32. The figure below shows a working surface illuminated by two light sources. What is the total illumination at point (A) (b) 19.5 a) 17,9 Solution: 600-cd 5m 6m 2m. (A) 200-cd 3m (c) Others (..)

Q: Fourier Transforms: Why is the Fourier Transform of U[n] = z/(z-1) but for 1 it is delta(n)? Can you…

A: Let x(t) be a continuous time function and x[k] is its Discrete sequence then x[k] can be found from…

Q: Two carpenters are hammering at the same time, each at a different hammering frequency. The…

A: The absolute disparities between the two frequencies add up to the beat frequency. A beat is…

Q: a+z 3. Use transformation @ Inª to find the potential inside of a long cylinder shown in a-z the…

A: Given: In this question, the given details are, Use transformation, ω=lna+za-z . To find the…

Q: A current of 26.3 mA is flowing through a circuit including three resistors in series, which have…

A: The given problem is from circuits.  The detailed solution is given in the next step

Q: Problem I f(t) to F(s) Use tables 12.1 and 12.2 from the textbook to find: d L {o cos wt} 2dt Use…

A: Please refer the attached images for the complete answer

Q: 3. For the network of Fig. 8.66: (a) Calculate IB. Io and re Determine Z, and Z. (c) Calculate A,…

A: Given circuit,

Q: A redundant part or component increases reliability because it is connected in parallel, not in…

A: Q 40. System reliability: Components and otherwise elements are organised parallely in parallel…

Q: 4. If the sequence of Wye connected load is CBA and the reference is VCA then the phase voltage must…

A:

Q: Describe the basic electronic circuit components in an audio-based communication system.

A: To describe: Basic electronic circuit components in an audio-based communication system.

Q: What is the simple operational amplifier circuit for a constant current source? How does one set the…

A: An Ideal operational amplifier has a very high Common mode rejection ratio, Very high input…

Q: Question A differential protection scheme is shown below 400/1 80 A fooo I, 00000 F I₂ The…

A: Given- A differential protection scheme as shown. To Find- The percentage bias.

Q: For the half subtractor: a) draw its circuit diagram. b) write its truth table. c) write the Boolean…

A: In the given questions we need to explain about the half subtractor.

Q: What is the sensitivity, resolution, precision and reproductibility of RTD connected to a Wheatstone…

A: Resistance Temperature Detector(RTD) A Resistance Temperature Detector, sometimes referred to as a…

Q: The MOSFET in the circuit to the right has W V₁=1V, -=1mA/V²,V L Determine the following: a) I₁ b)…

A:

Q: 13) Explain the nomenclature of additive white Gaussian noise (AWGN). What the PSD and…

A: Additive: It is a noise signals that gets added to the original signal in the channel. y(t)=  x(t)+…

Q: Question Overall transfer function of a system is given as G(s) = (28+1) (s²+28+5) .The system is…

A: Given- The overall transfer function of a system, Gs=2s+1s2+2s+5   To find- System characteristics.

Q: Assume the OPAMP is ideal. For the circuit shown below: R=0.3k, C=0.201nF, L=5.6mH and the voltage…

A: The Amplifier circuit is given as Here opamps are configured as a voltage buffer. So, the output…

Q: Determine the angle by which v1 lags i1 if v1 = 34 cos (10t + 125°) and it is equal to (a) 5 cos…

A: In the given questions we need to find the phase difference between current and voltage.

Q: (a) Periodic and non-periodic signals

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: Why answer has been changed, before it was with Equation Operators. now I see it like this in…

A: It is given that: re=10.71 Ω

Q: QUESTION 2 (40 MARKS) The voltage v(t) and current i(t) expressions in an AC circuit are given in…

A:

Q: Calculate v, in the circuit 10 cos (10t+ 75°) (+) 0.5 H 10 Q2 -18 F 10+

A:

Q: 3. Determine the Thevenin's and Norton's equivalent circuits at terminals a-b. 12V 1252 W 503 9.52 W…

A: Given data A circuit containing several resistors and three independent voltage sources is given in…

Q: Q1) Consider the use of 1500 bit frames on a 2 Mbps satellite channel with a 180 ms delay. What is…

A: Given data A satellite is following continuous flow control. Propagation delay, tprop=180 ms Data…

Q: Problem 2 Given: F(s) to f(t) F(s) = 565² +1125 + 5000 s(5² +145 +625) Determine: a) Use Partial…

A: It is asked to find inverse Laplace transform of given function using partial fraction

Q: What is the impedance of a circuit containing a 32002 resistor, 0.1H inductor, and 6.2 µF capacitor…

A: Given: Resistor, R=3200Ω, Inductor, L=0.1 H, Capacitor, C=6.2 μF. Frequency, f=60 Hz.

