A 50-ohm load is attached to a transmission line with characteristic impedance of ZO = 93.6 – j3.64 ohms. Evaluate the reflection coefficient at the load. O -0.304+j0.0176 O 0.304-jO.0176 O 0.152-j0.0176 -0.152+j0.0176

A 50-ohm load is attached to a transmission line with characteristic impedance of ZO = 93.6 – j3.64 ohms. Evaluate the reflection coefficient at the load. O -0.304+j0.0176 O 0.304-jO.0176 O 0.152-j0.0176 -0.152+j0.0176

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.9MCQ: Match the following: (i) Hysteresis loss (a) Can be redud by constructing the core with laminated...

See similar textbooks

Related questions

Q: 7. When a transmission line has a load impedance same as that of the characteristic impedance, the…

A: In this question, We need to choose the correct options When a transmission line has a load…

Q: following impedances in ohms per phase referred to the stator circuit: R1 = 0.1R 2, X = RQ, R2 =…

Q: The voltage waveform on a lossless TL in air is given by: V(z)=150e 8z + -20e*Bz (V). The TL has a…

A: Given: Voltage, Vz=150e-jβz+-20ejβz V Characteristic impedance, Z0=100 Ω Length, L=0.5 λ

Q: Q) A 50 0 lossiess transmission line is terminated by a load of impedance Zi. The VSWR on the line…

A: We come to know that there exist a minimum at the load end hence reflection coefficient must be…

Q: A 50 ΩΩ transmission line is matched with a load ZlZl. If the frequency of operation is 100MHz100MHz…

A: When the impedance of the load is same as the characteristic impedance of the transmission line ,…

Q: 02: A lossless transmission line of electric length 1= 0.35 A is terminated in a load impedance as…

A: Given that: i=0.35π , Zin = 60+30n Find Bl =2ππ× 0.35π…

Q: 18. The reflection coefficient for the I transmission line shown in figure at P is Transmission line…

A: In the question, What is value of reflection coefficient of the given transmission line.

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A: Given data, Corona loss P1=53 KW at V1=106 KV Corona loss P2=98 KW at V2=111 KV Phase voltage is…

Q: A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function…

Q: 3) Choose the correct answer with the explain: a) The maximum power transferred to the load is…

A: 3. a.) Acc to max power transfer max power id delivered to load when R(thevenin) is equal to R(load)…

Q: I need the answer as soon as possible

Q: A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side…

A: Given, A 3 phase transmission line has its conductors at the corners of an equilateral triangle…

Q: Determine the impedance ZL for maximum average power transfer and the value of the maximum average…

Q: In the transmission-line circuit shown below all lines are lossless, 2Z01 = Z02 = 1002 and RL1 R12 =…

A: Given Z01=Z02=100 ΩRL1 =RL2=50 Ω Lossless line

Q: The characteristic impedance of a transmission line is 70 ohms and has a load of 35 ohms. The SWR…

A: The solution is given below

Q: A transmission line of characteristic resistance 50 Ω is loaded with a load impedance ZL = RL + jXL…

A: Given data: XL=25 ΩZ0=50 ΩΓ=0.5

Q: - The distance from the load to the first minimum voltage in a 50 N line is 0.12A, and the standing…

Q: 1. Smith chart is based on the polar plot of: a. Reactance b. Voltage c. Current d. Voltage…

Q: Problem 2: Given that the voltage standing-wave ratio S = 3 on a 50 O line, that the first voltage…

Q: In Smith chart, if the value of the normalized load impedance ZLn is :(3+j0), then the value of VSWR…

Q: Q1/ Use nodal voltage method, find the magnitude and direction of * .current I 10 V½ A В + Özsv 4 50…

Q: Given the AC Bridge, determine the phase angle of Z4 (in °), if the values of other impedances are:…

Q: A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at 106 kV and a…

Q: a) A lightning strikes a 30-m unshielded over-head following parameters: Surge impedance of the…

Q: B3

Q: Q6: Calculate Zin at the load using smith chart for total transmission lines, while the wavelength…

Q: Q5: A lossless transmission line is terminated with (60+j30)Q load. The input impedance is…

A: In this question, Lossless transmission line Load impedance ZL = 60+j30 ohm Input impedance Zi =…

Q: Calculate the value of ZL in the circuit in order for ZL to receive maximum average power. What is…

