A 0.15-kg glider is moving to the right on a Frictionless, horizontalair frack with a speed oF 0-8 ms it has a head-on collisionwith a 0.3- kg glider that is noving to the left with a spedf 2.2 m/s. Find the firal velocity (magnitide & direction)glider ir the co\lision is elastic.eachOF

Answered: Image /qna-images/answer/f61d9ec7-e29d-466a-b795-778a58ea4ee5.jpg

A 0. 15-kg glider is koving to the right air frack with a speed of 0-8 ms it has a head -on colision with a 0.3-Kg glider that is noving to the left with a sped of 2.2 m/s- Find the final velocity (magnitide & direction) of each glider ir the co\lision is eastic on a Fictionless, horizontal

A 0. 15-kg glider is koving to the right air frack with a speed of 0-8 ms it has a head -on colision with a 0.3-Kg glider that is noving to the left with a sped of 2.2 m/s- Find the final velocity (magnitide & direction) of each glider ir the co\lision is eastic on a Fictionless, horizontal

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 2.) If block B moves downward with an A acceleration of 0.2 m/s/s, find the acceleration of block A.

Q: 3. The ball is kicked from point A with the initial velocity va 10 mis. Determine the range R and…

A: Given, vA=10 m/s

Q: select three different vertical positions to hit the block and determine the required velocities to…

Q: A 3 ft diameter vertical cylindrical tank open to the atmosphere contains 1 ft high water. The tank…

Q: A support is built for a duct. Find to the nearer degree the angle that thesupport makes with the…

Q: the shaded area shown in the figure fied Moment of Inertia With respect to the X-axis. 2cm -10m-

A: Consider the figure,

Q: A small button placed on a horizontal rotating platform with diameter 0.320m will revolve with the…

A: Given a small button placed on a horizontal rotating platform. It is required to find the…

Q: By using Unit Load Method for Beam AB Detemine; 1. The Maximum Deflection. 13 kN/m 2. The Slope…

Q: QUESTION 5: Disk A has a mass of 2 kg and is sliding forward on the smooth surface with a velocity…

A: step 1-

Q: Q2: An open Im diameter tank contains water at a depth of 0.7m when at rest. As the tank is rotated…

Q: Compute for the moment of inertia of the shaded region about its horizontal centroidal axis.

Q: 3) A body is thrown vertically upward with vo = 20 m/s. Find the velocity after 1.5 sec. %3D

Q: 4 ft 4 ft Locate the center of gravity along the y-axis of the homogeneous "bell-shaped" volume…

A: Let us analyse the question in step 2.

Q: Fluid mechanics, vane question: Determine the external reactions in the x- and y-directions needed…

A: We have to determine the external reactions in the X and Y direction respectively. Given…

Q: Q4) Find the natural frequencies of the system below ( without using lagrange or energy equations).…

A: We have to find the value of natural frequency of the given system.

Q: 9. Equation of motion for vortex flow does not take into account centrifugal force? a) True b) False

Q: The platform is rotating such that, at any instant, its angular position is 8 = (0.85t³ -0.87t2² +9)…

A: Given :

Q: The velocity of block A is 4m/s upward while the velocity of block C is 8m/s upward. Determine the…

A: Introduction : The rate of change of an object's position with regard to a frame of reference is its…

Q: Compute the natural frequency in side sway for the frame is figure below. If the initial…

A: Given, Initial displacement= 35mm Initial velocity = 20mm/s

Q: A ball is thrown vertically upward with an initial speed of 79 ft/sec from the base A of a cliff…

A: Given- H = 68 ft v0 = 79 ft/sec

Q: A jet issues from the side of the tank under a head of a=4.36m. The orifice is positioned 5.94…

A: Determine the point it strikes a horizontal plane

Q: A pulley has a constant angular acceleration of 3 rad/s². When the angu 2rad/sec, that the total…

A: Given data angular velocity, w=2rad/sec constant angular velocity, αC=3 rad/s2 Total angular…

Q: The crate in an inclined plane (angle of inclination, 82=10. has a masS M-200 kg and is subjected to…

