34. Four 10 mH inductors are in series. The total inductance is( a) 40,000 μΗ(b) 40 mH(c) 30 H(d) none of above

Answered: 34. Four 10 mH inductors are in series.…

Engineering

Mechanical Engineering

34. Four 10 mH inductors are in series. The total inductance is (a) 40,000 µH (b) 40 mH (с) 30 Н (d) none o

Electrical Transformers and Rotating Machines

4th Edition

ISBN:9781305494817

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter3: Inductance In Alternating-current Circuits

Section: Chapter Questions

Problem 4RQ: Four inductors, each having an inductance of 0.6 H, are connected in series. What is the total...

See similar textbooks

Related questions

Q: a) Determine, by successive conversions between Thevenin and Norton equivalent networks, a Thevenin…

Q: 12 In the crank-rocker shown, If 4 cm, = 7 cm, and l4 = 10 cm, then the smallest transmission angle…

A: Transmission angle is defined as the angle between the coupler and the output link. And it will be…

Q: slider E.Link AC rotates counterclockwise at 100rpm.A and B are fixed points.The following linkages…

Q: 1.9 Classify the following system of equations: du du dv +6 = 0 at du dv +b+a- dv = 0 at

A: A system of equations is a collection of one or more equations with several variables. The variable…

Q: Identify the degree of freedom of the following system 3k 4k 4k k 4k 2k

Q: Give the two kinds of transmissibities that are governed by this expression

A: we will discuss different transmissibilities

Q: Define the electrical power in terms of resistance R, current I, and potential difference V.

Q: m diameter is fixed fre m and 2 m from the natural frequency of shaf ig 11 CNm2

A: To find : natural frequency of the shaft. given : mass at length of 0.6m is m1=150kg mass at…

Q: 9. Identify the resistance of the Following Five Band Resistor

A: From the five band Resistance the actual resistance which is 2000K Ohm +5%

Q: The Unit of Impulse is given by_. - O a. N/s O b. Ns O c. N/m O d. N

Q: 17. Calculate the equivalent capacitance and the voltage on C, on the circ C₂=5 μF C₂ = 15 μF C₁ =…

A: Given Data :

Q: For the network shown, find the current in the 300 ? resistor. 60 N 90S2 8V 20 2 3002 1502 а. 34.2…

A: The series resistance Ra=60 Ω+90 Ω=150 Ω At the lower node Rb=300 Ω+150 Ω=450 Ω With respect to the…

Q: A 3-phase, 50 Hz, 3000 V motor develops 600 H.P. (447·6 kW), the power factor being 0·75 lagging and…

Q: A 4-79 permalloy solenoid coil needs to produce a minimum inductance of 1.5 Wb/m2. If the maximum…

A: Data given - A 4-79 permalloy solenoid coil minimum inductance of 1.5 Wb/m2 = 1.5 × 104 gauss…

Q: 21. Determine the equivalent resistance, Ry, of the circuit shown. 6Ω 10 Ω 15 Ω Μ 30 Ω 12 Ω α Ω Μα…

Q: Q#01: Briefly explain the following terms. a) Mechanical Vibration. b) Frequency. c) Natural…

A: Briefly explain the following terms.a) Mechanical Vibration.b) Frequency. c) Natural Frequency.d)…

Q: 7) What is the maximum displacement of the bob from its middle position to its maximum position…

A: The motion of the bob when moving up and down about an equilibrium position is called the…

Q: The _____________ between the windings of a transformer is the same. current induced emf voltage…

A: Transformer changes current and the voltage of a circuit but power (P=VI) remains constant. This is…

Q: If the impedance Z1 = 10 +j10 and the impedance Z2 = 10 -j0 are connected in series, the equivalent…

A: given data . impedance Z1= 10 + j10 ohms Z2= 10 - j0 find equivalent impedance…

Q: +0.040 -0.010 In an interchangeable assembly, shafts of size 25.000-0 'mm mate with holes o +0.030…

A: To determine the maximum interference in the assembly.

Q: Problem 9: An air-filled capacitor consists of two parallel plates, each with an area of 7.60 cm2,…

Q: In the network below, find the power associated to the current source, for V1 = 10 V. - V1 + 24 (T 2…

A: In this problem, the Kirchhoff's voltage law is used to calculate the voltage in current source then…

Q: In the network shown, Find the current I and the power supplied by the voltage source, for V = 6 V.…

A: We need to calculate the current and power in the question

Q: Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m,…

Q: 3)Explain how can we use the Linear Variable Differential Transformer (LVDT) as a. A flow…

A: LVDT is basically a transducer, which converts the rectilinear motion of the object to electrical…

Q: 14 In single degree of freedom systems, a. O, 0. II

A: For a single degree of freedom system , natural frequency is given by ωn = km The increase in mass…

Q: The sinusoidal current waveform having the maximum value of 75 A, then the R.M.S value is

A: Given Current = 75 A

Q: Two shunt generators 1 and 2 are operating in parallel. The voltage of generator 1 falls from 240 V…

A: Given Data The voltage of generator A is: EgA=240 V The voltage of generator A fall to: Ia=220 V at…

Q: (i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A…

A: (i) Voltage, VL=440VLine current, IL=12A As in delta connection,Phase voltage,Vp=line…

Q: A Systen is faund bo 0170- M+J Aermin the natural ne System effective ne eguilibriu

A: Solution Calculate the equilibrium position x''+3kxm+JR2=0

Q: ● Wn. K. Amplitude ratio Z/Y. ● b & delta. W 2 kg Structure D 24 mm

Q: 19. If three 75 W lamps are connected in parallel across a 125 V source, the total current equals a)…

A: Given data: The power of each of the lamps is, P=75 W. Number of lamps are, n=3. The voltage across…

Q: A voltage signal having the equation v(t) = 325.269 sin(376.99t - 30). What is the average voltage?

