8. Use the superposition theorem to find the current in and the voltage across the R₂ branch of Figure 8-69. FIGURE 8-69 2 V R₁ www 10kO R3 ww 1.0 ΚΩ R₂ 2.2 k R4 1.0 kn 3 V www R₂ 2.2 ΚΩ

Q: V₁ Road V3 = ·V. V₂ Calculate Vout for the circuit above assuming the following parameters: Hp…

A:

Q: A 34.5 KV feeder line is 5 mi long. The conductors are spaced 4 ft horizontally. The conductor is…

A: Given data: voltage of line Vl=34.5 kV Length of feeder line l=5 mi Horizontal spacing =4ft GMR of…

Q: A motor car manufacturing company has manufactured a motor car protecting circuit to warn if there…

A: The truth table can be derived from the given condition and the required boolean expression to…

Q: Plot the sinusoid for t=0 to T, where A = 150 mA, f= 35 Hz and 0 = -30°: i(t) = A sin (wt + 0)

A: Given , a sinusoid which is lag with Asin(wt) by -30 degree. The graph of both Asin(wt) and…

Q: Point charges 10 nC and 2 nC are located at (0, 0, 4) and (0, 4, 0) respectively. All the distances…

A: 6) Given point charges are Q1 = 10 nC located at P1(0,0,4); Q2 = 2nC located at P2(0,4,0); All the…

Q: 1. For the following circuits, Find i. ii. iii. iv. Transfer Function Identify whether it is low…

A:

Q: Amplifier's Frequency Response Vcc=20V R1 = 40 kohm R2 = 10 kohm Rc = 4 kohm RE=2 kohm Rs = 1 kohm…

A:

Q: 7. Find the voltage vo. 40 mV +1 Μ 5 ΚΩ 15 ΚΩ Μ + 10

A: Here lab experiment are not anwerable. I have to answer the next question.please follow. As per…

Q: Determine the pull down network of the given circuit and solve for the logic equation.

A: We need to draw the pull down network of the given circuit and need to determine the logic equation.

Q: Consider the following circuit. The frequency of oscillation is: | 47 ΚΩ 5.39 kHz 1.35 kHz 29.67 kHz…

A:

Q: Find the transfer function G(s)=X₂(s)/F(s) in the network below: 1 N-s/m 1 N/m oooo 1 kg 1…

A:

Q: Example 3. Determine v for the network of Figure 6. Example 4. Repeat Example 3 using Silicon diode.…

A: In  this question We need to determine the output voltage waveform.  If diode is ideal and silicon…

Q: A Silicon diode is operating at a room temperature of 25 °C and has a reverse current of 10 nA.…

A: The current through a silicon diode can be described by the Shockley diode equation: I = I0 *…

Q: Logic Equation (VI): Y1 = f(A,B,C)=IM(1.4) + X(3,5) 1. The truth table: A с 2. The standard SOP: 3.…

A: It is given that: Y1=fA,B,C=∏M1,4+x3,5

Q: Question 4 of 25 A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 cu. m. Find its…

A: Mass of glycerin m = 1200 kg                 Volume   v  = 0.952 cu.m                Weight…

Q: The logic circuit: (From minimum SOP) Number of gates used in the circuit: 2-Input AND gate..…

A: Number of gates used in the circuit: 2-Input AND gates = ...... ; IC name:-____ 2-Input OR gates…

Q: 7. For a 600-208 wye-wye step-down transformer with a wye connected load, what would the primary…

A: It is given that: V1V2=600208=aZ=30 Ω

Q: Given the sequential circuit of Figure P12.5, determine the output y when input A is [1 0 1 1].

A: Given sequential circuit:- Input A is [1 0 1 1].

Q: Rab = 100 Ohms (show the solution on how to get the answer)

A:

Q: R1 20 R2 302 20A R3 20 Holi V1 48V R4 ww 602 R5 40 www

A: Using superposition theorem calculation of current flowing through 6 ohm resistor. According to…

Q: Consider a circuit shown in the figure. Ignore the internal resistances of the batteries. ℰ1 = 48 V…

A: It is given that: ε1=48 V ε2=26 VR1=7 ΩR2=4 ΩR3=4 Ω.

