A beaker of height h is filled with a liquid of density p up to a certain limit. The beaker is rotated by an angle e such that further increase in the angle will result in over flow of the liquid. If the liquid surface is exposed to the atmosphere, what will be the gauge pressure at point B? a) pgh b) pgh sin e c) pgh cos e d) pgh=2

A beaker of height h is filled with a liquid of density p up to a certain limit. The beaker is rotated by an angle e such that further increase in the angle will result in over flow of the liquid. If the liquid surface is exposed to the atmosphere, what will be the gauge pressure at point B? a) pgh b) pgh sin e c) pgh cos e d) pgh=2

Name: A beaker of height h is filled with a liquid of density p up to a cer
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A beaker of height h is filled with a liquid of density p up to a certain limit. The beaker isrotated by an angle 0 such that further increase in the angle will result in over flow of theliquid. If the liquid surface is exposed to the atmosphere, wh

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

b) Calculate the gage pressure at points A, B, C and D. Take air density as 1.21 kg/m. Open to atmosphere Air Air 0.4m 0.4m Oil 0.5m S=0.9 1m Water Question 2 A pulley-load system is used to open and close the gate AB as shown. The gate is 5 m long and 2.5 m wide and has a mass Pulley hp
i) hovzontal pos 80°C air cokulate the rate of heat tr in the cauity per unit depth
Anaerobic treatment is a common treatment process in environmental engineering to degrade organic contaminants. During this process, methane (CHA) is produced which is an explosive gas. So, its pressure in the treatment tank has to be maintained below explosion limit. Question: You want to keep the methane pressure in the tank below 400 kPa, so what should be the maximum pressure you measured at point A? Methane Mercury (sg = 13,6) 8 cm 1 cm A 3 cm 11 cm water | 4 cm Oil (sg = 0,8)
If the sp. volume of a certain fluid is 0.7848m3/kg, what is the specific weight (N/m3)?
5) Consider 4 immiscible liquids in an open tank (open to atmosphere) as shown below. Find the gauge pressures at 1, 2, 3 and 4. SG is specific gravity. Oil (SG: 0.78) 1. Water (SG: 1) Glycerin (SG: 1.26) Mercury (SG: 13.6) 70 26°C AQI 29 OMEN 35cm 65cm 20 cm 40cm
Wind energy question #1 Q1) Wind at 1 standard atmospheric pressure and 15°C temperature has a velocity of 5 m/sec what the total power density in the wind stream? Choose the correct answer (76 w/m?, 15.25 w/m?, 3 w/m?) Q2) A. The anemometer is advice to measure the always recommended to set up on the height of B. The maximum power from wind power from wind stream by wind rotor is Itcal ......... Coefficient C. Savonius rotor s classify as ............. wind turbine Q3) How wind turbine classified ? Discuss with brief. Q4) Write short notes on applications of wind energy. Wind energy question #2 Q1) 1. If the mechanical and electrical efficiency about 70% and with consideration of Betz coefficient the total out power from wind power system . 2. Darrieus rotor is consider as . axies wind turbine, 3. The wind speed measure by the............. which recommended to set up on m height. Q2) What the power density in the wind stream of standard atmospheric pressure and 19°C temperature has a…
Water pressurized with a gas in a cylindrical tankare available. It is measured as l1 = 60 cm, l2 = 40 cm and l3 = 30 cm.Atmospheric pressure: Patm = 100 kPa ; Relative densities are: Dsu = 1, Poil = 0.85 and Pluc = 13.6. What is the difference between the pressure of the gas in the tank and the pressure at point A? a) 47.09 kPa B) -26.23 kPa NS) -6.20 kPa D) -52.81 kPa TO) 73.77 kPa 22
The specific gravity for salt water = 1.03, %3D what is the pressure at 7-m below the ocean in kPa? (UP TO THREE DECIMAL PLACES)
Q2] A closed tank contains air, oil and water as shown in Fig. 1. Find PA (gauge). Patm = 101325 N/m² 2.5 m 0.1 m 2 m 0.5 m Hg Air Oil S = 0.8 H₂O PA (gauge) = ? 2 m 0.6 m Fig. 1
The figure shows a sensor indicating a gauge pressure reading of 1.5 kPa. The fluids are at 20°C Determine: a) the height hb. b) the height hc.The specific weight of air is 12.0 N/m3.
Question 2 A gasoline line is connected to a pressure gage through a double U-manometer, as shown in fig below. If the pressure gage is 370 kPa, determine the gage pressure of the gasoline. Oil SG 0.79 Pse=370 kPa Enge Gasoline SG=0.70 45 cm 50 cm Pipe Air 22 cm 10 cm Mercury SG= 13.6 Water FIGURE P1-112 Add a caption... > Gideon Yalley
AND E 1 32% Ô 20:22 H+ flow rates of these two fans? c) A system is equipped with two pressure gages and a manometer, as shown below. For Ah= 8 cm, determine the pressure difference AP=P2-Pı d) The pressure of water flowing through a pipe is measured by the arrangement shown below. For the values given, calculate the pressure in the pipe. Air Ah Manometer fluid SG = 2.67, Oil SG = 0.87 %3D P1 P2 20:22 2/2