9 - if Germanium atomic density per one cubic meter is 4.4*1028 as one atom of donor atom is addedto 107 Germanium atom. The donor atomic density per one cubic meter =and P= —n=1.5*10¹0/cm³

Donor atomic density ND= (Germanium atomic density)/(10^7) =4.4*10 28/10^7 =4.4*1021 /m3

9 - if Germanium atomic density per one cubic meter is 4.4*1028 as one atom of donor atom is added to 10' Germanium atom. The donor atomic density per one cubic meter = _and P= n=1.5*10¹0/cm³

9 - if Germanium atomic density per one cubic meter is 4.41028 as one atom of donor atom is added to 10' Germanium atom. The donor atomic density per one cubic meter = _and P= n=1.510¹0/cm³

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 1RQ: 1. What is the dielectric?

See similar textbooks

Related questions

Q: Q2) Determine the back e.m.f at this load of series motor has a series field resistance of (0.301 2)…

Q: Describe the Torque-Slip characteristics of a three phase induction motor.

A: The torque-slip characteristics of the three-phase induction motor is shown below:

Q: 1- For the network of Fig. 16.40: a. Find the total impedance ZT. b. Determine the current I,. c.…

A: The required parameters can be calculated by reducing the parallel and series connected elements and…

Q: An AM transmitter is modulated by two different signals (55% and 75% modulation indices). How much…

A: Given, Modulation indices, m1=55%=0.55m2=75%=0.75 Carrier current, Ic=12 A

Q: Modulator: High level AM Series modulator +Voc Audio modulating signal Qemitter follower RFC Q₁…

A: AM modulator- AM modulator is a modulator which is used used for the superimposition of low…

Q: 3056+(8318 5. Simplify Z=(- +2318) - (1651-1356)

Q: Example 7/ An open wire T-L with G=0.29x 10-6U/Km,L-3.52 mH/Km, C=8.7 nF/Km,R=6.74 KQ/Km at F=1 KHZ,…

Q: Classify the power semiconductor devices based on its number of terminals and types of carrier…

A: Semiconductor devices are a part and parcel of the electronics industry. These devices also known as…

Q: Consider the feedback system is shown in following figure. The system has one parameters R(s) C(s)…

Q: A 1200 KVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a…

A: It is given that: 1200KVA6600 VR=0.4 ΩphX=6 Ωph

Q: 33. The efficiency of a 400 kVA, 1-phase transformer is 98.77 % when delivering full load at 0.8…

A: Here we discuss about the efficiency calculations of transformer. NOTE:- As in this 1 Q., 2…

Q: Solve the current I1 in the given circuit using Norton's Theorem

A: The given circuit is as shown below,

Q: A 208-V, 10 hp (1hp 746 W), four pole, 60 Hz. Y-connected induction motor has a full-load slip of 5%…

A: Given data, VL=208 VP0=10 hpP=4f=60 Hzs=5%=0.05

Q: Determine the approximate value of lp of Figure 56. 18 V Ip • 750 ΚΩ '91 ΚΩ Vas 2 ΚΩ OV 9V Pos loss…

A: Given circuit is shown below. We know that ID=IDSS1-VGSVP2

Q: A wire 7 mm in diameter is to offer a resistance of 10.5 2. Find the maximum wire length. o = 3.8 x…

Q: 3. Determine the line currents in an unbalanced Y connected load supplied from a symmetrical 3-6,…

A: The meaning of RYB in the three-phase electrical system is red, yellow and blue three-phase. The…

Q: ge regulation at full load current. of armature reaction as it is taken into a

A: A Synchronous generator is an electrical machine used to convert mechanical power into electrical…

Q: 2.1 Given a linear difference equation as shown below, find the output y(n) for 0 ≤ n ≤5, using the…

Q: A car is moving at a speed of 10 m/s, so if its speed is doubled due to uniform acceleration within…

A: given linear motion questions

Q: The resistance of a wire is 126.48 ohms at 100°C and 100 ohms at 30°C. Determine the temperature…

A: The resistance variation with the temperature is expressed as shown below: R=R01+α∆t∆t=Change in…

Q: In free space, the direction of the current density is: opposite the direction of the drift…

A: Given We need to determine the free space, the direction of the current density . Please find the…

Q: Let xp (t) = 8 cos(2лt) + 6 cos(8πt) + 4 cos(22πt) + 6 sin(32πt) + cos(58πt) + sin(66лt) If x₂(t) is…

Q: 2) What are the salient features of supply voltage control method? Speed control three phase…

A: Methods of Speed control of three phase induction motor: stator side, Changing number of stator…

Q: Use Laplace transform to obtain the output current i(t) in ampere for t = 1 second for the given…

Q: Question 4 An AC Voltage v(t) = 250 cos (100nt) is applied to the given circuit. ~ V (1) sine…

A: Brief description: For the given sinusoidal voltage function we need to derive peak, peak to peak ,…

Q: The current in an inductor L = 220 mH varies according to I = 3.8 sin(80t) A. Find: The induced emf…

A: Given, Inductor, L=220 mH Current in inductor, I=3.8sin80t A Time, t=2.6 ms

Q: What is the electric current that passes the 3 ohm resistance in the given circuit below? 202 402 m…

Q: 1- The efficiency of a 6600/384V, 200kVA, 1-phase transformer is 98% at full load 0.8 power factor…

A: Given data : Efficiency of transformer η=98%at full-load 0.8 power factor Efficiency of transformer…

Q: etermine the approximate value of Vo of Figure 55. VDD 121V 3910k $2.2KG2 $110kO 4V 2.97 V 132 V =…

