42. •• Predict/Calculate You pull downward with a force of 28 Non a rope that passes over a disk-shaped pulley of mass 1.2 kg and radius 0.075 m. The other end of the rope is attached to a 0.67-kg mass. (a) Is the tension in the rope the same on both sides of the pulley? If not, which side has the greater tension? (b) Find the tension in the rope on both sides of the pulley.

42. •• Predict/Calculate You pull downward with a force of 28 Non a rope that passes over a disk-shaped pulley of mass 1.2 kg and radius 0.075 m. The other end of the rope is attached to a 0.67-kg mass. (a) Is the tension in the rope the same on both sides of the pulley? If not, which side has the greater tension? (b) Find the tension in the rope on both sides of the pulley.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter9: Momentum And Its Conservation

Section: Chapter Questions

Problem 101A

See similar textbooks

Similar questions

When unable to loosen the lug nut on an automobile tire, a mechanic may put a piece of pipe on the handle of the tire wrench so as to extend its length. How does that help?
A 1450-kg sports car (including the driver) crosses the rounded top of a hill (radius = 88.0 m) at 20.0 m/s. - Determine the normal force exerted by the road on the car. - Determine the normal force exerted by the car on the 74.0-kg driver. - Determine the car speed at which the normal force on the driver equals zero.
• Part A IP Force to Hold a Baseball A person holds a 1.42-N baseball in his hand, a distance of 34.0 cm from the elbow joint, as shown in the figure(Figure 1). The biceps, attached at a distance of 2.75 cm from the elbow, exerts an upward force of 12.6 N on the forearm. Consider the forearm and hand to be a uniform rod with a mass of 1.30 kg You may want to review (Page 335). Calculate the net torque acting on the forearm and hand. Use the elbow joint as the axis of rotation. να ΑΣΦ ? 2.47 N. m Submit Previous Answers Request Answer X Incorrect; Try Again; 7 attempts remaining Part B If the net torque obtained in part A is nonzero, in which direction will the forearm and hand rotate? O counterclockwise O clockwise Figure 1 of 1 Submit Request Answer • Part C Humerus Biceps Would the torque exerted on the forearm by the biceps increase or decrease if the biceps were attached farther from the elbow joint? 12.6N Radius O decrease O increase 2.75 cm 170 cm Mg -17.0 cm Submit Request…
Because of Earth’s rotation about its axis, you weigh slightlyless at the equator than at the poles. Explain.
What happens when a person jumps heavily on his feet from an elevated position? And explain using newton's first law in relation to the disks in the spine
81. •Medical At its narrowest point the femur bone in the human leg resembles a hollow cylinder that has an outer radius of roughly 1.1 cm and an inner radius of just about 0.48 cm. Assuming that the ultimate strength of the bone is 1.7 x 10° N/m², how much force will be required to rupture it?
• Determine the Inertia (Ix) of the material shown from the X-X Axis (centroidal axis) 30 in 20 in 1.74x10^6 in^4 3.74x10^6 in^4 2.54x10^6 in^4 0.94x10^6 in^4
3. (35 pts) A system of two paint buckets connected by a lightweight rope is released from rest with the 12.0 kg bucket 2.00 m above the floor. The pulley has a mass of 2.4 kg and a radius of 3.50 m. Treat the pulley as a cylindrical hoop. A) Find the acceleration of the buckets. B.) 12.0 kg 2.00 m 4.0 kg Mathematical Representation 28 Aa MacBook Pro
• Pulling the string on a bow back with a force of 28.7 lb, an archerprepares to shoot an arrow. If the archer pulls in the center of thestring, and the angle between the two halves is 138°, what is thetension in the string?
•21 In unit-vector notation, what is the torque about the origin on a particle located at coordinates (0, -4.0 m, 3.0 m) if that torque is due to (a) force K with components F, = 2.0 N, F, = F = 0, and (b) force F with components F2, = 0, F2, = 2.0 N, F2 = 4.0 N? %3D %3D
Create a own theme parks rides, some interesting facts about it, and how it works based on the concepts of physics discussed in torque.
The ice cream cone shown below can be approximated as follows: • Scoop on top uniform solid sphere (M1 = 0.027 kg and R1 = 0.03 m) waffle cone base= cylinder (M2 = 0.038 kg and R2 0.01 m), which is uniform and solid also (it's filled with ice cream!) %3D 1. R, 1 R, M, If this entire ice cream cone were to be rotated about the axis shown, Rotational Inertia: a.) What would the the rotational inertia (I) of: Scoop on top: I1 kg-m2 cone base: I2 kg-m2 the whole ice cream cone: Itot kg-m2