A 111- resistor, a 0.150-uF capacitor, and a 5.77-mH inductor are connected in series to agenerator whose voltage is 27.8 V. The current in the circuit is 0.150 A. Because of theshape of the current-versus-frequency graph (shown), there are two possible values forthe frequency that correspond to this current. Obtain these two values. Give (a) thesmaller value, and (b) the larger value. Note: The ac current and voltage are rms values andpower is an average value unless indicated otherwise.

Answered: Image /qna-images/answer/3b16d193-6787-4435-8e66-2dfd44571560.jpg

Answered: A 111- resistor, a 0.150-uF capacitor,…

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter12: Electric Current And Related Variables In Engineering

Section: Chapter Questions

Problem 20P

See similar textbooks

Similar questions

The bar ABC in the figure below consists of an AB tube, with an outside diameter of 28 mm and a thickness of 4 mm, connected to a solid bar BC 12 mm in diameter. It is requested to obtain: a) The normal voltage acting on tube AB. b) The normal voltage acting on bar BC.
The heater of the automatic defroster in a refrigerator is a resistance wire.The heater uses 110 volts and draws 4.8 amperes of current. Find in ohmsthe resistance.
the algebraic sum of the potential rises and drops around a closed loop is zero Current divider KCL KVL Voltage division
ANSWER NUMBER 2- (ii) Find the value of V.
Suppose there is a RLC circuit connected across an AC source. How does increasing the resistance affect the resonant frequency of the circuit? Increasing the resistance decreases the resonant frequency Increasing the resistance has no effect on the resonant frequency Increasing the resistance increases the resonant frequency
If a 1500-W hair dryer is connected to a 120-V line. What is the maximum current drawn? I = [ Select ] What is the resistance? R = [ Select ]
An Aluminum wire has a length of 200 m and a diameter of 10 mm. Find its resistance of the wire. Select the correct response. O 56.2384 milli-ohm 42.6343 milli-ohm O 72.0654 milli-ohm 32.3253 milli-ohm
509% Part (b) Consider a 5.0om long wire of mass 10.0 g. The wire is suspended between the poles of a magnet as shown (end view of wire). When a 0.7 A current in the wire is turned on, the wire and magnet are attracted to each other. wire What can you learn about the magnet and the direction of the current through the wire with this information?
Find the magnitude and direction in X and Y of the motion of the joint at point C of the flat truss supporting a load of 1000 N as shown in the figure below. The value of E=210GPA for each member, the elements have a circular section with an external diameter of 75 mm and a thickness of 5 mm. Use the work and energy method. (In the picture it says 10 but it's 1000) E D B 1920 mm 1080 mm ION 810 mm 1440 mm
Two steel cables of diameter 8 mm are supporting a rigid beam as shown in the figure. If the applied load on the member is 30 KN, What is the angle of rotation of the rigid beam about point O?. E-200 GPa Your answer: O 63.8 degrees O 0.058 rad O2.44 degrees A -1.2m 12m 0.6m O 0.117 rad O 1.2 m 0.117 degrees 1.8 m 30 KN
The sinusoidal waveform of an ac circuit shows that the: <-90% O the current is leading the applied voltage by 90 O applied voltage is leading the current by 90 O applied voltage is lagging the current by 90 applied voltage is in phase with the current
Determine the resistance and conductance of 20m 20m of copper wire 2mm in diameter. P=1-72x10²

SEE MORE QUESTIONS

Recommended textbooks for you

Engineering Fundamentals: An Introduction to Engi…

Civil Engineering

ISBN:

9781305084766

Author:

Saeed Moaveni

Publisher:

Cengage Learning