3.51 Air is drawn into a wind tunnel used for testing automobiles as shown in Fig. P3.51. (a) Determine the manometer reading, h, when the velocity in the test section is 60 mph. Note that there is a 1-in. column of oil on the water in the manometer. (b) Determine the difference between the stagnation pressure on the front of the automobile and the pressure in the test section. 地 60 mph Water Wind tunnel Open Il in. Oil (SG = 0.9) Fan 117.

3.51 Air is drawn into a wind tunnel used for testing automobiles as shown in Fig. P3.51. (a) Determine the manometer reading, h, when the velocity in the test section is 60 mph. Note that there is a 1-in. column of oil on the water in the manometer. (b) Determine the difference between the stagnation pressure on the front of the automobile and the pressure in the test section. 地 60 mph Water Wind tunnel Open Il in. Oil (SG = 0.9) Fan 117.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A submarine moves horizontally in the sea and has its axis much below the surface of seawater. A pitot tube properly placed just in front of the submarine is connected to a differential pressure gauge. The pressure differential between the stagnation pressure and the static pressure was found to be 20KN/m2. Find the speed (m/s) of the submarine if the specific gravity of seawater is 1.026. О а. 3.54 O b. 5.87 О с. 6.24 O d. 4.55
Early mountaineers boiled water to estimate their altitude.If they reach the top and fi nd that water boils at 84 ° C,approximately how high is the mountain?
3. A container filled with water accelerates at 20 ft/s² up a plane inclined by a = 30°. The pressure at the top of the tank, point 1, is measure at 10 psi. The length of the tank is 10 ft, and its height is 5 ft. Determine the maximum pressure in the tank. Pt. 1 ax
A projectile travel in air of pressure 10.1043 N/cm2 at 10 °C at a speed of 1,500 kilometers per hour. Find the Mach angle in degrees.
Consider a geyser that shoots water to a height of 28 m into the air.Density of water, rho = 1000 kg m-3, acceleration due to gravity, g = 9.81 ms-1, atmospheric pressure, Patm = 101250 Pa. How fast is the water traveling when it emerges from the ground, If the water originates in a chamber 44 m below the ground, what isthe pressure there (consider there is NO friction within the chamberand that the water can be considered to be stationary)?
3. A 0.8-lbm object travelling at 200 ft/sec enters a viscous liquid and is essentially brought to rest before it strikes the bottom. What is the increase in internal energy, taking the object and the liquid as the system? Neglect the potential energy change. Derive with the formula below, show the cancellation, explain the step by step and draw a free body diagram/figure. refer with this: PE1 + KE1 + U1 + WF1 + Q1 + W1 = PE2 + KE2 + U2 + WF2 + Q2 + W2 + E losses.
A vertical gap 2.2 cm wide of infinite extent contains a fluid of viscosity 2.0 N s/m? nd specific gravity 0.9. A metallic plate 1.2 m x 1.2 m x 0.2 cm is to be lifted up with a constant velocity of 0.15 m/sec, through the gap. If the plate is in the middle of the gap, find the force required. The weight of the plate is 40 N. F 1.0 1.0 cm cm 0.2 cm
2.106 The pressure, temperature, and velocity of a high speed gas flow are 100kPa, 100 °C, and 930 ms~!, respectively. Determine the pressure and temperature that would result if the gas is brought to rest isentropically. Take the gas to be air. [Answer: 1.462 MPa, 803 K]
Balloons are used for touristic travel in certain regions.For this travel, aforce is required to push the balloon upward.The force is expressed as below; ?balloon=pair x g x vballoon.Assume that the balloon has a 500-cm-diameter, the density of air is 1,23x10−3g/cm3. A-definedgas is used to fill the balloons and itsweight is approximately 1:7 of the weight of air.Neglect the other weights. The balloon carries three people. The people’s weights are67, 75 and 83 kg, respectively.Determine the balloon’s acceleration when it is first released.
A pump has a total (manometric) head of 12.1 m. The radial velocity through the pump is constant at 3 m/s. The exit angle of the impeller vanes is 70 deg and the water enters radially. If whirl velocity at exit is 13 m/s, ignoring friction and other losses calculate
H.W.2/: The bottom quarter of a vertical cylindrical tank of total height 0.4 m and diameter 0.3 m is filled with a liquid (SG > 1, like glycerin) and the rest with water, as shown in the figure below. The tank is now rotated about its vertical axis at a constant angular speed of v. Determine (a) the value of the angular speed when the point P on the axis at the liquid-liquid interface touches the bottom of the tank and (b) the amount of water that would be spilled out at this angular speed? 3h h = 0.1 m D = 0.3 m
3.20 Air flows over the airfoil shown in Fig. P3.20. Sensors give the pressures shown at points A, B, C, and D. Find the air velocities just above points A, B, C, and D. The air density is 0.0020 slug/ft. V = 100 mph Po= 13.20 psia B P=13.35 psia PB= 12.5 psia Pc = 12.8 psia PD= 13.0 psia Figure P3.20 D