A 1250-kg car drives up a hill that is 16.2 m high. During the drive, two nonconservative forces do work on the car: (i) the force of friction, and (ii) the force generated by the car’s engine. The work done by friction is -3.11 x 105J ; the work done by the engine is + 6.44 x 105J. Find the change in the car’s kinetic energy from the bottom of the hill to the top of the hill. Draw and Explain.

Q: Activity A Direction: Count the number of significant figures of the following: 1. 1.002 km 2. 3.090…

A:

Q: A 0.220 kg string is attached to opposite sides of a room that is 4.30 m across. If the string is…

A:

Q: 19. What is the voltage across the 6.02 resistor in the diagram below? ε = 12.0V r = 0.20 Q 2.00 Ω M…

A:

Q: An archery bow is drawn a distance d = 0.49 m and loaded with an arrow of mass m = 0.078 kg. The bow…

A:

Q: 12. The cell in the diagram below is short-circuited with a wire of resistance 0.10 2. What is the…

A:

Q: 1. A bullet of mass m, 0.0500 kg is fired into a block of wood of mass m₂ = 0.850 kg. This block of…

A:

Q: A computer adapter carries a voltage of 19.5 Volts and a current of 3.33 Amps. What is the…

A:

Q: 27. In an RLC series circuit, the voltage amplitude and frequency of the source are 100 V and 500…

A:

Q: 6. The spring shown in the figure is compressed 50 cm and used to launch a 100kg physics student.…

A: Force constant of spring(k) =80000 N/m Spring is compressed by x=50Cm=0.5 m Mass of student (m) =100…

Q: 17. You have three 6.0 k resistors. By combining these three resistors in different combinations,…

A:

Q: Choose all of the processes from below which describe changes which are independent of the path by…

A: The path function depends on the path its takes from one point to another.   The elevation…

Q: A 50.0 object is moving at a velocity of 30.0 m/s must come to a stop in 2.00m. How much force is…

A: Given data:  Mass (m) = 50.0 m/s Initial Velocity (u) = 30.0 m/s Final velocity (v) = 0 m/s Distance…

Q: State Kepler's third law

A: Introduction: Kepler's law states the planetary motion of the plane, which is given by Johannes…

Q: How much of work (W) is done by a 100 kg firefighter with 65 kg of equipment when climbing a 9 m…

A: The net work done required will be equal to change in fireman's mechanical energy .Since he moves at…

Q: As an Acapulco cliff diver drops to the water from a height of 46 m, his gravitational potential…

A: Given data:  Height (h) = 46 m Gravitational potential energy (PE) = 25000 J Required: The diver's…

Q: A 1.90-mol sample of oxygen gas is confined to a 4.99-L vessel at a pressure of 8.02 atm. Find the…

A: Given, n = 1.90 mole Volume, V  = 3.99 L Pressure , P = 8.02 atm = 8.13×105 Pa Average translational…

Q: Statitics of Rigid Bodies Answer #1 with complete solution

A: Component of a vector along x axis = A cosθ î  Component of a vector along y axis = A Sinθ ĵ

Q: 1.A mass is attached to the bottom of a vertical spring. This causes the spring to stretch and the…

A:

Q: The cone of a loud speaker oscillates in simple harmonic motion at a frequency of 262 Hz (“middle…

A:

Q: gun horizontal. If the muzzle speed is 1600 ft/sec, find the time of flight and the distance from…

A:

Q: 2. (MOMENTUM AND IMPULSE) In Cases A and B illustrated below, identical balls collide with a wall.…

A:

Q: Suppose a quasar is shining with a luminosity L. What is the approximate minimal mass of the black…

A: Solution:   Given  A quasar is shining with a luminosity L L = 1×1012 LSun We have to determine…

Q: Radiation An orange orb has an emissivity of 0.646 and its surroundings are at 184°C. The orange orb…

A:

Q: A double-slit interference pattern is observed on a screen with the intensity graph. Points A, B, C,…

A: the points of bright fringes = A , B , C , D , E the points of dark fringes = F , G , H , I , J , K…

Q: Two centrifuges rotate at the same peripheral velocity of 53.34 m/s. The first bowl has a radius of…

A: centrifugal force: The apparent outward force that a rotating mass experiences is known as…

Q: (10¹) A single conducting circular coil with radius of 1.3 m is placed in a uniform magnetic field…

A: Given: The radius of the coil is 1.3 m. The strength of the magnetic field is 3 T.

