A 1130-kg car is held in place by a light cable on a very smooth (frictionless) ramp, as shown. The cable makes an angle of 31° above the surface of the ramp, and the ramp itself rises at 25.0° above the horizontal. Find the tension in the cable ?

A 1130-kg car is held in place by a light cable on a very smooth (frictionless) ramp, as shown. The cable makes an angle of 31° above the surface of the ramp, and the ramp itself rises at 25.0° above the horizontal. Find the tension in the cable ?

Name: A 1130-kg car is held in place by a light cable on a very smooth (fri
Uploaded: 2024-03-20T06:57:57.000Z
Channel: Bartleby
Description: A 1130-kg car is held in place by a light cable on a very smooth (frictionless) ramp,as shown. The cable makes an angle of 31° above the surface of the ramp, and theramp itself rises at 25.00 above the horizontal. Find the tension in the cable ?A) 4

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter5: Newton's Laws Of Motion

Section: Chapter Questions

Problem 76PQ: Jamal and Dayo are lifting a large chest, weighing 207 lb, by using the two rope handles attached to...

See similar textbooks

Similar questions

A uniform pole is propped between the floor and the ceiling of a room. The height of the room is 7.80 ft, and the coefficient of static friction between the pole and the ceiling is 0.576. The coefficient of static friction between the pole and the floor is greater than that between the pole and the ceiling. What is the length of the longest pole that can be propped between the floor and the ceiling?
An automobile driver traveling down an 8% grade slams on his brakes and skids 30 m before hitting a parked car. A lawyer hires an expert who measures the coefficient of kinetic friction between the tires and road to be k = 0.45. Is the lawyer correct to accuse the driver of exceeding the 25-MPH speed limit? Explain.
A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull the block with a horizontal force of 95.0 N for 1.54 s. a. Determine the magnitude of each force acting on the block of ice while you are pulling. b. With what speed is the ice moving after you are finished pulling? Repeat Problem 71, but this time you pull on the block at an angle of 20.0.
Why is the following situation impossible? A 1.30-kg toaster is not plugged in. The coefficient of static friction between the toaster and a horizontal countertop is 0.350. To make the toaster start moving, you carelessly pull on its electric cord. Unfortunately, the cord has become frayed from your previous similar actions and will break if the tension in the cord exceeds 4.00 N. By pulling on the cord at a particular angle, you successfully start the toaster moving without breaking the cord.
An iron bolt of mass 65.0 g hangs from a string 35.7 cm long. The top end of the string is fixed. Without touching it, a magnet attracts the bolt so that it remains stationary, but is displaced horizontally 28.0 cm to the tight from the previously vertical line of the string. The magnet is located to the right of the bolt and on the same vertical level as the bolt in the final configuration. (a) Draw a free-body diagram of the bolt. (b) Find the tension in the string, (c) Find the magnetic force on the bolt.
Why is the following situation impossible? Your 3.80-kg physics book is placed next to you on the horizontal seat of your car. The coefficient of static friction between the book and the seat is 0.650, and the coefficient of kinetic friction is 0.550. You are traveling forward at 72.0 km/h and brake to a stop with constant acceleration over a distance of 30.0 m. Your physics book remains on the seat rather than sliding forward onto the floor.
A car is stuck in the mud. A tow truck pulls on the car with the arrangement shown in Figure P5.24. The tow cable is under a tension of 2 500 N and pulls downward and to the left on the pin at its upper end. The light pin is held in equilibrium by forces exerted by the two bars A and B. Each bar is a strut; that is, each is a bar whose weight is small compared to the forces it exerts and which exerts forces only through hinge pins at its ends. Each strut exerts a force directed parallel to its length. Determine the force of tension or compression in each strut. Proceed as follows. Make a guess as to which way (pushing or pulling) each force acts on the top pin. Draw a free-body diagram of the pin. Use the condition for equilibrium of the pin to translate the free-body diagram into equations. From the equations calculate the forces exerted by struts A and B. If you obtain a positive answer, you correctly guessed the direction of the force. A negative answer means that the direction should be reversed, but the absolute value correctly gives the magnitude of the force. If a strut pulls on a pin. it is in tension. If it pushes, the strut is in compression. Identify whether each strut is in tension or in compression.
A sled and rider have a total mass of 56.8 kg. They are on a snowy hill accelerating at 0.7g. The coefficient of kinetic friction between the sled and the snow is 0.18. What is the angle of the hills slope measured upward from the horizontal? You may find a spreadsheet program helpful in answering this question.
The leg and cast in Figure P4.40 weigh 220 N (w1). Determine the weight w2 and the angle needed so that no force is exerted on the hip joint by the leg plus the cast. Figure P4.40
(a) What is the minimum force of friction required to hold the system of Figure P4.74 in equilibrium? (b) What coefficient of static friction between the 100.-N block and the table ensures equilibrium? (c) If the coefficient of kinetic friction between the 100.-N block and the table is 0.250, what hanging weight should replace the 50.0-N weight to allow the system to move at a constant speed once it is set in motion? Figure P4.74
If you press a book flat against a vertical wall with your hand, in what direction is the friction force exerted by the wall on the book? (a) downward (b) upward (c) out from the wall (d) into the wall.
Calculate the normal force on a 15.0 kg block in the following circumstances: (a) The block is resting on a level surface. (b) The block is resting on a surface tilted up at a 30.0 angle with respect to the horizontal. (c) The block is resting on the floor of an elevator that is accelerating upwards at 3.00 m./s2. (d) The block is on a level surface and a force of 125 N is exerted on it at an angle of 30.0 above the horizontal. (Sec Section 1.5.)