Q: Figure shows the response of a system to a step input of magniture 1 N (w) x 0.04 0.036 0.032 0.028…

A: Settling time : The time it takes for the output to reach and stay within a specific error band…

Q: For a system gain of 112 dB, a total NF of 6.5 dB, an input noise power of -104 dBm, and a minimum…

A: We can use the following equation to calculate the minimum received carrier power required: SNRout =…

Q: the following Assuming D1 is ON and D2 is OFF, with Vs1 = 14.4 V, Vs2 = 1.3 V, R₁ = 1.9 kN, R₂ = 6.1…

A:

Q: (4) Find Current Io in the following ckt. (or) write all the Three loop equations. 710 10010 + 205 m…

A: In this question We need to determine the current Io  as shown the circuit.  We are solving this…

Q: 2. Consider the following signal: f(t) For mm T -T 0 0<t<T,f(t) = A 2T a. Find the Fourier expansion…

A:

Q: Evaluate the integrals: 10 - i. Sexp[-15t - 4] 8′(t − 4)dt S²₂ (-3t4-99) 8"(t + 1) dt ii.

A:

Q: horizontal Separator at low pressure at conditions: Gas flow rate 10.0 MMscfd Operating pressure 800…

A: The sizing of a horizontal separator requires a detailed analysis of the process conditions,…

Q: 1. For the following circuits, Find i. ii. iii. Transfer Function Identify whether it is low pass,…

A:

Q: Logic inputs A to G A +5 V PMOS network 어[ F D DOG Figure 7.46 tu (a) What is the logic function…

A:

Q: 38. Draw block diagrams for the following: ÿ +10y +47ÿ+102ỳ +90y=3. b. ÿ+10y +47ÿ+102y +90y=2e-²¹.…

A: It is asked to create the block diagrams of the given problems.

Q: satellite receiving system is designed using a dish antenna of 40dB gain. The effective radiated…

A:

Q: Solve for the equivalent resistance in Rab

A: We need to determine the equivalent Resistance between terminals 'a' and 'b'.i.e Rab.

Q: The output y(k) of a discrete-time system is given by -Σ y (k) a) b) c) k Σmu(m) m=0 where k> 0 is…

A:

Q: 7-A transistor circuit similar to Fig.1 has a collector supply voltage of 20 V, a collector…

A: We need to find out collector to emitter voltage, Vce for the given circuit.

Q: Find R initial at T initial=3°C where the temperature coefficient a-20, R final 6032 and T final…

A:

Q: Simplify the ciucult shown in Figure (1) to find the current in the (42) resistor using Source…

A:

Q: Find an expression fro the gain if Rin = infinity, Rout = 0, and Ao does not equal infinity.

A: The gain is the ratio of output voltage to the input voltage. The resistor can be replaced with its…

Q: Given 3 parallel thermal units U1, U2 and U3 where their input-output fuel functions are as follows:…

A:

Q: Using the partial fraction expansion method, find the inverse of the following z-transforms: b. X(z)…

A: here we have to find the partial and then inverse Z-transform.   we know that Z-1 zz-a = an un…

Q: 1. The voltage - current relationship of an electronic board is given by the values in the table,…

A:

Q: VOL: A: For a medium line model, draw the circle diagram only and put the value of OR, OS and Ot. If…

A: Given  Load power factor cosθR=0.85 Sending end power factor cosθS=0.83 Torque angle δ = 240

Q: 3. Determine the following: a. Total Current and currents passing through each of the resistance. b.…

A: In this question We need to determine the total current and current in the each resistance. In the…

Q: Consider a system x (t) →y (t): y(t) = tx(t+1) + x(3t-1) determine if the system is: a) linear b)…

A: Given: A system with equation,  y(t)=t x(t+1)+x (3t-1), To find: Whether the system is: a) Linear,…

Q: Example 6. Repeat Example 5 using Silicon diode. F i 5.0 = g r e 9 10 0 -20 Vi Vi C = 1 µF HE 4₁ f =…

A: here we have to find the output voltage.

Q: -14 Calculate the rms value of the ripple current in Problem 7-13 through the diode and, hence,…

A: 7.14

Q: In a single phase VSI bridge inverter, the load current is lo = 200 sin (wt - 45°) mA. The dc supply…

A: Given- A single phase VSI bridge Inverter- The load current- Io=200 sinωt-450 mA D.C. supply…

Q: 8 Ω 6Ω Μ Ω Μ 4Ω 6Ω 3A 3 Ω + C 20 V

A: Using nodal analysis at node a, b we can find voltages at these nodes ..which are Va,Vb Node d is…

Q: 1. Determine the voltage across each resistor using KVL گیا 45 V 2 + I E₁ R₁ www 5 ΚΩ 7,5 ΚΩ R₂ CO…

A:

Q: A 3-phase 4160 V Y-connected source is rated at 5 MVA. It is connected to a balanced 3-phase delta…

A:

Current Division Method

The generalized current divider formula is given by the following relation below,