Q: Exercise 6 Evaluate the density of charge carriers in intrinsic silicon at 300 K. We give Eg =…

A: According to the question,

Q: FIND 5V го In TERMS OF Vs. 마 24 кл ти 16кл -M 24кг M + 1s Vp 96 кл ти + loks - Vo

A: We need to find out the output voltage for given circuit.

Q: Example 4. The switch in Figure 16 is closed at t=0. Find i(t) and v(t) for all time. Note that…

A:

Q: Question 4 Consider an LTI system with frequency response: 1+e-j2 te -j4w H(ej") = -π<ωΣπ 1+2e-j40…

A:

Q: Given point B(p = 4, p = -50°, z = 2) Find the cartesian value of x A. 2.57 B. - 3.06 C. 4.472 D.…

A:

Q: For the electric network shown below: 8 Ohm 60 V LLLL 5 Ohm www ww 1 Ohm 4 Ohm Ohm ww 4 Ohm lalalal…

A: To find the current through each loop by crammer rule

Q: a) Convert the flowing number (226)10 to binary, octal, and hexadecimal. b) Use a truth table to…

A:

Q: The sinewave has a peak voltage of 7 A and a Half cycle value of 9.3333 ms. What is the period?…

A: Given: Sine wave has half cycle time period =  9.3333 ms, peak voltage = 7 V, To find: Period of the…

Q: 3) The choosing of a PCM waveform for a particular applications is limited by some parameters. What…

A: To explain: Parameters that effect the selection of a PCM waveform for a particular application.…

Q: 1052 aww 2052 www R www Figure 5 18. Determine the value of R in figure 5 if the equivalent…

A: The given problem is from circuits.  The detailed solution is given in the next steps

Q: What is a criteria to find low pass filters, bandpass filter and highpass filter from a pole zero…

A: In this questions, we need to classify different type of filter based on there pole zero location.

Q: Draw a circuit schematic for this function only with NOR gates. X_Sim= AB'+BC

A:

Q: www SA www VE (20V + T 82 ww ve 260 ww 10n 2UX

A:

Q: In the network in the below figure, find I using superposition. 6 ΚΩ 6 ΚΩ 12V 6 ΚΩ 6 mA 6ΚΩ

A: In this question we need to find the current Io by using superposition theorem.

Q: Hy R(s) MOD专四作 G1 G2 C(s)

A:

Q: 20 cos(2 t) Volts a. (4- j5)Vx -j2Vx 252 b. (4-j5)Vx Vx 0.2 F - 4Vy = -j100 Which from the following…

A:

Q: star connected circuit

A:

Q: 3. Determine Vo using mesh analysis. 20V 45 V 1502 M Il 82 + F% + 14 1022 12 3222 M 13 2012 +48V

A:

Q: Consider the circuit shown below: a) Find the phasors V₁ and 11. b) Find the power delivered to the…

A:

Q: 892 www -j492 1₁ elle 10/0° A 692 j2 s 50/30° V Using mesh analysis and the indicated mesh currents…

A: given circuit problem.we have to find Io.

Q: Q7. Deduce the self-inductance of the toroid shown in Fig. 1. If N is number of turns, and the…

A: It is asked to deduce the expression of self-inductance of the toroid shown in the given figure. The…

Q: Problem 02.036 - Current division among parallel resistors Find i and Vo in the given circuit.…

A:

Q: Question 2-) Determine the state variable equations for the network shown below. v₁ (±) Vi 8 Ω 0.5 F…

A:

Q: GIVEN THE NETWORK BELOW, DERIVE THE TRANSFER FUNCTION BY FILLING ALL VALUES BELOW 10 ka 1kQ + 100 kQ…

A: