A 70-mm-diameter suction pipe leading to a pump, as shown below, carries a discharge of 0.05 of oil (s.g. = 0.85). If the pressure at point A in the suction pipe is a vacuum of %3D 180 mmHg, find the total energy head at point A with respect to a datum at the pump. Express answer in meters. Use T = = 3.1416

A 70-mm-diameter suction pipe leading to a pump, as shown below, carries a discharge of 0.05 of oil (s.g. = 0.85). If the pressure at point A in the suction pipe is a vacuum of %3D 180 mmHg, find the total energy head at point A with respect to a datum at the pump. Express answer in meters. Use T = = 3.1416

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

P-0SCApu, A 60 MLD water treatment plant has 4 mechanical flocculators. The design criteria for each flocculator are as P.-P.(I+r) wo. P.xCx WDn follows: P-G'uV r-1+05 (ax b x h) R =Sx 100% Number of paddles Number of plates per paddle Area of each plate Coefficient of drag Relative velocity of paddle Detention time 4 AH, (R, + R,) AH, (R, +R,) ¸ AH, (R, + R, ) R 2 %3D H. H 4 Q Zoom 0.6 m2 %3! 1.8 0.55 m/s 25 minutes %3D 1.14 x 10 3 Ns/m² 1000 kg/m³ Dynamic Viscosity %3D Density of water %3D Compute the volume for each tank in m3. B 1 500 1042 D 260 375
21. The maximum size of ferrules that can be safely used with 150mm mains is: B) 20mm D) 10mm A) 25mm C) 15mm
1. A 1.5” S40 pipe has a capacity of ______ cu. ft/sec. at a 1 ft/sec. velocity. A. 0.0031 B. 1.7672 C. 0.0332 D. 0.0123 2. The bulk density of impure alumina oxide in lb/ft3 is A. 0.70 B. 80 C. 90 D. 60 3. Tetrahydrofuran has a vapor pressure of ______ mmHg at 176 deg. F A. 200 B. 1518 C. 1173 D. 2 562
Select the correct answer for the followings: 1. PVC pipe is not used in exposed services because; a. It's cost is high. b. It's strength is reduced by UV rays, c. It is available in small sizes. d. None of above answers. 2. Glob valve is seldom used in water distribution systems because of; a. It's short life. b. It's high head loss. c. It can't resist high water pressure. d. None of above answers. 3. When the average water demand for a city is 20000 m³/day, the maximum hourly water demand for this city is; a. 30000 m³/day. b. 54000 m³/day. c. 36000 m³/day. d. None of above answers. 4. Lime is always added when the used coagulant is; a. Alum. b. Ferric chloride. c. Aluminum sulfate. d. All of above answers. 5. Treatment of water with alum increases; a. Acidity and hardness of water. b. Alkalinity and hardness of water c. Sulfates in water. d. pH of water. 6. The fire storage required for a residential area composed of attached houses is; a. 5670m³. b. 453.6m³. c. 4082.4m³. d. None of…
노키 10ptis L₂ follft 다 0.1 ft 1 Visioft/s Figure 1
chlorine at 10°C is Wpder gas prerrure OF Assume a gal comrtant OF 117 N-/ Kg-K. Calculate the FOllawing: Deasity b. Specipic weght a.Dens C (pecipic Volume
Q2: An otl of viscosity Co.15 pas) and specific gravity 0.9 is flows Throngh 1.Find The slope of The Pipe That will canse The Pressure to be constantalong The pipes entire length? an inclined (300mm) diameter Pipe. Q= 0.005m3/sec 3oomm Dia. Zz datum 2. check if The Rlow is laminarRlow?
Discharge Q, (OCF)
Research atleast 4 venturi meter write the problem and solution legibly draw also the diagram if there is.
verifyy the Answer R_B=562lb and M_B =2324lb-in. (Show all the work within 20-30mins)
Ex: Giren L₁ = toom, D₁ = 50mm, L2= foom, D₂ = 100mm (forall pipes) = 0.032, Find:. a-Discharge of each pipe a. Equivalent dia for a single Pipe For (toon) length A Ⓡ تواري B Hom B ران Datum
Q5: The compartments (B) 4 Cc) in figure below are closed & filled with air. When the gauges (A) f (D) read as indicated, what should be the value of Cx) for gaug eCE)? (Mercury in each U-tube gauge) 2.07 bar B 254 Air D Air E