A: Given Data: Mass of crane=m=200 Kg g=10 m/s2 θ1=20 degrees θ2=10 degrees It is asked to find…

Q: The disk rolls without sliding on the fixed horizontal surface. At the instant shown, the…

A: The given figure shows the rod and a disk, it is required to find out the region of instantaneous…

Q: Q1/ a circular horizontal disk with a 10 cm diameter has a clearance of 1 mm from a horizontal…

A: Given: diameter of disk = 10 cm Clearance = 1mm angular velocity = 100radians/min v = .003m2/s…

Q: The baseball player at A hits the ball with with vo = 15 m/s at an angle of 60°. Player B, who is 5…

A: Determine Speed at B and distance d??

Q: Compute the natural frequency in side sway for the frame is figure below. If the initia displacement…

Q: A golf ball is driven off a tee that is elevated 10m above the fairway. The initial velocity of the…

Q: 1. Determine the minimum jet velocity, Vo, and the angle, 0, required for the jet to reach the top…

Q: moment distribution method 20kN /m 4m IC 3'

Q: A 3-ft-diameter vertical cylindrical tank open to the atmosphere contains 1-ft-high water. The tank…

A: Diameter of vertical cylindrical tank = 3ft Height of water at tank = 1 ft Tank is rotated about its…

Q: Fon-1 ►750 lb/ft? 1217 Ib/ft? 아-1211 - Y 7 - tusc

A: Draw the free body diagram of the given problem:

Q: Water enters a two-armed lawn sprinkler along the vertical axis at a rate of 150 L/s, and leaves the…

A: The area of the outlet of the jet is calculated as, Ajet=π4d2=π40.022=3.14×10-4 m2

Q: Q.1.18 Compute the natural frequency in side sway for the frame is figure below. If the initia…

Q: A bead moves along a circular wire. Its speed increases at as2t - 4m/s?, Its initial (at t=0)…

A: For the given bead,

Q: b1 - - b2 + b2 -E b1 h2 h2 h2 h2 b1 b1

A: For Rectangle : Moment of Inertia about centroidal axis IGG = bd3/12..

Q: SITUATION. A 35kg disk rests on an inclined surface for which us=0.20 W P A B C 0 Zoom image…

Q: A 450-N is in contact with a level plane of fy = 0.10. The block is acted upon by a horizontal force…

Q: What is the magnitude of the moment of F about point B? F= 15i + 12j – 8k (kN) |(4, 4, 2) m .в (6,…

A: The force F is given as: The vector BA is calculated as: Now the moment of F about point B is…

Q: A power plant emits SO, at the rate of 80 g/s from a stack. If the concentration of SO, at the…

A: To find :- The height of stack so that the SO2 concentration be limited to 0.00001 g/m^3

Q: *19-20. The 100-kg spool is resting on the inclined surface for which the coefficient of kinetic…

A: Solution Given Data Mass of Spool = 100 kg Coefficient of kinetic friction μK=0.1 Radius of gyration…

Q: Initial velocity of the ball, vo 29.50 m/s, upward from the ground Determine the distance, d, if the…

Q: W=2 KN/m 2- Drive the equation of motion which describes the oscillation of the frame shown in the…

A: Since no details regarding the damping are mentioned in the question, hence the damping terms are…

Q: The coefficients of friction between the 18-kg block and the 3-kg platform BD are µs = 0.50 and =…

A: Acceleration is the rate of change of velocity with respect to time. It is a vector quantity as it…

Q: Q.21 Compute the natural frequency in side sway for the frame is figure below. If the initia…

Q: Prob. 1. The 300N block rests upon a level plane for which the coefficient of kinetic friction is…

Q: Determine the horizontal velocity vA Of a tennis ball at A so that it just clears the net at B.…

Q: A ball Is thrown vertically upward from the 12-m level in an elevator shaft with an initial velocity…

A: We have to determine the time when the ball hit the elevator, where will the ball hot the elevator…

