3. Suppose that some researchers found a 100g of solid Nitrogen originally at 63K. If this Nitrogen was then put into contact with a solid sphere of iron originally at 20°C with mass 100g and radius 1.28 cm, what is the final temperature of the isolated Nitrogen/Lead system and how much does the volume of the sphere shrink?

3. Suppose that some researchers found a 100g of solid Nitrogen originally at 63K. If this Nitrogen was then put into contact with a solid sphere of iron originally at 20°C with mass 100g and radius 1.28 cm, what is the final temperature of the isolated Nitrogen/Lead system and how much does the volume of the sphere shrink?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter2: The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 53P: Dry air consists of approximately 78% nitrogen, 21% oxygen, and 1% argon by mole, with trace amounts...

See similar textbooks

Similar questions

Dry air consists of approximately 78% nitrogen, 21% oxygen, and 1% argon by mole, with trace amounts of other gases. A tank of compressed dry air has a volume of 1.76 cubic feet at a gauge pressure of 2200 pounds per square inch and a temperature of 293 K. How much oxygen does it contain in moles?
gas Lab 11 Instructions: Specific Heat Due: See Course Schedule eesm et elsluols mo nuoy b.e The density of iron is PFe €7.87g/cm3. Calculate the mass of the drilo diansb erT iron cube using the definition of density: p= m/V. Show your calculation. 10cm^3 10X10 x10 X 7.87 1.39/cm 3 7,810 gms Answer: こ take mass : by volum e mass - volum ecc (cm³) こ1 mome erlt sisidile erlt ec. woThe density of brick is pbr = 1.92g/cm³. Calculate the mass of the sriw wole brick cube using the definition of density: p = m/V. Show your pnnuas calculation. omme er euld en T0Answer: xac Massco = 1.42 x 10 cm Icm 3 1.9 Zg eignsit er = 19.2 19.2g こ d. The water and the oil are both in beakers which have a 3-liter capacity. Each of the major tick marks on the beaker is 1 liter, elsidile and each minor tick mark i6 0.2 liters. Examine the beakers and ut6ied determine the volume (in ml) of each liquid. (There are 1000 ml 1000mL= IL in one liter, and that 1 ml = 1 cm³.). hdml lcm3 ierine Answer:uteTegnmet eid) ho…
The susceptibility of magnesium at 400°K do lomperaliāe the gusceptibilily coil be. 1.8x105. sH what 19x10 H what dloubled.
A) What is an equation to equate KE and GPE? B) A gas is held in a container of 15 m^3 in volume and a pressure of 5 Pa. If the volume isincreased to 26 m^3 what is the pressure of the gas? c)A syringe has a volume of 5 cm^3 and a temperature of 300 k. Upon heating the syringeexpands to a volume is now 5.5cm^3, what is the temperature of the syringe?
Hegr for at 1 he perature. t 9 Qu tg) 2 BLIT Clo Exercise 1 Bil Calculate the final temperature of Luquid water one mole £f ice at -15°C is mixed. adiabatically with four moles of water at 25°C. We give : The enthalpy of ice melting! Cp (H₂o, ine) = 37.62 Jmol + K-² Cp (120, loquid) = 75.24 Jmot " K " 2 - Please answer the question step question step-wuse explanations. Thanks in advanced !!! 314 Alt fusion, 273K (H₂0, soud) = 6,056 KI mol-1 Molar beat capacities: showing detailed 305
Please help. Refer to the picture attached. The following pressure, temperature and specific humidity measurementswere made from radiosonde soundings on day 11 of the Wangara PBLexperiment: (a) Calculate and plot virtual temperature as a function of height. Answer in the format of Given, Required, & Solution. (b) Calculate and plot virtual potential temperature as a function of height. Answer in the format of Given, Required, & Solution. (c) Characterize the various layers on the basis of local and nonlocal stability and discuss the differences between the two.(d) Estimate the height of the inversion base (zi), as well as the PBL height (h). Discuss the sensitivity of the latter to the near-surface temperature. Answer in the format of Given, Required, & Solution.
Problem 1: An iron-constantan thermocouple is used to measure the temperature in an oven. The cold junction is at ambient temperature of 82oF (about 28oC), and the thermocouple voltage is 12 mV. Use the given information and the table below to: Determine the voltage at the cold junction. Determine the voltage at the hot junction. Determine the approximate temperature of the oven in oC and o
to vyrons lamstal sat to (asluojolid nt) ognalo odi ei jed hour. Her 26. A monatomic gas at a temperature of 600 °K and pressure 300 kPa is inside a container whose volume is 0.100 m³. How many atoms of gas are there? Express your answer as a 00.21 multiple of 1.0 x 1024. degree 20.10 szodato soon (a) 3.62 (b) 3.45 (c) 5.43 (d) 6.46, (e) none of these
Passive samplers used for monitoring gaseous compounds are characterized by being able to fix atmospheric compounds at a rate controlled by physical phenomena, such as diffusion and permeation [...]. The diffusion of the compound inside the passive sampler occurs due toa) at atmospheric pressure at the sampling site.b) transport by the wind inside the samplerc) the difference in the concentration of the compound between the collector surface and the atmosphere.d) the temperature difference between the collector surface and the atmosphere.
The saturated vapor pressure of mercury is 0.0020 mmHg at 300 K and the density of air at300 K is 1.18 g L−1. ]ag Calculate the concentration of mercury vapor in air in mol L−1. ]bg Whatis the number of parts per million ^ppmh by mass of mercury in air?
There are two important isotopes of uranium, U235 and U238 ; these isotopes are nearly identical chemically but have different atomic masses. Only U235 is very useful in nuclear reactors. Separating the isotopes is called uranium enrichment (and is often in the news as of this writing, because of concerns that some countries are enriching uranium with the goal of making nuclear weapons.) One of the techniques for enrichment, gas diffusion, is based on the different molecular speeds of uranium hexafluoride gas, UF6 . (a) The molar masses of U235 and U238F6 are 349.0 g/mol and 352.0 g/mol, respectively. What is the ratio of their typical speeds vrms ? (b) At what temperature would their typical speeds differ by 1.00 m/s? (c) Do your answers in this problem imply that this technique may be difficult?
Heliox, a mixture of helium and oxygen, is sometimes given to hospital patients who have trouble breathing, because the low mass of helium makes it easier to breathe than air. Suppose helium at 25 is mixed with oxygen at 35 to make a mixture that is 70% helium by mole. What is the final temperature? Ignore any heat flow to or from the surroundings, and assume the final volume is the sum of the initial volumes.