Answered: A 8M x 64 main memory is built using…

A 8M x 64 main memory is built using 512K × 16 RAM chips and memory is word-addressable. If low-order interleaving is used, address 0X000000000000003E will reside in bank and position

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter3: Data Representation

Section: Chapter Questions

Problem 11VE: Most Intel CPUs use the __________, in which each memory address is represented by two integers.

See similar textbooks

Related questions

Q: Execution the instruction: BSA X: X is memory location, is need : 3 steps and 3 Micro-operations O 5…

A: Question 2: B) 4.8 Let m be the number of instructions and n be the number of pipeline steps. As a…

Q: Identify if possible the type of addressing modes for the following instructions. 1. MOV EAX, [EBP…

A: Given instruction- 1. MOV EAX, [EBP +ESI]

Q: The memory address of the last location of 1 Kbyte memory chip is given as FBFFH. Find the starting…

Q: A computer employs RAM chips of 512 x 16 and ROM chips of 1024 x 8. The computer system needs 4K…

A: The answer is

Q: er a 48-bit word long instructions. It has 200 registers, each of which is 48 bits long. It needs to…

A: Here in this question we have given a 48 bit architecture machine with 1 word long…

Q: 3. If a ROM chip in some 8-bit microcomputer system starts wita an address of 97C0H while its end…

A: If a ROM chip in some 8-bit microcomputer system starts with an address of 9700Hwhil its end…

Q: RAM and 2K bytes of ROM along with interface unit of 128 registers each. A memory mapped I/O…

A: The answer is

Q: 3. If a ROM chip in some 8-bit microcomputer system starts with an address of 97C0H: while its end…

Q: A DRAM chip has 1M of memory locations. The number of address pins on this DRAM chip will be not…

A: Answer in step2

Q: A computer employs RAM chips of 512 x 16 and ROM chips of 1024 x 8. The computer system needs 4K…

A: Introduction

Q: ime is 10 ns and main memory or read operation is 90%. In to d for read operations with w emory…

Q: The memory locations 2050y and 2051H contain 3FH and 424 respectively, and the reg- ister pair DE…

A: Required :- Approach :- Please see the handwritten below in step-2 with comments written on it.

Q: Explain how an 28F400 memory chip can switch from 8 bit data bus to 16 bits data bus without…

Q: Design a 128K x 16 RAM by using a block diagram of RAM chip as shown in Figure 1. Assume that…

A: Design a 128K x 16 RAM by using a block diagram of RAM chip as shown in Figure 1 Assume that…

Q: he 64K single memory chip is used in total. Determine the number of lines in address bus including…

A: option(f) is the correct option.

Q: Design a memory module with 64 kilobyte ROM using 8K x 8 EPROM devices and similar sized writeable…

A: Introduction: EEPROM stands for electrically erasable programmable read-only memory and is a type of…

Q: and describ

A: given - Draw the pin details of 8085 microprocessor and describe each and every pin.

Q: (Direct Memory Addressing Mode) Ex. Write an assembly code to transfer the memory content of address…

A: Direct Addressing mode: In this type of addressing mode , the address of data is directly specified…

Q: A processor is fetching instructions at the rate of 1 MIPS. A DMA module is used to transfer…

A: Answer :

Q: B. Design an 256KX16 DRAM memory using 64KX4 module. Draw the block configuration of the modules…

A: The answer is given below:-

Q: 8086 Microprocessor is having 20-bits data bus and 16-bit Address bus Select one: O True False

A: the above is false

Q: Q5) The contents of a four-bit register is initially 1101. The register is shifted six times to the…

A: 5. The register is given the serial input with the serial data 101101. First digit from the left is…

Q: The memory contains an array of 200 elements starting at addresses 200H. Write the assembly code…

A: GIVEN: The memory contains an array of 200 elements starting at addresses 200H. Write the assembly…

Q: Interface keyboard and display controller 8279 with 8086 at address 0080H. Write an ALP to set up…