Question

A 0.15-kg glider is moving to the right on a Frictionless, horizontal
air frack with a speed oF 0-8 ms it has a head-on collision
with a 0.3- kg glider that is noving to the left with a sped
f 2.2 m/s. Find the firal velocity (magnitide & direction)
glider ir the co\lision is elastic.
each
OF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An 8-m simply supported beam carries a concentrated load of 40 kN at a distance of 3.25 m from the left support. Calculate the deflection (mm) at the point of maximum moment. The flexural rigidity EI is equal to 10000 kN-m². Enter a positive value. Just indicate the direction of the deflection in your solution.
An 8-m simply supported beam carries a concentrated load of 40 kN at a distance of 3.25 m from the left support. Calculate the deflection (mm) at the point of maximum moment. The flexural rigidity EL.is equal to 10000 kN-m². Enter a positive value. Just indicate the direction of the deflection in your solution.
A 85 Ib thin panel is placed in an aircraft at an angle of 60 during landing. End A sits on the rough horizontal surface with an unknown frictional coefficient and end B sits on a smooth horizontal surface with a negligible frictional coefficient. The panel has length 10 ft and the deceleration of the plane is 11 f/. Determine the reactions at endpoints A and B as well as the minimum frictional coefficient to maintain equilibrium. The normal force at A is (put units in second box). The normal force at B is (put units in second box). The static coefficient necessary to maintain equilibrium is The reaction at A is (units) with an angle of degrees.
An 8-m simply supported beam carries a concentrated load of 40 kN at a distance of 3.25 m from the left support. Calculate the deflection (mm) at the point of maximum moment. The flexural rigidity EI.is equal to 10000 kN-m². Enter a positive value. Just indicate the direction of the deflection in your solution.
4 - A rubber material is attached between two rigid plates. If the lower plate is held in place, what load P is needed to produce a relative displacement of 0.5 mm between the two plates? The rubber material has a shear modulus G = 0.0010 GPa. 80mm 200mm 400mm
HW1: In Figure below , the 1200N block is acted upon by the 600N force and the unknown force P as shown. The normal force of the plane on the block is 1800N, and the coefficient of friction between the plane and the block is 0.2. Determine : (a) the frictional force. (b) the unknown force P. N O09
Prob. A 60-lb uniform thin panel is placed in a truck with end A resting on a rough horizontal surface and end B supported by a smooth vertical surface. Knowing that the deceleration of the truck is 12 ft/s?, determine (a) the reactions at ends A and B, (b) the minimum required coefficient of static friction at end A. B 5 ft 60
The flywheel A rotates clockwise under the action of a 700 N-m couple. A band break is to be used to stop the rotation of A. The coefficient of friction between the belt and the flywheel is 0.40.a.) What is the minimum force applied at the end of rod B that will stop the flywheel?b.) If the 700 N-m couple acts counterclockwise on A, what is the minimum braking force P?
A uniform rigid bar which weighs 1000KN/m is supported by a cable at point B, a rough surface horizontal floor at point A, and a corner edgeof a rough surface wall at point C. If the coefficient of static friction on all contact surfaces is 0.10, determine the reaction at the supports of the uniform rigid bar. Neglect the weight of the cable.
1. A 6 kg slider is released from rest at Point A and slides with negligible friction in a vertical plane along the circular rodshown below. The attached springhas a stiffnessof 520 N/m and an unstretchedlength of 0.6 m.a. Determine the change in potential energy when the slider is at B in joules. b.Determine the change in elastic potential energy when the slider is at B in joules c. Determine the velocity of the slider at B in meters per second.
A 5.98-m simply supported beam supports a trapezoidal distributed load. The intensity of the load varies linearly from 0N/m at supports A to 60.72N/m at support B.-Calculate the location of zero shear. *Express your answer in meters-Calculate the maximum moment experienced by the beam-Explain the relationship between the shear and flxural stresses experienced by the beam
A 450-g tetherball A is moving along a horizontal circular path at a constant speed of 4 m/s. (A) Determine the angle theta in degrees that the cord forms with pole BC, (B) determine the tension in the cord in Newton