REN5.2.2/3 The hoop is cast on the rough surface such that it has an angular velocity = 3 rad/sand an angular acceleration a = 8 rad/s². Also, its center has a velocity of v.= -51 m/sand a deceleration a 21 m/s². Determine the acceleration of point B at this instant.DIS12~15DfNº0.39an=r w²an= 0.s. 32an = 43anB30°0.5 mw = 3 rad/sx = 8 rad/s²D

Answered: Image /qna-images/answer/acf347b5-e006-42be-b854-07517f69dac9.jpg

5.2.2/3 The hoop is cast on the rough surface such that it has an angular velocity = 3 rad/s a = 8 rad/s². Also, its center has a of v. = -51 m/s an and a deceleration de 21 m/s². Determine the acceleration of point B at this instant. dis ~15 "/> de D 0.31 an=r w² an²015. 32 an=43 cosso 17 CA B 30° 0.5 m w = 3 rad/s x = 8 rad/s² D 1450

5.2.2/3 The hoop is cast on the rough surface such that it has an angular velocity = 3 rad/s a = 8 rad/s². Also, its center has a of v. = -51 m/s an and a deceleration de 21 m/s². Determine the acceleration of point B at this instant. dis ~15 "/> de D 0.31 an=r w² an²015. 32 an=43 cosso 17 CA B 30° 0.5 m w = 3 rad/s x = 8 rad/s² D 1450

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The Scotch-yoke mechanism converts rotational motion of the disk to oscillatory translation of the shaft. If 0 = 470, w = 2.72 rad/s, a 1.92 rad/s2, r 375 mm and d 880 mm, determine the velocity and acceleration of point Pof the shaft. The velocity and acceleration are positive if to the right, negative if to the left. A Answers: m/s i Vp m/s ap
8. The constant angular acceleration of the rotating disk is 12 rad/s2. The angular velocity of the disk is 24 rad/s clockwise when t = 0. Determine the total angle turned by the disk between t = 0 and t = 4sec. ANS: 48 rad
Question 6 to this answer. At the instant shown, the bar AB has a velocity of 4.8 rad/s clockwise. If a = 0.22 m, b = 0.33 m,0 = 24°, and a = 52° at this instant. Determine the magnitude of the velocity in m/s of roller C. A 0 α A
The ends of the 0.38-m bar remain in contact with their respective support surfaces. End B has a velocity of 0.46 m/s and an acceleration of 0.59 m/s² in the directions shown. Determine the angular acceleration a (positive if counterclockwise, negative if clockwise) of the bar and the acceleration of end A (positive if up, negative if down). 24 0.38 m 101 aB = 0.59 ms² Ug -0.46 ms B Answers: a = i ! rad/s2 aA = i ! m/s?
For the diagram below the angular velocity of the wheel is w = 2rad/s. The location of the instantaneous center of zero velocity is at point 0.3 m OD 1.2 m OB 45% O somewhere not listed in the other options. OC 0.3 m C
determine the magnitude of velocity at C if the angular velocity of bar BCD is 5.35rad/s CCW and velocity of D is 2.65m/s. Also, the angular velocity of bar DE is 12.5 rad/s. please give detailed solution when getting velocity using trigonometry
4. 4) The hydraulic cylinder D extends, moves the rigid rod ABC, and causes the collar A to move with velocity and acceleration both to the left. If the dimensions 1 = 1.1 ft, and 2 = 2.3 ft, VA = 4.7 ft/s, aa = 2.7 ft/s², and the angle 0 = 25°, determine the angular acceleration (in rad/s2) of rod ABC. Negative sign must be included if the angular acceleration is clockwise. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. %3D 12 D а Your Answer: Answer
The car started to move forward with the passenger's door fully open (0 = 0). This caused the door to rotate about its axis with an angular acceleration a = 10 cos 0, where a is in rad/s?. Determine the angular velocity (w) of the door as it closes fully (0 = 90°). a. 1.748 rad/s теат b. 2.977 rad/s c. 3.831 rad/s O d. 2.258 rad/s e. 4.472 rad/s
The ends of the 0.72-m bar remain in contact with their respective support surfaces. End B has a velocity of 0.40 m/s and an acceleration of 0.27 m/s? in the directions shown. Determine the angular acceleration a (positive if counterclockwise, negative if clockwise) of the bar and the acceleration of end A (positive if up, negative if down). 34 0.72 m $105 -0.27 m -0.40 me Answers: rad/s m/s?
The constant angular acceleration of the rotating disk is 12 rad/s2 . The angular velocity of the disk is 24 rad/s clockwise when t = 0. Determine the total angle turned by the disk between t = 0 and t = 4sec.
4. 4) The hydraulic cylinder Dextends, moves the rigid rod ABC, and causes the collar A to move with velocity and acceleration both to the left. If the dimensions/₁ 1.0 ft, and /2 = 2.0 ft, vµ = 5.5 ft/s, aµ = 2.1 ft/s², and the angle 0 = 30°, determine the angular acceleration (in rad/s²) of rod ABC. Negative sign must be included if the angular acceleration is clockwise. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. Your Answer: 1₁ Answer B 12 ÏÏ a =
The telephone-cable reel rolls without slipping on the horizontal surface. If point A on the cable has a velocity VÀ = 0.84 m/s to the right, compute the velocity of the center O (positive if to the right, negative if to the left) and the angular velocity w (positive if counterclockwise, negative if clockwise) of the reel. Answers: Vo = W = 1.91 m i 0.69 m 1.315 1.37705 Ja m/s VA A rad/s