) Derive an equation that predicts the time required for the block to reach the bottom of the ramp in terms of L, θ, g, and μ, the coefficient of friction. (b) This derived equation has no real solutions for angles θ ≤ tan–1 (μ). Show algebraically this is the case and explain the physical significance of this – i.e. what does this mean about an actual block on an actual ramp with actual friction?
A block is sent up an incline with a velocity of 3.51 m/s. Assume there is no friction between the incline and the block. The angle is at an incline of 31.1 degrees with the horizontal. A) How far up the incline does the block go? B) How long does it take to get there? C) What is it's speed when it gets back to the bottom?
The conveyor belt is designed to transport packages of various weights. Each 10-kg package has a coefficient of kinetic friction u. = 0.31. The speed of the conveyor is 4 m/s , and then it suddenly stops. (Figure 1) Part A Determine the distance the package will slide on the belt before coming to rest. Express your answer to three significant figures and include the appropriate units. ? Figure 1 of 1 S = Value Units Submit Request Answer B Provide Feedback