A: Solution is given below: Option C is correct.

Q: A 4 pole DC generator has an armature winding containing a total of 648 conductors connected in two…

A: After solving the problem 1, the answer I got is 1250rpm, which is not in the options. I checked my…

Q: The two popular operating voltages for residences are_________ V and _________ V.

A: Residential electric service enters the building in two forms, 120 volts and 240 volts. These are…

Q: Find the power that can be transmitted.

A: Given data; b=150mm=0.15mMax.tension /cm width=140 NT1T2=2.25d=1.05 mN=220 rpm we have to find the…

Q: Determine the capacitance of 10 m length of the cylindrical capacitors shown in 3 mm, c Figure 6.19.…

Q: The maximum power is delivered to a circuit vwhen source resistance is load resistance. O a. Less…

A: The maximum power delivered to a circuit when source resistance is.............

Q: Linear attenuation coefficients: Vzd The sides of the squares have the same length: d Inz

A: Ix=Ioe-μxwhere-Ix=Intesity at distance 'x'Io=Idial intensityμ=Linear attenation…

Q: H.W.6: For the Y-Y circuit in H.W.2, calculate the complex power at the source and at the load.…

A: The answer is (1012+j801.6)VA

Concept explainers

Automation in manufacturing processes

The term automation refers to the technique through which the creation of an apparatus takes place using an automatic process or a system. Let us try to understand this with an example.

Question

34. Four 10 mH inductors are in series. The total inductance is
( a) 40,000 μΗ
(b) 40 mH
(c) 30 H
(d) none of above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. (i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A determine the capacitance of each of the capacitors. If the 0 60° then calculate the power dissipation in kW when it is connected in STAR ENGG_AC_Quiz-Format_01/2016-17_V02 (ii) Three coils each having resistance 6Q and inductance are connected in star with 415V. If the line current is 30 A, find the value of inductive reactance as well as inductance value. If 0 45° then calculate the power dissipation in kW when it is connected in Delta.
In the network below, find the power associated to the current source, for V1 = 10 V. Vi + 2 A (T 14 V Select one: а. -14 b. -4 С. -8 d. -20 е. -18 2.
In a transistor, IC = 100 mA and IE = 100.5 mA. The value of B is * 100 50 about 1 200
12) Using the information provided, find the unknown quantities. a) Find the Resistor – (R3)? b) Find the Voltages – (E), (V2), (V4)? - c) Find the Current – (I)? | d) Calculate Total Power – (PT)? + 2V + V2 + 12 V - - R2 R3 1 kl 2 k + + R4 3 kΩ V,
The total capacitance of a 2.2 µF capacitor connected in series with a 0.047 µF capacitor is Four 1000pF capacitors are in series. What is the total capacitance ? Three 10mH inductors are in series. The total inductance is The total inductance of a 270 mH inductor connected in parallel with a 1.2 mH inductor is
Figure 1 of 1 F = 30 N 4. E=50 N 20° F = 20 N
There is a total of 500 mA of current into five parallel resistors. The currents through four of the resistors are 50 mA, 150 mA, 25 mA, and 100 mA. What is the current through the fifth resistor?
In the network shown, Find the current I and the power supplied by the voltage source, for V = 6 V. + v(* ` 20 k2 Select one: a. I = 0.45 mA, P = - 4.05 mW b. I = 0.2 mA, P = - 0.8 mW c. I = 0.3 mA, P = - 1.8 mW %3D d. I = 0.4 mA, P = - 3.2 mW e. I = 0.6 mA, P = - 7.2 mW
What is the value of a sinusoidal voltage at 7 us (micro second) from the positive going zero crossing when Vp = 15V and f = 50KHZ ?
Figure < 3 of 4 WB A C B
The mechanism used in a marine engine consists of a single crank AB and two connecting rods BC and BD as shown in (Figure 1). Assume r = 0.2 m Part A Determine the magnitude of the velocity of the piston at D the instant the crank is in the position shown and has an angular velocity of w 4 rad/s. Express your answer with the appropriate units. НА VD = Value Units Submit Request Answer Part B Determine the direction of the velocity of the piston at D the instant the crank is in the position shown and has an angular velocity of w = 4 rad/s. Oup and to the left Figure <1 of 1 O down and to the right Submit Request Answer
Three inductors are connected in parallel. Inductor 1 has an inductance of 0.06 H; inductor 2 has an inductance of 0.05 H; and inductor 3 has an inductance of 0.1 H. What is the total inductance of this circuit?