5.90 . Two blocks connected by a cord passing over a small, frie- tionless pulley rest on frictionless planes (Fig. P5.90). (a) Which way will the system move when the blocks are released from rest? (b) What is the acceleration of the blocks? (c) What is the tension in the cord? Figure P5.90 100 kg 50 kg 30.0° 53.1°

5.90 . Two blocks connected by a cord passing over a small, frie- tionless pulley rest on frictionless planes (Fig. P5.90). (a) Which way will the system move when the blocks are released from rest? (b) What is the acceleration of the blocks? (c) What is the tension in the cord? Figure P5.90 100 kg 50 kg 30.0° 53.1°

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter6: Applications Of Newton's Laws

Section: Chapter Questions

Problem 47P: (a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her...

See similar textbooks

Similar questions

(a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her mass on that knee? (b) During strenuous exercise, it is possible to exert forces to the joints that are easily 10 times greater than the weight being supported. What is the maximum force of friction under such conditions? The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pam.
(a) If half of the weight of a small 1.00103-kgutility truck is supported by its two drive wheels, s hat is the maximum acceleration it can achieve on dry concrete? (b) Will a metal cabinet lying on the wooden bed of the truck slip if it accelerates at this rate? (c) Solve both problems assuming the truck has four-steel drive.
A 1.30-kg toaster is not plugged in. The coefficient of static friction between the toaster and a horizontal countertop is 0.350. To make the toaster start moving, you carelessly pull on its electric cord. a. For the cord tension to be as small as possible, you should pull at what angle abive the horizontal? b. With this angle, how large must the tension be?
A supermarket pushcart is being pushed at 45 degrees with respect to the horizontal from the starting point to the cashier, which is 25 feet away. The cart is 5kg, it contains 2 boxes of 10-1b flour and seven packs of half-kilogram sugar. The coefficient of friction between the wheels and the floor is 0.03. a. What force is required? b. How much force is required?
1. Two pulleys A and B shown are supported by a system of light cords and pulleys, which are frictionless and negligible weight. Block A is 290 kN and B is 880 kN. Calculate the acceleration of each block after release and the tension in the main cord. A В
Two blocksmịand m2 connected by a rope are being pulled by a horizontalforce F equal 160 N. Suppose that mį=10 kg,20 kg, and the coefficient of kineticm 2 =20 kg10 kgfriction between each block and the surfacem1is 0.52.A. Draw free-body diagrams of both objects.B. Find the acceleration of the systemC. Find the tension in the ropeD. What is the distance that the system ( two masses) will travel if youknow that are started from rest and final velocity is 4.5 m/sec(B) a= { F
Consider the figure shown in the following figure. You are loweringtwo boxes, one on top of the other, down a ramp by pulling on a ropeparallel to the surface of the ramp. Both blocks move with constantvelocity of 10.0 [m/s]. The coefficient of kinetic friction between theramp and the lower box is 0.555 and the coefficient of static frictionbetween the two boxes is 0.750. A. Draw the Free-Body diagram of both blocks. Set the ?-axis parallel to the ramp. B. Write Newton’s 2nd law along the ? and ? directions for both blocks considering their state of motion (accelerations). C. What are the magnitude and direction of the frictional force on the upper box? D. What is the magnitude of the applied force? E. Determine the angle at which the top block will start to slide down the bottom block.
Consider the figure shown in the following figure. You are loweringtwo boxes, one on top of the other, down a ramp by pulling on a ropeparallel to the surface of the ramp. Both blocks move with constantvelocity of 10.0 [m/s]. The coefficient of kinetic friction between theramp and the lower box is 0.555 and the coefficient of static frictionbetween the two boxes is 0.750. A. Draw the Free-Body diagram of both blocks. Set the ?-axis parallel to the ramp. B. Write Newton’s 2nd law along the ? and ? directions for both blocks considering their state ofmotion (accelerations). C. What are the magnitude and direction of the frictional force on the upper box? D. What is the magnitude of the applied force? E. Determine the angle at which the top block will start to slide down the bottom block.
moodle.nct.eduom/mod/qi -Learning Portal Courses - Reports - e-Services- Academic Departments - ETC - CIMS - A 17kg crate resting on a horizontal surface is pushed as shown. If the coefficient of static friction u, between the surfaces is 0.24, what is the minimum force (F) required to start the motion? O a 4.08N O b. 70.83N Oc 39.98N Od. 694.17N Windows buut An object of mass Skg is sliding with a constant velocity of 10m/s on a frcitionless horizontal table. The force needed to keep the object moving with the same velocity is. 144 4- # 4. 6. V.
The leg and cast in Figure P4.18 weigh 200 N, with the center of mass as indicated by the blue arrow in the diagram. The counterbalance w, weighs 105 N. Determine the weight w, and the angle a needed so that no force is exerted on the hip joint by the leg plus cast. N W2 Wi 40% Figure P4.18
5.68 CP In Fig. P5.68 m₁ = 20.0 kg and a = 53.1°. The coefficient of .. kinetic friction between the block and the incline is μ = 0.40. What must be the mass m₂ of the hanging block if it is to descend 12.0 m in the first 3.00 s after the system is released from rest? Figure P5.68 m₁ α m₂
H.W: Two blocks connected by a cord passing over a small frictionless pulley rest on frictionless plane, as in fig. below, (a)which way will the system move? (b)what is the acceleration of the block (c)what is the tension in the cord? Ans.(a) To left (b)0.65m/s² (c)43.37N N-100Neut. 7 ī N=50Neut my 50.10 Kg) m₂. 10.20 Kg