A: 8279 Interface keyboard and display controller: Intel’s 8279 is a standard purpose Keyboard Display…

Q: Timing Diagram Assume an 8086 has been set to operate at 30 Mhz and at 40% duty cycle. Calculate:…

Q: nterface two 32KB EPROM to the 16-bit data bus of 8086 based system. Design an address decoder…

Q: design an interfacing circuit for the memory to meet the following specification: 1- Microprocessor…

A: Answer:)

Q: Design memory decoder for a system having a total of 2GB RAM divided in sub memory modules of 512MB.…

A: Design memory decoder for a system having a total of 2GB RAM divided in sub memory modules of 512MB.…

Q: registers are not included in Bus Interface Unit of 8086 microprocessor. a. BX, SI, D! b. AX, BX, BP…

A: 8086 Microprocessor has two Functional unit Executive Unit (EU) Bus Interface Unit (BIU)

Q: Q8/Assume that the microprocessor can directly address 64K with a R/W' and 8 data pins The memory…

A: Please check the solution below

Q: Q.9 Design a RAM architecture with 8 bit DRAM or SRAM cells. Consider the size of the RAM is 1KB.

A: Given RAM 1Kb ...

Q: The memory chips used are 32 kybte each in total 64K memory. Determine the number of lines in adress…

A: The memory chips used are 32 kbyte each in total 64KB memory. Determine the number of lines in…

Q: CLK signal is the clock output 1 point signal provides the basic timing for processor operation and…

A: This question comes from microprocessor which belongs to subject computer engineering. Let's discuss…

Q: 3. Show the inputs and outputs for a 128 MByte memory with 32-bit read/write operations and byte…

A: The diagram is drawn in the next step :

Q: Design a 512 MByte memory using 64M*4 chips, with 8-bit read/write operations and byte…

A: Read/Write operation: Memory unit consists of two types of operation i.e read and write operation.…

Q: Q5/ design an interfacing circuit for the memory to meet the following specification: 1-…

Q: 1. In Von-neuman archticture the RAM and program memory have --------- bit width. 2. PIC16F87X…

A: Answer - Von Neumann architecture is also known as IAS computer. It contains the CPU, main memory…

Q: Design 8086's memory system consists of 512K bytes of RAM and 128K bytes of ROM using the devices…

Q: In one computer if address bus is 16 bits and memory word is 8 bits, then the capacity of memory is…

A: No of address that can be address is 2^16 each word have size 8 bits. So, total address-able memory…

Q: Our laboratory has 3 128Kx4 bit, 3 256Kx4 bit and 2 512x4 bit memory blocks. Using these blocks,…

A: Answer :

Q: Using multiple 4M × 8 RAM chips (see below) plus a decoder, construct the block diagram of a 16M ×…

A: HERE WE HAVE TO CONSTRUCT 32MX16 RAM USING 8MX8 RAM. As the data bit width to be obtained is 16 bit…

Q: A computer employs RAM chips of 512 x 16 and ROM chips of 1024 x 8. The computer system needs 4K…

A: The number of chips needed in RAM is 2048 /256 = 8 chips. 2048 = 211 256 = 28 The number of chips…

Q: A main memory unit with a capacity of 4 megabytes is built using 1Mx 1-bit DRAM chips.Each DRAM chip…

A: To find the time required to refresh all the cells in the memory unit

Q: A system has a control memory of 2048 words of 24 bits each. The micro- instruction has three…

A: We need to find total bits in the address field and micro operation field.

Q: 2.The result of the arithmetic and logic unit stored in the register as a binary number. 3. Flag…

A: See the answer in second step.