A: Maximum power transfer theorem says that to obtain maximum power from a network, the resistance of…

Q: determine the current in the line by reflected impedances method lang 0.18 10.24 1:20 mm 10:1 Zinea…

A: For the above given question we need to calculate the value of line current which is already…

Q: a line characteristic impedance 600 ohm and 3 db loss is a half wavelength .it is fed by a source of…

A: A line characteristic impedance 600 Ω and 3 dB loss is a half wavelength. It is fed by a source of…

Q: 80022 j125022 -J4502 Vs = 100 Sin (wt) V Soive for polar & Phasor form of Ziz, VR, V₂, Vc

Q: at 20 MHz the characteristic impedance of a transmission line is (20-j2) ohm and the propagation…

A: Given, Frequency (f) = 20 MHz Characteristic impedance of a transmission line, Zo = 20 - j 2 ohm…

Q: Derive the following formula for a transmission line's voltage reflection coefficient (all symbols…

Q: Q6: Calculate Zin at the load using smith chart for total transmission lines, while the wavelength…

Q: A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed.…

A: Given transmission line circuit is 3-phase double circuit. Diameter of each conductor is 2.76 cm.…

Q: . The relation between impedance and admittance locus is Opposite Mirrored Inversely Reciprocally

A: Impedance is reciprocal to admittance

Q: Compute the voltage drop across the transmission line, ETL = E1 – E2, in both polar and cartesian…

A: A diagram of a two bas bur power system is shown in the question. We need to determine the voltage…

Q: A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function…

A: We are know that Wavelength of the wave is Distance between two crests or trough of that wave

Q: j40 4Ω -j 102 v /0° V j82 Esa (1) 10 2 V. For the circuit shown, if V-205, the value of reflected…

A: In the circuit shown below

Q: Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.1 kQ,…

Q: For the network shown in figure, carry out three iterations of Gauss-Seidel method. jl P.U rele 3.…

A: One of the most basic iteration methods is the Gauss-Seidel (G-S) method. It's a version of the…

Q: A transmission line of characteristic impedance of Zo=50 ohm with length of A/4 loaded by a load…

A: Given: A transmission line is having Characteristic equation, Z0=50 Ω Length, L=λ4 Load impedance,…

Q: The relation between impedance and admittance locus is ..

A: Admittance is the reciprocal of impedance.

Q: 14.17 The voltage a cross a load impedance is V = 12270° V and the current through it is I = 3L-20°…

Q: A lossless vacuum-filled transmission line of characteristic impedance R. = 1000 is terminated by a…

Q: A load impedance ZL = (45 - j60)2 is connected to a line that has a characteristic impedance 75Q. By…

Q: For a T.L. of Zo=50 Ohm, terminated with ZL= 100 Ohm, the value of the VSWR is: O 5 O 2 O 3

A: The solution can be achieved as follows.

Q: ) To match a load of ZL = 30 (2), to a transmission line with characteristic (f) ( impedance Zo = 75…

A: According to the question, to match a load line, we need to find the distance of the quarter-wave…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 50-ohm load is attached to a
transmission line with characteristic
impedance of ZO = 93.6 – j3.64 ohms.
Evaluate the reflection coefficient at the
load.
O -0.304+j0.0176
O 0.304-jo.0176
O 0.152-j0.0176
O -0.152+j0.0176

Expert Solution

Step 1

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Each of the conductor in a parallel-plate capacitor is calleda. dielectricb. insulatorc. platesd. terminal
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
Question 2: With the help of mathematical expression and wave forms prove the following. a. V and I are in the phase in purely are circuit. b. V leads I in purely inductive circuit. c. I leads V in purely capacitive circuits.
phase The conductirs in a singke line are 6m above the guünd. gnünd. Each conductrs are spaced 3m a pant. Calculate the capacitance Capaci tance per milo, of the live if' bothe thu conductors radii s 75 mum. a.erdudlirg ground ef fet (ufvestal) b. mcluding gound effed.
Draw the waveform of voltage and current under the following conditions: A current which lags the voltage by 60°. A current which leads the voltage by 60°. A current which is in phase with the voltage
15. You are working on a power factor correction installation, and you notice with a clip-on ammeter as you add in capacitance the current drops, you add more capacitance and the current drops, you add more capacitance the current rises. How do you know when you are at unity power factor?
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
Find loss tangent and dielectric constant