436. A 230 V DC motor takes a current of 40 A and runs at 1100 r.p.m. If armature and shunt field resistances are 0.25 2 and 230 2 respectively the back emf will be:

Q: Q1: Find the electric potential at the axis of a uniformly charged disc ?

A: Electric potential: It is the amount of work done that is required to move a particular or given…

Q: O A 50- load consists of a resistor in parallel with a 75-µF capacitor. If the load is connected to…

A: Important note: In the given problem statement, it is given the the load is consisting of a resistor…

Q: A C

A:

Q: B: The frequency test data of certain elements plotted on the bode diagrams and approximated are…

A: We are aware that one pole causes a -20 dB/dec slope and one zero causes a +20 dB/dec slope.

Q: Given the following linear system: 8 d²y(t)gdy +7 y(t) = 6r(t) dť²2 dt Find Y(s)/R(s) for the above…

A: We need to find out transfer function for given equation

Q: 1: In the circuit shown below, R₂/R₁ = 3 P₂/P Compute the 2 Vs www R₁ R₂ (P1 and P2 are power…

A: We need to find out the power ratio for both resistor

Q: let h (n) = 8(n) + 8(n-1) and x(n) = 8(n) + 8(n-1) + 8(n-2) + 8(n-3) Find the output y(n) using (a)…

A:

Q: what is the answer for these question? Pls answer these. Thank you

A: From the above circuit the various components are as: Fuse, key, transformer, resistance, and diode.…

Q: Problem 4 (Stokes Theorem): 24 14 z=3 Es ds VXA-ds= E-kr²za+ Jc A-d (3.1) (3.2) Verify Stokes…

A: INTRODUCTION: The Stokes theorem states that "Integrate the Curl of the vector field on the surface…

Q: EXAMPLE 1-8 Write the shorthand equation to calculate terminal resistance. 50 ΚΩ Reg 30 ΚΩ 40 ΚΩ 2…

A:

Q: A substation has two feeders, Sub Feeder-A have demand at a time is 35 KW and Sub Feeder-B have…

A: Given data, Individual maximum demand 35 KW and 42 KW. Maximum demand = 70 KW.

Q: 1.You would use a piezoelectric transducer to detect a. microwave RF signals b. magnetic fields…

A: Transducer is a device that converts one form of energy into another form. Sensor is the basic…

Q: Referring to figure shown below, determine the following: a. Total Resistance (R₁) b. Current Ix c.…

A: The circuit diagram is shown below,

Q: Q4/ The magnitude of the line voltage at the terminals of a balanced Y-connected load is 6600 V The…

A: Given: Balanced Y-connected Load  VL=6600VLoad Impedance = (240-j70)Ω/φload is fed from a line has…

Q: : For the circuit shown below; find to? H.W3 R₁ = 1K₁₂², R₂ = 2K₁√z R₂ = 3 kr ₂ R₁=9kr Ans: Vo= 6v₁…

A:

Q: 1: In the circuit shown below, R₂/R₁=3 P₂/P Compute the Vs ww R₁ ww R₂ (P₁ and P2 are power…

A: Given, The circuit is, The ratio of resistors, R2R1=3.

Q: HW: The voltage and current waveform of an electrical element are depicted in the figure below. Find…

A:

Q: 6. An integrated circuit has in one chip a NAND gate, a flip flop, a counter, and a shift register.…

A:

Q: 5V 5 (+1) し 1052 ما b h GV (-+) 72 с 9 92 -8√ 82 17V

A:

Q: For the nowing plant. period is 2 sec. s(s+1) el the sal

A:

Q: In a series circuit, you measure 9 volts across a 300 ohm resistor. How much current is flowing…

A: Given: A series circuit with, Measured voltage, V=9 volts. Resistance, R=300 Ω.

Q: How do you convert a voltage source in series with a short-circuit to a current source? A B Multiply…

A:

Q: Example 1: If the resistance of an electric iron is 50 Q and a current of 3.2 A flows through the…

A: Given data, Resistance of electric iron, R=50 Ω. Current flowing through resistance, i=3.2 A.

