5. For the system shown in Fig. 7, m₁ = 10 kg and the absorber mass m₂ = 2.5 kg. If m₁ is excited by a 1 Nm unbalance rotating at 1800 rpm, determine the proper value of the absorber spring k₂. What will be the amplitude of m₂. kaz m2 Figure 7 mij −12 ܓܔܓܔܓܔܓܔܓܔܔܔܓܔܛܔܔܐ

5. For the system shown in Fig. 7, m₁ = 10 kg and the absorber mass m₂ = 2.5 kg. If m₁ is excited by a 1 Nm unbalance rotating at 1800 rpm, determine the proper value of the absorber spring k₂. What will be the amplitude of m₂. kaz m2 Figure 7 mij −12 ܓܔܓܔܓܔܓܔܓܔܔܔܓܔܛܔܔܐ

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A device with a mass of 370 kg is placed on top of the suspension, whereby the springs are compressed into a pile a distance of 4 mm. What is the natural frequency of the system in Hertz to one decimal place?
A textile machine with a mass of 5000 kg must be isolated from transmitting force to thefoundation. A spring can be used as an isolator between the machine and the foundation.The forcing function can be expressed asF(t) = 100 sin(ωt) + 5 sin(2ωt)where the force is in Newtons, t is in seconds, and frequency ω = 1200 rpm. Commercialisolators (springs) are available from the machine manufacturer. These isolators are rated bytheir deflection under the weight of the machine and are available in ratings of 6 and 8 mm.(a) Determine the steady state responses of the machine for the two springs, respectively.(b) Of the two springs, which one provides better isolation from transmitting force to thefoundation?
Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m, k2=30N/m, kt=20N- m. Determine the natural frequency of the set up in hz k1 m1 a Jo b k2 m2
When a 2kg cylinder is suspended from a spring, the spring is stretched by a distance of 40 mm. What will be the natural frequency in Hz (use four decimal places) for aa 0.5 kg cylinder suspended from the same spring?
Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m, k2=30N/m, kt=20N-m. Determine the natural frequency of the set up in rad/s
Find the natural frequency (in Hertz) of the system illustrated in the following figure. Assume the disk is rolling without slipping. K1 = 4 MN/m, K2 = 2K1, M = 165 kg, and R = 0.2 m. Assume the moment of inertia is A K, R. K2 www M No Slip 220.19 Hz 35.04 Hz 25.58 Hz 17.94 Hz 71.49 Hz O 0 O O O
An electrical switch gear is supported by a crane through a steel cable of length 4 m and diameter 0.01 m. If the natural time period of the axial vibration of the switch gear is found to be o.o1 s, find the stiffness of the switch cable. * O 4 MN/m O 5 MN/m O 2 MN/m З MN/m
e 707 2k M شب M X2 2k ht derive the equations of motion. Gssume the solutions x₁ = Asinwt and X₂ = Bsin wit defermine the two critical frequencies. W₁ and W₂ (rad/s) determine the modelshape modeshape af each frequency. as a ratio of A/B
A musical note on a piano has a frequency of 40 Hz. If the tension in the 2-m string is 308 N, and one-half wavelength occupies the string, what is the mass of the wire? 0.047 kg 0.040 kg 0.024 kg 0.031 kg 0.019 kg A block-spring system has a maximum restoring force Fmax 0.1 N. If the amplitude of the motion is A = 0,01 m and the mass of the block is m = 400 g
For given mass (m=10kg) and two springs systems k1=30 N/m and k2= 20N/m. Find the following 1. Circular Frequency and natural frequency 2. If initial displacement is 50 mm and initial velocity is 0, what is max displacement and max velocity. 3
The damped harmonic oscillator system satisfies the equation mx + rx+ sx = 0. mž +rx + note: pay attention to the x The displacement experienced by mass m can be expressed by x = Ae^-rt/2m cos(w't + Ø ). At t = 0, the mass is at x = x0 velocity x (with one point) = v0. On this system it is known that wi – w² = 10-6wž. a. If damping is removed, the mass will ocillate in simple harmonic motion. Determine A and Ø in the parameters xo, vo and wo (the natural frequency of the oscillator). b. For this damped harmonic oscillator, determine A and Ø in the parameters xo, vo and w'. c. Calculate the logarithmic reduction 9/11 and quality factor Q. d. If w, = 10^6 rad/s and m = 10^-10kg, calculate the spring constant s and = coefficient r.
Find the two natural frequencies of the system and describe its two natural modes of oscillation. See Attachment for assistance m1 = m2 = 1; k1 = 0, k2 = 2, k3 = 0