Q: Assume that the microprocessor can directly address 64K with a and 16 data pins The memory map for…

A: Step 1 The answer is given in the below step

Q: The 64K single memory chip is used in total. Determine the number of lines in address bus including…

A: The Answer is in Below Steps

Q: Q5/ design an interfacing circuit for the memory to meet the following specification: 1-…

A: Answer :-

Q: MP store the higher order 8bit and lower order 8bit of the address in the Z and W registers,…

A: According to the information given:- We have to choose the correct option to satisfy the situation

Concept explainers

Fundamentals of Input and Output Performance

The I/O subsystem is a component of computer system design that uses buses to assist communication between the Central Processing Unit, Computer Memory/Storage, and Input and Output Devices (that is known as peripheral devices). The I/O subsystem includes disc controllers, tape drives, discs, system buses, and other devices. The I/O database application reads and writes drives using the operating system windows I/O.

Question

A 8M x 64 main memory is built using 512K x 16 RAM chips and memory is word-addressable. If low-order interleaving is used, address 0X000000000000003E will reside in bank
and position

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Fundamentals of Input and Output Performance

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

A(n) __________ is a storage location implemented in the CPU.
Most Intel CPUs use the __________, in which each memory address is represented by two integers.
A(n) ____________________ instruction copies data from one memory location to another.
The time it takes to perform the fetch instruction and decode instruction steps is called the execution time. True or false?
PCSrc ID/EX EX/MEM Control IF/ID Add Branch MEM/WB Add Shift left 2 RegWrite Instruction Memory Read Address Read Addr 1 Register Read Read Addr Data 1 File Write Addr Data Memory MemtoReg ALUSrc Address Read Data ALU Read Data 2 Write Data Write Data ALU cntrl MemRead Sign Extend 16 32 ALUOP RegDst Figure 3: For EACH of the following registers, indicate how many bits are in the reg- ister, and what control signals are are in the register. he control signals in the diagram are: regWrite, regDest, aluOP, ALUsrc, Branch, MemRead, MemWrite, MemToReg. Register Number of bits Control Signals PC 32 None IF/ID 64* None ID/EX EX/MEM МЕM/WB
For the 8086 memory segment (011A) h with an offset (2B35) h, the memory address is
In the Allen-Bradley MOV instruction, constants such as 250, 400, 5.5, etc., can be entered into the source location of the MOV instruction rather than a memory address containing the value to be moved. True False
Assume the following values are stored at the indicated memory addresses and registers:Address Value Register Value0x200 0xFF %rax 0x2000x204 0xAA %rcx 0x10x208 0x11 %rdx 0x30x20C 0x13Fill in the following table showing the values for the indicated operands: Operand Valueaddq %rcx,(%rax) ------------------subq %rdx,4(%rax) -------------------imulq $16, (%rax,%rdx,4) --------------------incq 8(%rax) -------------------decq %rcx -------------------subq %rdx,%rax ---------------------xorq %rdx,%rdx --------------------sarq 3, %rdx --------------------notq %rdx -------------------
Q1-Design the hardware required to interface 32KB of SRAM to the demultiplexed address and data bus of the 8086 Microprocessor connected in minimum mode using 16Kx8 memory chips. Decode the memory using two method the first one is with simple NAND gate decoder the second method is Decode the memory with 3-to-8-line decoder (74138). so that it starts from physical address 00000h also for each memory chip used in your Design determines the range of physical address which can handle. 9255 hin with 9096 microprocessors to work on on YO
microprocessor 8086 Design a control unit of a computer that has the following features: 16700 operations, 4 bits for indirect memory access, with memory size 128 GB X 64 bits. Then, show whether this design is perfect or has disadvantages. If does have, what are these disadvantages in this system Then, show the timing signals for the following: DLP MUL RI, where the MUL needs five clocks The MUL can't be run unless ADD R1,R2 is executed. ADD requires 3 clock cycles to be done Note that: among the 16700 operations, there are three operations require high time computation in which they require the following number of clock 102, 466, 20050 to complete only the clock execution section.
20 LDA 50 21 SUB 51 50 100 51 200 Choose the contents of the registers: PC, MAR, MDR, IR, A at the end of fetch-execute cycle for instruction 20: PC MAR MDR IR A
The Register indirect addressing mode is: Immediate Operand Addressing Mode mcq question Register Operand Addressing Mode Memory Operand Addressing Modes Direct addressing mode