Q: What is the total current supplied by the voltage source in the circuit below? 202 402 M m 12 V (+…

Q: Draw the equivalent circuit model and switching characteristics of the device which is having…

A: Introduction - IGBT is a stands for insulated-gate bipolar transistor. It is a power transistor…

Q: Knowing that the open loop transfer function is vā (s) 1 s²+9s +21 And the closed loop block diagram…

Q: Solve the current I1 in the given circuit using Norton's Theorem

A: The given circuit is as shown below,

Q: Two conical conducting surfaces, 0 = 20° where V = 10 [Volt], and 0 = 40° where V = 3 [Volt], are…

A: Conductive materials are the best conductors of electricity and heat. Conductors allow heat to…

Q: Q2) Determine the back e.m.f at this load of series motor has a series field resistance of (0.301 2)…

Q: For a process described by the following FOPTD model. Find the suitable Pl controller .parameters…

A: Given the FOPTD model transfer function, ysus=12s+1

Q: 2) What are the salient features of supply voltage control method?

A: Voltage Controller: A voltage controller, also known as an AC voltage controller or AC regulator, is…

Q: a circuit armature of a 4 pole generator has 51 slots , each slot containing 20 conductors . What…

A: The emf induced in the generator is given by the expression as shown below: E=PϕNZ60A If the winding…

Q: e-2t (cost + 3 sin t) 8 2 3 + (s−2)² +1 (s+ 2)² +1 Option 4 s 5 s² - 4s +5 Option 2 8+2 (s+ 2)² +1…

Q: Q1/ The following information is given for a 250-kW, 500-V, long-shunt compound generator : Shunt…

A: The terminal voltage of the generator is 500 V The power produced is 250 kW The armature resistance…

Q: Q4-Chose the correct form of the verb (only 6) 1-1 (go /am going) to play football now. Goodbye 2-1…

A: In first the correct form of verb will be :- am going. So the sentence will be- I am going to play…

Q: A rectangular bus bar has a cross-section of ½ by 1 ¾ inch. And is 25ft long. What is its resistance…

A: Given: Cross-section of ½ by 1 ¾ inch25 feet=7.62 mT=20oC

Q: In the network shown, what is the value of le in mA?

Q: State Space Representation.

Q: Develop the following problems in a clear and orderly way. Use 4 decimal places for magnitudes, real…

A: In delta connection line voltage is equal to phase voltage and line current is 3 times the phase…

Q: Determine the current using source transformation. Assigned branch current = i1 (solve using…

A: The circuit diagram is shown below,

Q: Choose the correct answer from the given alternative: 1. In an ideal transformer, (a) windings have…

Q: TRUE OR FALSE Ultimate tensile strength has the same value to yield strength in brittle materials.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 2) What are the salient features of supply voltage control method? Speed control three phase…

A: 2) to write the salient features of supply voltage control method Supply voltage control method is…

Q: Please solve the current I, in the given circuit using Norton's Theorem

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

9 - if Germanium atomic density per one cubic meter is 4.4*1028 as one atom of donor atom is added
to 107 Germanium atom. The donor atomic density per one cubic meter =
and P= —
n=1.5*10¹0/cm³

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

two dentiaal conducting SPheres have eta Charges 5.147 pC anl To851 pC sthe are Brought Ynto contacf and allowes do reaek equilibrow How many elcehouics are transfares equilibrum is attained
A charge of 20 units is placed 5 cm from a like charge of 3 units in mica. The force of repulsion is 0.52 dynes. Find the dielectric constant of mica. Select the correct response: 6.6 O 4.61 2.4 O 1.25
9. Which of the following statements about conductivity is correct? Distilled water has a lower conductivity than salt water Distilled water has a higher conductivity than salt water Distilled water and salt water have zero conductivity O Distilled water and salt water have a similar conductivity Question 10 10. Which of the following measurements of conductivity is the highest? O 1.2 mS/cm 1100 μS/cm O 0.2 mS/cm O 12 µS/cm
Assuming silicon with completely ionized dopants, compute n and p for the following case. N 5.00×10¹6 cm-³ N₁ = 0 T = 700 K -3 n (700 K)=2.865x10¹ cm-³
The Value of R1 is 39.4Ohms. explain
Calculate the mobility of electrons (m² /V.sec) of n-type material having resistivity of 0.5 Q-m, the number of donor atoms per m is 3x1019 www 0.2467 0.4167 O 0.4267 0.4507
6. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have high Dielectric strength as compared to pure liquids d) Have lower dielectric strength as compared to pure liquids e) None of the above
Four point charges are placed at corners of a square . At the top left is a charge of - 1 C, at the top right is a charge of - 2 C, at the bottom right is a charge of -3 Cand at the bottom left is a charge of - 4 C. What is the direction of the net electric force due to the four point charges on a positive charge Q located at the center of square ? O due North O due South O Sw O SE
A8-cm long wire carrying a uniformly distributed 12-µc charge is bent into a semicircle. What is the el O A) 4.2 MV B) 0.042 MV C) 0.42 MV O DI 42 MV E) 420 MV
? The unit of the electric field intensity is V/m O V/O VO V/Nm O
QUESTION 3 E-05, PC-05. While testing of capacitor with the Multimeter it will show value of? will indicate charge voltage. some resistane. Cwill indicate amount of current it has. QUESTION 4 E-05, PC-02. What are the factors affecting the capacitance of capacitor. Area of plates only. O Area of plates and Dielectric media. O Area of plate, dielectric and distance between plates.
Why Pout will not increase bu 75% So why we did not use (1+0.75)(S)Pf and only we use 0.75(s)(pf) why we did not increase it ?