Q: You kick a soccer ball of mass 0.42kg initially on the ground with a speed 6m/s at an angle 55 above…

A: Given:  Mass of the ball is m= 0.42 kg Initial speed of the ball u = 6  ms Angle made by initial…

Q: A projectile is shot from the top of a building 96 ft high from a gun at an angle of 30° with the…

A:

Q: Suppose a 2.90 N force can rupture an eardrum having an area of 1.26 cm2 . (a) Calculate the maximum…

A:

Q: An object is placed 50 cm from a convex lens having a focal length of 13.5 cm. A. Draw a diagram of…

A: Given, An object is placed 50 cm from a convex lens having a focal length of 13.5 cm.

Q: (a) The electron’s energy is measured with an uncertainty no greater than 0.8 eV. Determine the…

A: Given, a) The electron’s energy is measured with an uncertainty no greater than 0.8 eV.   Let the…

Q: The crystalline lens of the human eye is a double-convex lens made of material having an index of…

A: A virtual image is created between the convex lens' optical centre and focus when an object is…

Q: A projectile is shot from a top of a building 96 feet high from a gun at an angle of 30 degrees with…

A: Given data: The angle, θ=30° A projectile is shot from a top of a building 96 feet  The muzzle speed…

Q: Consider a parallel-plate capacitor having an area of 2550 mm^2 and a plate separation of 4.9mm and…

A:

Q: 1.The work required to stretch a certain spring from an elongation of 4.00 cm to an elongation of…

A:

Q: A)Several years ago while participating in an early spring adventure race I had to cross a rapidly…

A:

Q: A ramp of mass M=5M=5 kg is at rest on a horizontal surface. A small cart of mass m=1m=1 kg is…

A: Conservation of linear momentum: The conservation of linear momentum states that the momentum of a…

Q: While in flight, an unstable particle decays into three pions (rest mass 140 MeV/c²) according to…

A:

Q: Consider an ideal solenoid X that carries a current 2I. Another solenoid is wrapped around solenoid…

A:

Q: A 900 g copper rod at 20 degrees celcius has a length of 1.0000 m. The thermal expansion coefficient…

A:

Q: 3. Two immiscible liquids A and B are in a container. A 100-g object is dropped onto the container…

A:

Q: A cubical block of with side length = 12.0 [cm] floats at the interface between some liquid (P =…

A:

Q: A typical nucleus is 10 x 10-15 m. Use the uncertainty principle to estimate the minimum momentum…

A:

Q: A 4.8-cm-diameter parallel-plate capacitor has a 0.56 mm gap. You may want to review (Pages 884-886)…

A:

Q: Describe from your own experience an example of a free-end reflection and a fixedend reflection.

A: Fixed end reflection:- When the pulse is reflected off of the fixed end, it is inverted. In other…

Q: A pickup truck (2,200 kg) and a compact car (1,100 kg) are moving so that they have the same…

A:

Q: 3 1. The density of mercury is 1.36 × 10¹ kg/m³. What is the mass of a 2.16 × 10-m³ sample of…

A: Given data:  Density (ρ) = 1.36×104 kg/m3 Volume (V) = 2.16×10-4 m3 Required: The mass (m)

Q: 7. Complete the following statement: In general, the term Pressure refers to A) a change in volume.…

A: In general the term pressure refers to                   C) a force per unit area

Q: Consider an asymmetric p-n junction which has a heavily-doped n-type side relative the p-type side.…

A: In a p-n junction diode, two sides of a semiconductor are doped differently. One side is doped with…

Q: In your own words, distinguish between wave speed and frequency.

A: Difference between wave speed and frequency-----