A 984 uF capacitor has an initial voltage, v(0) = 1 V. If the current flowing through the capacitor is i(t) = 19 mA, what is the voltage v(t) across the capacitor, at time t= 39ms? Enter your answer to 3 significant figures. i(t) C
Q: S A 6-pole, 480-V, 50-Hz-connected synchronous generator has X,1 ohm. The no-lo: rotational losses…
A:
Q: The following system given by input (t) and output y(t) is linear. g(t) = 2r(t) + 2 True False
A: The following system given by input x(t) and output y(t) is linear. y(t) = 2x(t) + 2True False
Q: A 100az pC electric dipole is placed at the origin. Find V and E at the position (0, 0, 10). Ans: V…
A:
Q: For the following circuit obtain: (a) the response v(t) for t>0, (b) the current i(t) through the…
A: The circuit is given asinitial condition are zero for both inductor and capacitor because source…
Q: 5. For a pn junction diode calculate I, for NA= 10¹7/cm³, No = 5x10¹6/cm³. You are given area of…
A: NA=1017/cm3ND=5/cm3Area of cross section =25Diffusion length in p sides(Lp)= mDiffusion length in…
Q: 4. Consider the following LTI system shown in Figure (3). C-10 μF m Figure (3) R=IKn (a) What is the…
A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…
Q: 1. A 30, 100 kVA, 460 V, 60 Hz, eight-pole induction machine has the following equivalent circuit…
A:
Q: Question 4 Design a filter that has the transfer function H(s) 1) Please determine the filter type,…
A: The transfer function of a second-order filter is given asTo find:(i) filter type, its gain,…
Q: 2.22. For each of the following pairs of waveforms, use the convolution integral to find the…
A:
Q: (B) Choose appropriate values for Sallen-Key low-pass filter circuit shown in Figure 1 to give it a…
A: For the given circuit the value of the resistor and capacitor needs to be calculated to get a low…
Q: Find the transfer function of the following: 1. Using Mesh Analysis vi(t) +1 192 www 1 H oooo 1 F…
A:
Q: A current of 20A flows through a load having a resistance of 2 ohm. Determine the power dissipated…
A: Current I = 20 ALoad resistance RL= 2 Coil resistance Rc = 0.01 We have to find the the value of…
Q: Total Current = 9.434A Vac = 24Vac. what is the circuit impedance?
A: Total Current IT = 9.434A VAc = 24 Vac.circuit impedance Z = ?
Q: Describe the principles of fault injection testing and its importance in evaluating system…
A: We have to describe the principles of fault injection testing and its importance in evaluating…
Q: How does duality find its application in the design and analysis of antennas, especially in the…
A: Duality plays a significant role in the design and analysis of antennas, particularly in the context…
Q: Problem 1 Consider the following sequence {r[n]}. (a) Plot {y[n]} = {x[n−3]}. (b) Plot the time…
A: Given:a discrete time signal x[n], To plot:
Q: How can IoT technology be utilized to optimize energy consumption in commercial buildings and reduce…
A: We have to explain how can IoT technology be utilized to optimize energy consumption in commercial…
Q: Compare microchip technologies for power management, such as voltage regulators and energy…
A: Microchip technologies for power management play a critical role in energy-efficient IoT (Internet…
Q: Discuss the potential of wireless power transfer technologies, such as resonant inductive coupling,…
A: Wireless power transfer (WPT) technologies, particularly resonant inductive coupling, hold…
Q: Sample Problem. Determine the output waveform for the network below and calculate the output dc…
A: D1 and D4 are silicon diodes whereas D2 and D3 are germanium diodes.
Q: for the control system shown in Fig (a) below, a) Determine the values of gain K and the time…
A:
Q: Q27. Find the true power, the reactive power, and the apparent power of the circuit shown below. 10…
A:
Q: 1- What is the type of the filter according to its pass band 2- Which parameter of the filter will…
A: For the given active filter circuit the type of filter needs to be obtained and the effect of…
Q: 20 Ω Σ16 Ω 184 φ + 2Ω ww υΔ + SINI V +1 180 V S Ro 8 Ω 510 Ω και 0.10.
A: (a)Open the variable resistance, and redraw the circuit.
Q: An optical fiber has a core refractive index n1=1.5 and a cladding refractive index n2=1.48. the…
A: Given-Core refractive index n1 = 1.5Cladding refractive index n2 = 1.48Diameter = 50 micronsLength…
Q: Assuming that/Q=1.5 mA, calculate all currents and voltages (1030, 12, Vn, Vp and v), as well as the…
A: The given circuit diagram is shown below,
Q: 1.26 In the circuit of Fig. P1.26, node V₁ was selected ground node. *(a) What is the voltage…
A: For the given circuit:a. What is the voltage difference acroos R6 ?
Q: What role does duality play in the analysis of Maxwell's equations in electromagnetic theory?