Q: .. Find Inverse Z-Transform for the following function: H(z) = 1+2z 1-52-2+62-3 1-32-1+22-2 -, |z|>2

A:

Q: Find the current density J at point A(1, 2, 3) for: H = 2xyax - 3y²ay A/M

A: We need to find out the current density at given point

Q: Q4: Given the function √x,y(x, y) = {b(x + y)² -2<x<2 elsewhere and -3<y<3 (a) Find the constant b…

A:

Q: 36 V ΖΩ www Μ ΑΛΛΑ Ο 11 = -2 A, i2 = -1 A Ο i1 = 0 A, i2 = -2 A Ο i1 = 2 A, i2 = 0 A Ο i1 = 2 A, i2…

A:

Q: What is dual of A+[B + AC] + D? A A+ [B(A+C)] + D B A [B+ AC] D CA+ [B (A + C)] D D A [B(A + C)] D

A: Given Boolean function: F=A+B+AC+D.

Q: Consider a causal second-order system with the transfer function G(s) = lim c(t), rounded off your…

A:

Q: Find: a) Va Vc b.)

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The current is in the 30 mH inductor is 10cos (10 000t +30°) m A. Calculate; i. The inductive…

A: Given data: Inductance, (L)= 30 mH is=10 cos10000 t+300 mA

Q: 9120° V V |A 5Ω ΤΩ 1.65 Ω j1.02 02 V 18 4Ω -15Ω

A:

Q: Given the following linear system: gdy(t) +9+7 y(t) = 6r(t) 8ď²y(t) dy dt Find Y(s)/R(s) for the…

A:

Q: A step up chopper has input voltage of 200 V and output voltage of 600 V. If conducting time of…

A: Given a step up chopper with, Input voltage, Vin=200 V. Output voltage, Vo=600 V. Conducting time of…

Q: 9120° V V |A 5Ω ΤΩ 1.65 Ω j1.02 02 να 18 4Ω -15Ω

A:

Q: If a MOSFET is to be used in the making of logic gates application then it must work in a.…

A: We need to select correct option for given statement

Q: Wa The voltage and current waveform of an electrical element are depicted in the figure below. Find…

A:

Q: C- Find the Fourier expansion of the f(x) = sinx =π<x<π

A:

Q: op-Amp circuit that produce output given by V₂ = -(4√₁ + √₂ +0:1√₂) if v₁ = 2 sin wt ; V₂ = 5V, and…

A:

Q: 21) Answer two only A- Sketch the single-sided and double-sided spectra for phase and amplitude of…

A:

Q: Find the inverse Z-Transform of the following signal: Z-1 |z| > 1 (1-z-¹)(1-¹-z-¹)²' H(z) =

A: This is a problem of Z transform. The solution is given in the next step.

Q: Calculate the missing value: P = 1000 W, E = 1 = 20 A. O a. 0.02 V b. 50 V O c. 500 V O d. 20,000 V

A: Given  P= 1000 W E= ? I=20 A

Q: Find the unknown values. 30 V Disregard negative sign. i₁ = i₂ = 2 V1 = V2 = 892 41 Ω ww + 21- V3 =…

A: Given  The circuit diagram is shown in below,

Q: Do you understand the connection between a diode and an LED and semiconductors? Put the symbol and…

A: Yes for sure LED is nothing but a special type of a PN junction diode which is operated under…

Q: 16. What is 2/5 multiplied by 2/3? B. 4/10 A. 4/8 17. What is N in 3/6 x 1/4 = N. B. 4/12 A. 4/10 C.…

A: We need to find select correct option for given multiplication

Q: PRACTICE EXERCISE 4.9 A charge distribution in free space has Pv otherwise. Determine E at r = 2 m…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: The voltage across R₁ resistor in the circuit shown below is? V1 10 R1 60 www 29

A: Given circuit,

Q: The voltage on a 75 ohm transmission line decreases by 0.10% per meter.  What length of this…

A:

Q: Upon chgecking the spectrum analyzer, a 2 dB single tone is detected and a noise floor at - 5 dB.…

A: We need to find out the signal to noise power ratio

Q: Referring to figure shown below, determine the following: a. Total Resistance (R₁) b. Current Ix c.…

A:

Motor Load, Torque, and Power Quality Requirement

An electric motor is a gadget that changes electrical energy into mechanical energy over to follow up on a mechanical burden. The weight set on the motor because of this mechanical movement is known as motor load. Appropriately matching the motor burden to the engine is vital to forestall harm to the engine or wasteful and unnecessary expensive activity. Engines perform such undertakings as moving a thing starting with one spot then onto the next, cutting it, changing its shape, etc. The motors might be evaluated as far as a few variables including power yield, voltage, current, and temperature. Harm to an engine might happen when it is worked under over the top engine load contrasted with its appraised limit.