A: We need to explain role of duality play in the analysis of Maxwell's equations in electromagnetic…
Q: 3 RTH=? 3 3 A B
A: I am calculating thevinin resistance from your circuit. If have any doubts, please post original…
Q: Investigate the applications of IoT in predictive maintenance for critical infrastructure such as…
A: IoT (Internet of Things) has the potential to revolutionize predictive maintenance for critical…
Q: A single-tone frequency-modulated signal is given by s(t) = 8cos [1.67×10%+2.5 sin(37×10¹)] The…
A: It is given that:
Q: for this simplified circuit now, calculate the mesh currents of the system at midday, when the…
A: The circuit is given ashere we need to calculate the voltage, current and show the power balance.
Q: a) Consider the MOSFET circuit shown in Fig. Q6.1 below. Find the drain current lo and the voltage…
A:
Q: A diode at room temperature (VT=25mV) conducts 1.8 mA when its forward voltage is 0.7 volts. What…
A:
Q: Please Draw the Circuit and Solve. 1) The non inverted active low pass filter has impedance…
A: The circuit of active loss pass filter can be designed as
Q: Q4// A single phase overhead transmission line delivers 1100 kW at 33 kV at 0.8 p.f. lagging. The…
A: Given:Power delivered (P) = 1100 kWVoltage (V) = 33 kV = 33000 VPower factor (PF) = 0.8 lagging…
Q: The following circuit can be simplified into a Thevenin equivalent circuit. Find the Thevenin…
A: For the given circuit the equivalent thevenin's circuit needs to be obtained.
Q: Obtain the response i(t) for the current through the 30 ohm resistor for t>0. note: do not use…
A: An RLC circuit is excited by the following sources:two DC voltage sources of 60 V and 120 V,an…
Q: 50 Ω 170 V 200 nF 200 Ω i | 100 mH
A: Given Data;A DC, RLC transient circuit with,Voltage source To Find:The expression of i(t).
Q: Calculate the capacitor voltage for t= 0 (zero negative) and t> 0 for the given circuit. Assume R =…
A: In this questionWe need to determine the voltage across the capacitor. We know capacitor act as open…
Q: 1. Problem 1.8 in the textbook: There is no charge at the upper terminal of the element in Fig. 1.5…
A:
Q: 6. For the circuit below, if Vz = 25V and Vy = 5 V, what is Vz? 30 + V₂
A: Given that Voltage Vx =25 vVoltage Vy =5v Voltage VZ = ?
Q: 244 0.102 7822 50 48V beflueen doirlw vapnened erit ni noftifegmlla riliw balquos egbelwon…
A:
Q: Provide an in-depth overview of semiconductor fabrication processes and their impact on microchip…
A:
Q: QUESTION 9 The current lo in the transistor circuit in the Figure below assuming that the transistor…
A: We need to find out unknown current for given circuit.
Q: Compare microchip technologies for energy harvesting and their applications in self-powered IoT…
A: Compare microchip technologies for energy harvesting and their applications in self-powered IoT…
Q: A 60 Hz three-phase transmission line has length of 130 Km. The resistance per phase is 0.036 22/km…
A:
Q: 13u(t) A 6Ω Μ www 0.4 F 1Η m Μ U(1) Σ20 Ω 6Ω 1+ 39u(t) V
A: we need to determine the response of v(t), valid for all t for the above circuit
Q: The voltage across a C = 850 mF capacitor is v(t) = 6 sin(100t) + 3 V. Find the initial energy in…
A: Given: C = 850×10−3 Fv(t) = 6sin(100t) + 3 V
Q: 2. Problem 1.9 in the textbook: The current entering the upper terminal of Fig. 1.5 (shown in below)…
A: Consider the current is,
Step by step
Solved in 4 steps with 10 images
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?Two capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?
- An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
- You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfaradList the five capacitor replacement rules.
- A 100 µF capacitor is connected in series with a 500 V DC voltmeter across a 400 V DC supply. The voltmeter has a resistance of 1000 Ω/V. Determine the time, in seconds, represented by one time constant for this RC series circuit. Determine the voltage across the capacitor planes at the end of one time constant when the capacitor is on chargeThe figure below shows a simple RC circuit with a 3.50-µF capacitor, a 3.60-MQ resistor, a 9.00-V emf, and a switch. What are the following exactly 6.50 s after the switch is closed? S C R (a) the charge on the capacitor (b) the current in the resistor µA (c) the rate at which the capacitor is storing energy (d) the rate at which the battery is delivering energyA resistor and a capacitance are connected in series to an emf source. The time constant of the circuit is 0.87 s. What will be the 35 - time constant of the new circuit when another capacitor identical to the first is connected in series with the circuit? O a) 0.973s O B) 1,742 s O C) 2.034 s O D) 2.136 s O TO) 0.435 s